Home > NEC > Communications System > NEC Neax 1000 Ivs Very Small Platform System Manual

NEC Neax 1000 Ivs Very Small Platform System Manual

Here you can view all the pages of manual NEC Neax 1000 Ivs Very Small Platform System Manual. The NEC manuals for Communications System are available online for free. You can easily download all the documents as PDF.

Page 21

 NDA-24219 CHAPTER 2
Page 7
Revision 2.0
Figure 2-4   19-Inch Rack-Mounting Installation
PIM
19”BRACKET (H) 

Page 22

CHAPTER 2 NDA-24219  
Page 8
Revision 2.0
Figure 2-5   Desktop Installation
PIM 

Page 23

 NDA-24219 CHAPTER 2
Page 9
Revision 2.0
3. FUNCTIONAL OUTLINE OF EQUIPMENT
This section explains the functional outline of the equipment (modules, installation hardware, circuit cards) used in
the PBX.
3.1 Functional Outline of Modules
Table 2-2 shows the functional outline of the modules.
3.2 Functional Outline of Installation Hardware
Table 2-3 shows the functional outline of installation hardware.
Table 2-2  Functional Outline of Modules
MODULESFUNCTIONAL
NAMEFUNCTIONAL OUTLINE
SN1420 PIMAB-A PIM...

Page 24

CHAPTER 2 NDA-24219  
Page 10
Revision 2.0
3.3 Functional Outline of Circuit Cards
3.3.1 Control Circuit Card
Table 2-4 shows the functional outline of each control circuit cards.
Table 2-4  Functional Outline of Control Circuit Cards
CARD NAMEFUNCTIONAL
NAMEFUNCTIONAL OUTLINE
PN-CP03 MP Main Processor Card
This card is equipped with Memory, TDSW (1024CH 
´ 1024CH), 16-Line 
CFT, DTMF Sender, Clock, PLO (receiver mode 2 ports), RS-232C Ports (2 
ports) for MAT/Built-in SMDR, modem for remote maintenance,...

Page 25

 NDA-24219 CHAPTER 2
Page 11
Revision 2.0
3.3.2 Application Circuit Cards
Table 2-5 shows the functional outline of each application circuit card.
Table 2-5  Functional Outline of Application Circuit Cards  
CARD NAMEFUNCTIONAL 
NAMEFUNCTIONAL OUTLINE
SPN-AP00-A AP00 Application Processor Card
This card is equipped with four RS-232C ports, and is used for SMDR, H/M Printer, 
PMS functions and MCI. This card is used on the basis of one per system.
SPN-AP01 AP01 Application Processor Card
This card is...

Page 26

CHAPTER 2 NDA-24219  
Page 12
Revision 2.0
3.3.3 Line/Trunk Circuit Cards
Table 2-6 shows the functional outline of each line/trunk circuit card.
SPN-DAIA DAIA Firmware Processor Bus Card—With T1
Used in main system when connecting to Remote PIM SPN-DAIB.
SPN-4RSTB-
911MF-911 Provides MF signaling for Enhanced 911.
SPN-SC03 CSH Channel Handler for Zone Transceivers
SPN-SC03 ICH ISDN-BRI Channel Handler
Provides D-channel signaling interface for four ILCA cards.
Table 2-6  Functional Outline of Line/Trunk...

Page 27

 NDA-24219 CHAPTER 2
Page 13
Revision 2.0
PN-4DITB DIT 4-line Direct In-Dialing Trunk Card
This card is equipped with the function for loop detection, sending reverse signal and 
PB to DP signal conversion. This card is internally equipped with –48 V DC On-Board 
Power supply.
PN-DK00 DK Circuit card for External Relay Control/External Key Scan
This card is provided with eight circuits, and can provide the above-mentioned control 
functions on a per circuit basis.
PN-4DLCA/
PN-4DLCMDLC 4-line Digital...

Page 28

CHAPTER 2 NDA-24219  
Page 14
Revision 2.0
PN-8LCS LC 8-line Analog Line Circuit Card for single-line telephones
Loop resistance: Max. 600 W
This card is equipped with a controller for momentary open function.
PN-M03 M03 V.35 DTE Interface Card
This card is used together with the PN-2DPCB card to provide the V.35 interface.
PN-2ODTA ODT 2-line OD Trunk Card
This card can be used as either a 2-wire E&M trunk or a 4-wire E&M trunk, and is 
internally equipped with a –48 V DC On-Board Power Supply.
Both No....

Page 29

 NDA-24219 CHAPTER 2
Page 15
Revision 2.0
DTP-16-1 PN-8DLCJ / 8DLCP
(STANDARD)656ft. (200m)Note 1
PN-4DLCD / 4DLCQ
(STANDARD)656ft. (200m)
[3937ft. (1200m)]
PN-2DLCB / 2DLCN
(LONG)2788ft. (850m)
[3937ft. (1200m)]
DTP-16D-1 PN-8DLCJ / 8DLCP
(STANDARD)656ft. (200m)Note 1
PN-4DLCD / 4DLCQ
(STANDARD)656ft. (200m)
[3937ft. (1200m)]
PN-2DLCB / 2DLCN
(LONG)2788ft. (850m)
[3937ft. (1200m)]
DTP-32-1 PN-8DLCJ / 8DLCP
(STANDARD)656ft. (200m)Note 1
PN-4DLCD / 4DLCQ
(STANDARD)656ft. (200m)
[3937ft. (1200m)]
PN-2DLCB...

Page 30

CHAPTER 2 NDA-24219  
Page 16
Revision 2.0
* The value in the [ ] shows the cable length when using the long line function.
Note 1:When using PN-8DLCJ or PN-8DLCP card, it is not available long line function.
Note 2:The DSS/BLF Console requires local AC/DC power supply.
Note 3:With AC/DC power at DESKCON 3000’ with 4DLCD ETJ-16DD-1 PN-8DLCJ / 8DLCP
(STANDARD)656ft. (200m)
Note 1
PN-4DLCD / 4DLCQ
(STANDARD)656ft. (200m)
[3937ft. (1200m)]
PN-2DLCB
(LONG)2788ft. (850m)
[3937ft. (1200m)]
ETJ-24DS-1 PN-8DLCJ...
Start reading NEC Neax 1000 Ivs Very Small Platform System Manual

Related Manuals for NEC Neax 1000 Ivs Very Small Platform System Manual

All NEC manuals