NEC Neax 2000 Ivs2 Installation Procedure Manual

CHAPTER 1 GENERAL INFORMATION
Control Card
NEAX2000 IVS2 Installation Procedure Manual
ND-70928 (E), Issue 1.0Page 15
Control Card
This table shows the names and functions of each control card.
Table 1-3  Control Card Name and Function
EQUIPMENT 
NAMEFUNCTIONAL
NAMEFUNCTION
PN-CP14 MP Main Processor Card
Provides Memory, TDSW (1024CH x 1024CH), 16-line CFT, 
PB sender, Clock, PLO 2 ports (receiver mode/source 
mode), two RS-232C ports, 2-line DAT (Recording duration: 
Max. 128sec.), DK, 4-line PB...

CHAPTER 1 GENERAL INFORMATION
Application Processor Card
NEAX2000 IVS2 Installation Procedure ManualPage 16ND-70928 (E), Issue 1.0
Application Processor Card
This table shows the names and functions of each application processor card.
Table 1-4  Application Processor Card Name and Function 
EQUIPMENT 
NAMEFUNCTIONAL
NAMEFUNCTION
PN-AP00-A
[For North 
America/
Latin America 
Only]DBM Data Base Module Card for WCS Roaming function
One card per WCS system.
PN-AP00-B AP00 Application Processor Card
Provides...

CHAPTER 1 GENERAL INFORMATION
Application Processor Card
NEAX2000 IVS2 Installation Procedure Manual
ND-70928 (E), Issue 1.0Page 17
PN-DAIA DAI Digital Trunk Interface (23B+D, 1.5 Mbps) Card for Remote
PIM
Accomodates 24-channel PCM digital lines, and provides
Firmware Processor and BUS interface.
One through three cards, corresponding to the number of
remote site, must be provided at main site.
PN-DAIB DAI Digital Trunk Interface (23B+D, 1.5 Mbps) Card for Remote
PIM
Accomodates 24-channel PCM digital...

CHAPTER 1 GENERAL INFORMATION
Application Processor Card
NEAX2000 IVS2 Installation Procedure ManualPage 18ND-70928 (E), Issue 1.0
PN-IPTA IPT IP Trunk Card
Accommodates the IP network and transmit/receive com-
pressed voice or signals over IP network.
Used with max. four PN-4VCTH cards (16 channels).
10 BASE-T/100 BASE-TX twisted pair cable is connected
directly to this card.
PN-24PRTA PRT ISDN Primary Rate (23B+D) Interface Card
Provides a built-in D-channel Handler (DCH).
PN-4RSTB MFR 4-line MF...

CHAPTER 1 GENERAL INFORMATION
Application Processor Card
NEAX2000 IVS2 Installation Procedure Manual
ND-70928 (E), Issue 1.0Page 19
PZ-M537 EXPMEM Memory Expansion Card for MP/AP00 Card
The system capacity is expanded as follows:
When mounted on PN-CP14 (MP) card:
 
When mounted on PN-AP00-B (AP00) card:
 
PZ-M542
[For Other 
Countries]CONN Coaxial Cable Connection Card
Used to connect a coaxial cable for Digital Trunk Interface.
Max. two cards can be connected to LTC connector of each
PIM.
PZ-M557
[For...

CHAPTER 1 GENERAL INFORMATION
Line/Trunk Card
NEAX2000 IVS2 Installation Procedure ManualPage 20ND-70928 (E), Issue 1.0
Line/Trunk Card
This table shows the names and functions of each line/trunk card.
Table 1-5  Line/Trunk Card Name and Function 
EQUIPMENT 
NAMEFUNCTIONAL
NAMEFUNCTION
PN-2AMPA AMP 2-line Amplifier Trunk Card
Provides Echo Canceller (EC), Automatic Gain Controller
(AGC) and Tone Disabler (TD) functions.
PN-AUCA AUC 2-line Analog Long Line Circuit Card provided with Power
Failure Transfer...

CHAPTER 1 GENERAL INFORMATION
Line/Trunk Card
NEAX2000 IVS2 Installation Procedure Manual
ND-70928 (E), Issue 1.0Page 21
PN-4COTE
[For 
Australia]COT 4-line Central Office Trunk Card (Loop Start Trunk)
Provides a detector for line fault conditions.
PN-4COTG COT 4-line Central Office Trunk Card (Loop Start trunk)
Provides loop detection, receiving/sending the Caller ID
(CLASS SM) signal.
PN-6COTJ
[For 
Australia]COT 6-line Central Office Trunk Card (Loop Start Trunk)
Provides a detector for line fault...

CHAPTER 1 GENERAL INFORMATION
Line/Trunk Card
NEAX2000 IVS2 Installation Procedure ManualPage 22ND-70928 (E), Issue 1.0
PN-2DITA
[For Hong 
Kong]DIT 2-line Direct Inward Dialing Trunk Card
Provides loop detection, sending reverse signal and PB to
DP signal conversion.
Equipped with –48V DC-DC on-board power supply.
PN-4DITB DIT 4-line Direct Inward Dialing Trunk Card
Provides loop detection, sending reverse signal and PB to
DP signal conversion.
Equipped with –48V DC-DC on-board power supply.
PN-DK00 DK...

CHAPTER 1 GENERAL INFORMATION
Line/Trunk Card
NEAX2000 IVS2 Installation Procedure Manual
ND-70928 (E), Issue 1.0Page 23
PN-8DLCP DLC 8-line Digital Line Circuit Card for Dterm75/65 (Series E/III),
DSS Console, ATTCON, DESKCON
[–27V version, 2-wire type]
PN-2DPCB DPC 2-line Data Port Controller Card
Used for intra-office or inter-office digital data transmission
on nailed down connection.
Accommodates max. two DTEs with V.11 (X.21) interface or
V.24/V.28 (RS-232C) interface.
PN-2ILCA ILC 2-line ISDN Line...

CHAPTER 1 GENERAL INFORMATION
Line/Trunk Card
NEAX2000 IVS2 Installation Procedure ManualPage 24ND-70928 (E), Issue 1.0
PN-4LCL
[For China]LC 4-line Analog Line Circuit Card for Single Line Telephones
Loop resistance : Max. 600 ohms (including telephone set)
Provides Message Waiting Lamp control function for each
circuit, and reverse function for only No. 3 circuit.
Equipped with +80V DC-DC on-board power supply.
PN-4LCV
[For Brazil]LC 4-Line Analog Line Circuit Card for Single Line Telephones
Loop...