Mitel SX-200 DIGITAL Pabx Information Manual

Installation Forms 
NOTES FOR FIGURE 4-2 
E&M/TIE TRUNK CARD SWITCH FUNCTIONS 
Notes: 
1. Trunk impedance switches are located on the rear face of the Trunk Card. 
2. Outgoing/incoming switch settings: 
Outgoing Incoming 
Busy Switch Busy Switch Result 
Set to Set to 
Idle Busy Normal trunk operation - if trunk is 
made busy by attendant, outgoing busy, 
incoming busy condition results. See 
below. 
Busy 
Busy Trunk cannot be seized, incoming or 
outgoing from the ACD system. 
Recommended setting if...

Installation Forms 
TABLE 4-3 
TRUNK CARD SWITCH SETTINGS - DID/TIE TRUNK CARD 
TRUNK NUMBER (l-200) 
SWITCH SETTINGS 
INCOMING CONDITIONS BUSY 
IDLE 
OUTGOING CONDITIONS ““1 1 1 
SWITCH “A” SETTING CLOSED 
OPEN 
SWITCH ‘3” SETTING CLOSED 
OPEN SWITCH “A” SETTING 
;WlTCH “B” SETTING CLOSED 
OPEN 
CLOSED 
OPEN 
JNCOMING WINK WINK INCOMING WINK WINK 
NO WINK 
OUTGOING WINK 
WINK 
NO WINK 
3i SY 
I I 
I  iiNK IMPEDANCE 
600 OHM 
VITCHES (3) 
900 OHM 
PULSING 
CONDITION BATTERY/GROUND 
LOOP 
DIALING...

Installation Forms 
L 
TRUNK CONTROL SWITCHES 
1 
TABLE 
TRUNK TVPE SWITCH A SWITCH B 
DID TRUNK CLOSED CLOSED 
I ““P TIE TPIINUK CLOSED OPEN 
---. ..- . ..-._.. 
------ _. -.. 
INCOMING DIAL - 1 OPEN 
1 CLOSED 
OUTGOlN 
NOT USE” , VrLI” , “TLI” 
, 
NORMAL SETTING 
5 = CLOSED 
6 = CLOSED 
7 = CLOSED 
8 = CLOSED 
9 = NOT USED 
10 = NOT USED ,-OPEN  
SEE TABLE 
OUTGOING 
WINK 
I # 
NOT 
OUTGOING 
WINK SWITCH 
r---1 
6000 :---:9oon 
L---J 
SW3 
TRUNK 1 
IMPEDANCE 
SWITCHES 
8 TRUNK 
BUSY 
SWITCHES 
6OO.Q...

Installation Forms 
NOTES FOR FIGURE 4-3 
DID/TIE TRUNK CARD SWITCH FUNCTIONS 
Notes: 1. Trunk impedance switches are located on the rear face of the Trunk Card. 
Trunk Busy Switches 
2. Outgoing Busy Switches (1 per trunk) can be set for either of the following conditions: 
Idle setting - normal trunk operation 
Busy setting - trunk cannot be seized for outgoing call 
3. The “outgoing busy” condition may be set either by the outgoing busy switch (Note 2), 
or by the console “Trunk Busy Out” function....

Installation Forms 
5. CABLING AND CROSS-CONNECTIONS 
General 
5.01 
The forms contained in this Part show the plug assignments for 
each circuit of each bay. The first four forms cover the four 
bays in the all-digital configuration. Plug assignment forms are also 
included for analog Bay 3 and Peripheral Cabinet, if needed. Power Fail 
Transfer card assignment forms are included for both Control and 
Peripheral cabinets. For more information, 
refer to Section 
MITL9108-093-200-NA, Shipping, Receiving...

Installation Forms 
PLUG 57 (at Cross-Connect Field) BAY 1 TABLE 5-l 
PLUG ASSIGNMENTS 
Bay/ Pair 
Connection/Comments 
Slot Cct Pin Colour (Extension, Circuit, Feature) 
I-2 26 W-BL 
1 BL-W 
27 w-o 
2 o-w 
26 W-G 
3 G-W 
29 W-BR 
4 BR-W 
30 W-S 
5 S-W 
31 R-BL 
6 BL-R 
32 R-O 
7 O-R 
33 R-G 
6 G-R 
34 R-BR 
9 BR-R 
35 R-S 
10 S-R 
36 BK-BL 
11 BL-BK 
37 BK-0 
12 0-BK 
36 BK-G 
Not Used 
13 G-BK 
Not Used 
l-l 39 BK-BR 
14 BR-BK 
40 BK-S 
15 S-BK 
41 Y-BL 
16 BL-Y 
42 Y-O 
17 O-Y 
43 Y-G 
18 G-Y 
44 Y-BR...

