Mitel Voice Processing Solutions Instructions Manual

MESA-Net TCP/IP 
e 
Node II? Address 
e 
Subnet Mask 
a 
Physical Network Number 
e 
Broadcast Address 
e 
Gateway II’ Address 
When you configure MESA-Net TCI?/IP, as described in the Procedures section of 
this chapter, you define the following parameters: 
The module number that contains the ethernet card to use for 
MESA-Net TCI?/II?, and the number of the ethernet card in that 
module. You can only configure MESA-Net TCI?/II? on one module of 
a multi-module Centigram server. 
The System Node Name,...

list 
Page 1 of 1 
VoiceMemo Release 6.OA and later 
Tak Procedure 
Configure h4ESA-Net TCJ?/II’ . . . . . . . . . . . ..*..............*..................*............ CI? 5718 
Install Optional Feature Software . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . CI? 5402  

Page 1 of 2 
Configure MESA-Net TCP/IP VoiceMemo Release 6.06.OA and later 
This procedure describes how to configure the low-level MESA-Net TCI?/II? parameters. 
step Refireme 
1. Install the MESA-Net TCI?/II’ optional feature. 
2. Reach the MESA-Net TCP/Il? Menu. 
3. Select the module on which to configure MESA-Net TCP/II?. The module must 
contain an ethernet card, and you cannot use the same module for MESA-Net 
Async. 
SeLect: (H) Host Number to configure 
Prompt 
Host Number to configure = [I:...

Cl? 5718 
Page 2 of 2 
Release 6.OA and later 
Step 
9, Set the local node number, which is used to address and route MESA-Net messages. 
SeLect: (T) System Local Node Number (l-8 
191) = 
J+-OWZ~L System Local Node Nurrher (l-8191) = 
Response: The number, from 1 to 8 191, of the local node. 
10. Verify your work by looking at the system-wide TCP/II’ configuration. 
Select: (U) Show System Wide TCI’/IP configuration 
11. Exit to the VoiceMemo Configuration Main Menu to save your changes. Refireme  

Cl? 
ptiond Feature With System Online 
VoiceMemo Release 6.OA and later 
The procedure describes how to install an optional feature with the system online. Be 
sure the Optional Feature Diskette(s) and the Module Enable Diskette contain the serial 
number(s) for all disk(s) in the system. 
ate: The serial number on the OneView Optional Feature diskette must match the 
serial number of the hard disk on which OneView is being installed. If you 
receive an error message about an incorrect serial number,...

Cl? 5402 
Page 2 of 2 
VoiceMemo Release 6.OA and later 
Step 
6. The following prompt appears: 
J$-O~JIP Wait for paging queues to be empty? 
Response: N to continue. 
7. Exit to the VoiceMemo Configuration - Main Menu, then go to the VoiceMemo 
Configuration - Offline Menu. 
8. Duplicate the active configuration. 
SeLect: (B) Duplicate Active Configuration 
9. Exit to the VoiceMemo Configuration - Main Menu and activate the configuration. 
SeLect: (A) Activate Configuration 
Dot. Fb. A 
Refirence 
Menu...

MESA-Net Async connects Centigram servers together by means of direct 
connection, modems, and multiplexers (or any combination of these). MESA-Net 
Async is flexible to support the varied requirements of different sites and networks. 
0 
For nodes with iow network traffic volume, a simple MESA-Net Async 
installation enables two links. The node can connect to all other MESA- 
Net Async nodes on the network (up to the network maximum of 
1500 
nodes), but only two at any given time. The MESA-Net Async...

MESA-Net Async 
e multiple parallel links 
e 
loadsharing 
Note: For an overview of the tasks associated with installing and 
configuring MESA-Net Async, refer to the section “Overview of 
MESA-Net Tasks” at the end of Chapter 
1. 
et Async ardware 
To support MESA-Net Async, you must install one or more expansion serial cards in 
each Series 6 server on the network: 
Q For the Model 701, 1201, and l2OS, you can use either a 4-port 
Smartcard or a Serial 16/32 card. 
e For the Model 640, you must use the...

MESA-Net Async 
San Jose Node 1 San Jose Node 2 
Series 6 Server Series 6 Server 
A direct connection between co-located nodes 
is made by connecting a null modem cable 
between an Originate Link on each node and 
an Answer Link on the other node. 
There is a procedure at the end of this chapter that describes how to make a MESA- 
Net Async direct connection. 
Most MESA-Net Async connections are made using modems. Currently, Centigram 
has certified the following modems for use with MESA-Net: 
Telebit...