Home > Mitel > Communications System > Mitel SX 200 ML PABX Instructions Guide

Mitel SX 200 ML PABX Instructions Guide

Here you can view all the pages of manual Mitel SX 200 ML PABX Instructions Guide. The Mitel manuals for Communications System are available online for free. You can easily download all the documents as PDF.

Page 361

18 (Maintenance Functions - Test Line) 
19 (Direct Inward System Access) 
20 (Callback - Busy) 
21 (Call Hold) 
22 (Call Hold Retrieve - Local) 
23 (Call Hold Retrieve - Remote) 
24 (Abbreviated Dial Access) 
2.5 (Clear All Features) 
27 (Tone Demonstration) 
28 (ADL Call Setup) 
29 (ADL Disconnect) 
30 (Last Number Redial) 
31 (Executive Busy Override) 
32 (Automatic Wakeup) 
33 (Call Park) 
34 (Node ID) 
35 (Maid In Room) 
36 (SUPERSET 4 Set Room Status Display) 
37 (Direct to ARS) 
38 (UCD...

Page 362

Features Description 
Meter Pulse Collection 
2-213 
A&UVKData Module 2-214 
MITEL Application Interface (MAI) 2-215 
Modem Pooling 2-l 36 
Modem Pooling Queuing 
2-141 
Moving Stations and SU/?!%SETTelephones 
2-216 
Multi-Attendant Positions 2-216 
Multicall Line 2-202 
Music on Hold (MOH) 2-217 Programmable Key Module (PKM) 2-237 
N 
Names 2-218 
Never a Consultee 2-220 
Never a Forwardee 2-220 
New Call Ring 2-221 
Night 
/Day Switching 2-222 
Services 2-223 
Services Flexibility 2-223 
Night Bells...

Page 363

ACD Silent Monitoring (42) 2-53 
ACD Silent Monitoring Beeps (43) 2-53 
Analog Networking SMDR (06) 2-l 0, 2-257 
ARS Unknown Digit Length Timeout (47) 
2-57 
Attendant Call Block (09) 2-l 74 
Attendant Conference Beeps (10) 2-21 
Auto Room Status Conversion/Auto Wakeup 
Print (34) 2-l 75 
Auto Room Status Conversion/Auto Wakeup 
Print Timer (56) 2-l 75 
Auto Wakeup Alarm (12) 2-174 
Auto Wakeup Music (14) 2-175 
Auto Wakeup Print (13) 2-175 
Automated Attendant (106) 2-53 
Automatic Call Distribution...

Page 364

Features Description 
36 (End of Dial Character # Enabled) 
37 (Calibrated Flash) 
38 (Switch-hook Flash) 
39 Data SMDR Indicate Long Calls 
40 (Message Register Follows Talker) 
42 (ACD Silent Monitoring) 
43 (ACD Silent Monitoring Beeps) 
44 (ACD Reports) 
46 (Digit Translation Plan) 
47 (ARS Unknown Digit Length Timeout) 
48 (Limited Wait for Dial Tone) 
49 (Pseudo Answer Supervision Timer) 
50 (Dialing Conflict Timer) 
51 (Final Ring Timeout) 
52 (Minimum Flash Timer) 
53 (Maximum Flash Timer) 
54...

Page 365

SX-200@ ML PABX 
Peripheral 
Devices 
TM @ - Trademark of Mite1 Corporation. 
@‘Copwiqht 1997. Mite1 Corporation. 
All ri&ts&ave~ 
Printed in Canada.  

Page 366

Peripheral Devices 
NOTICE 
The information contained in this document is believed to be accurate in all re- 
spects but is not warranted by Mite1 Corporation (MlTEL@). The information is 
subject to change without notice and should not be construed in any way as a 
commitment by Mite1 
or any of its affiliates or subsidiaries. Mite1 and its affiliates 
and subsidiaries assume no responsibility for any errors or omissions in this doc- 
ument. Revisions of this document or new editions of it may be issued...

Page 367

Peripheral Devices 
NOTICE 
I . If any of the warranty seals on any MITEL SUPERSWITCH@ or SUPERSETTM 
products are broken, MITEL reserves the right to refuse to service the equipment 
or to void any remaining warranty on the equipment. 
2 . If any MITEL equipment has been modified so that it is not within manufacturer’s 
specifications (including, but not limited to, the installation of any non-MITEL parts, 
components, or replacement boards), then MITEL reserves the right to: refuse to 
service the...

Page 368

Peripheral Devices 
iv 
Issue 1 Revision 0 
March 1997  

Page 369

Table of Contents 
1. Introduction 
........................................................ ..I- 1 
General 
.............................................................. ..l- 1 
Reasonforlssue 
....................................................... ..I- 1 
Disclaimer ............................................................ 
. . l-l 
2. Attendant Console. 
.................................................. .2-1 
Physical Description 
..................................................... .2-l...

Page 370

Peripheral Devices 
SUPERSET 410 Telephone Installation Instructions ............................. .5-6 
Wall-Mounting the SUPERSET 470 Telephone ................................ .5-7 
Visual Indication of System Communications Problems .......................... .5-7 
Connection to the M/L/NKData Module ...................................... .5-7 
6. SUPERSET 420TM Telephone. ........................................ .6-l 
General Description ...................................................... .6-i...
Start reading Mitel SX 200 ML PABX Instructions Guide

Related Manuals for Mitel SX 200 ML PABX Instructions Guide

All Mitel manuals