Installation Forms 
TABLE 5-l (CONT’D) 
BAY 1 PLUG ASSIGNMENTS 
PLUG Jll (at Cross-Connect Field) 
Bay/ Pair 
Slot Cct Pin Colour Connection/Comments 
(Extension, Circuit, Feature) 
l-4 
l-3 26 
1 
27 
2 
28 
3 
29 
4 
30 
5 
31 
6 
32 
7 
33 
8 
34 
9 
35 
10 
36 
11 
37 
12 
38 
13 
39 
14 
40 
15 
41 
16 
42 
17 
43 
18 
44 
19 
45 
20 
46 
21 
47 
22 
48 
23 
49 
24 
50 
25 W-EL 
EL-W 
w-o 
o-w 
W-G 
G-W 
W-BR 
BR-W 
w-s 
S-W 
R-BL 
BL-R 
R-O 
O-R 
R-G 
G-R 
R-BR 
BR-R 
R-S 
S-R 
BK-BL 
BL-BK 
BK-0...

Installation Forms 
TABLE 5-1 (CONT’D) 
BAY 1 PLUG ASSIGNMENTS 
PLUG J5 (at Cross-Connect Field) 
Bay/ Pair Connection/Comments 
Slot Cct Pin Colour (Extension, Circuit, Feature) 
l-6 26 W-BL 
1 BL-W 
27 w-o 
2 o-w 
26 W-G 
3 G-W 
29 W-BR 
4 BR-W 
30 w-s 
5 S-W 
31 R-BL 
6 BL-R 
32 R-O 
7 O-R 
33 R-G 
8 G-R 
34 R-BR 
9 BR-R 
35 R-S 
IO S-R 
36 BK-BL 
11 BL-BK 
37 BK-0 
12 0-BK 
38 BK-G 
Not Used 
13 G-BK 
Not Used 
l-5 39 BK-BR 
14 BR-BK 
40 BK-S 
15 S-BK 
41 Y-BL 
16 BL-Y 
42 Y-O 
17 O-Y 
43 Y-G 
18 G-Y...

Installation Forms 
TABLE 5-l (CONT’D) 
BAY 1 PLUG ASSIGNMENTS 
PLUG J9 (at Cross-Connect Field) 
Bay/ Pair 
Connection/Comments 
Slot Cct Pin 
Colour (Extension, Circuit, Feature) 
I-8 
26 W-BL 
1 BL-W 
27 w-o 
2 o-w 
28 W-G 
3 G-W 
29 W-BR 
4 BR-W 
30 w-s 
5 s-w 
31 R-BL 
6 BL-R 
32 R-O 
7 O-R 
33 R-G 
8 G-R 
34 R-BR 
9 BR-R 
35 R-S 
10 S-R 
36 BK-BL 
11 BL-BK 
37 BK-0 
12 0-BK 
38 BK-G 
Not Used 
13 G-BK Not Used 
l-7 39 BK-BR 
14 BR-BK 
40 BK-S 
15 S-BK 
41 Y-BL 
16 BL-Y 
42 Y-O 
17 O-Y 
43 Y-G 
18...

Installation Forms 
TABLE 5-2 
BAY 2 PLUG ASSIGNMENTS 
PLUG J31 (at Cross-Connect Field) 
Bay/ 
Slot Cct 
2-2 
Pair 
Connection/Comments 
Pin Colour 
(Extension, Circuit, Feature) 
26 W-BL 
1 BL-W 
27 w-o 
2 o-w 
26 W-G 
3 G-W 
29 W-BR 
4 BR-W 
30 W-S 
5 s-w 
31 R-BL 
6 BL-R 
32 R-O 
7 O-R 
33 R-G 
8 G-R 
34 R-BR 
9 BR-R 
35 R-S 
10 S-R 
36 BK-BL 
11 BL-BK 
37 BK-0 
12 0-BK 
38 BK-G 
Not Used 
13 G-BK 
Not Used 
39 BK-BR  2-l 
14 BR-BK 
40 BK-S 
15 S-BK 
41 Y-BL 
16 BL-Y 
42 Y-O 
17 O-Y 
43 Y-G 
18 G-Y...