NEC Neax 2000 Ivs2 Oai System Manual
Here you can view all the pages of manual NEC Neax 2000 Ivs2 Oai System Manual. The NEC manuals for Communications System are available online for free. You can easily download all the documents as PDF.
Page 81
CHAPTER 5 CIRCUIT CARD INFORMATION List of Required Circuit Card NEAX2000 IVS2 OAI System Manual ND-70922 (E), Issue 1.0 Page 75 Lamp Indications Switch Settings LAMP NAMECOLOR FUNCTION RUN Green Flashes at 60 IPM while this card is operating normally. LINK Green Remains lit when link is established. XMT Green Remains lit when it is transmitting the data. RCV Green Remains lit when it is receiving the data. RVP Green Remains lit only when it is receiving the data with its own IP address. ERR –...
Page 82
NEAX2000 IVS2 OAI System ManualPage 76 ND-70922 (E), Issue 1.0
CHAPTER 5 CIRCUIT CARD INFORMATION
List of Required Circuit Card
SW1 (DIP SW)
NOTE 21 (D15) ON
2 (D14) ON
3 (D13) ON
4 (D12) OFF
5 (D11)ON
OFF
6 (D10)ON
OFF
7 (D9)ON
OFF
8 (D8)ON
OFF
SW2 (DIP SW)
NOTE 21 (D7)ON
OFF
2 (D6)ON
OFF
3 (D5)ON
OFF
4 (D4)ON
OFF
5 (D3)ON
OFF
6 (D2)ON
OFF
7 (D1)ON
OFF
8 (D0)ON
OFF
SWITCH
NAMESWITCH
NUMBERSETTING
POSITIONFUNCTIONCHECK
1
23
45
67
8ON
MAC ADDRESS SWITCH SETTING
00004CA4 X X X X
(HEX)
FixedSW1-1...
Page 83
CHAPTER 5 CIRCUIT CARD INFORMATION List of Required Circuit Card NEAX2000 IVS2 OAI System Manual ND-70922 (E), Issue 1.0 Page 77 NOTE 1:When the power is on, flip the MB switch to ON (UP position) before plugging/ unplugging the Circuit card. NOTE 2:Each equipment must have a unique MAC address to distinguish between systems. Therefore, when more than one PBX is installed in the same network, assign the lower 4 digits of the following MAC address by SW1 and SW2 to prevent duplicate addresses....
Page 84
NEAX2000 IVS2 OAI System Manual ND-70922 (E), Issue 1.0 Page 79 APPENDIX DEFINITION OF V.24 SIGNAL LEADS This appendix contains the definition of V.24 signal leads.
Page 85
NEAX2000 IVS2 OAI System ManualPage 80 ND-70922 (E), Issue 1.0 APPENDIX DEFINITION OF V.24 SIGNAL LEADS PIN No.SIGNAL-NAME DIRECTION OF SIGNALMEANING RS-232CJIS C 6361CCITT V.24ANOTHER 1 AA (FG) 101 GND Frame Ground 2BASD103 TXD DTE Send Data 3BBRD104 RXD DCEReceive Data 4CARS105 RTS DTE Request to Send 5CBCS106 CTS DCEClear to Send 6CCDR107 DSR DCEData Set Ready 7 AB SG 102 GND Signal Ground 8 CF CD 109 DCD DCEData Channel Receive Carrier Detect 9 Not used 10 Not used 11 PB Peripheral Busy 12 SCF...