Lexmark X264 Service Manual

Repair information 4-73
7013-XXX
Right side printer cover removal
1.Remove the rear door and cover. See “Rear door and cover removal” on page 4-69.
2.Remove the front scanner cover. See “Front scanner cover removal” on page 4-29.
3.Remove the right side scanner cover. See “Right side scanner cover removal” on page 4-75.
4.Remove the screw (A) from the front of the printer.
A 

4-74  Service Manual 7013-XXX
5.Press in on the tabs (B), and swing the right side printer cover out.
6.Lift the right side printer cover, and remove.
B
B 

Repair information 4-75
7013-XXX
Right side scanner cover removal
1.Lift the ADF scanner cover, and remove the front scanner cover. See “Front scanner cover removal” on 
page 4-29.
2.Remove the screw (A) from the front of the printer.
3.Remove the screw (B) from the rear of the printer.
A
B 

4-76  Service Manual 7013-XXX
4.Disconnect the right side scanner cover from the printer, and remove. 

Repair information 4-77
7013-XXX
Toner level sensor removal
1.Open the front access door.
2.Remove the right side printer cover. See “Right side printer cover removal” on page 4-73.
3.Disconnect the toner level sensor cable (A) from J5 on the controller board.
4.Squeeze the lower tabs (B) of the toner level sensor, and push it from its holder.
5.Remove the toner level sensor through the inside of the printer.
Note:  The toner level sensor must be installed properly, or the printer will not function.
BA 

4-78  Service Manual 7013-XXX
Top printer cover removal
1.Remove the ADF scanner assembly. See “ADF scanner assembly removal” on page 4-9.
2.Open the front access door.
3.Lift the top printer cover, and remove. 

Repair information 4-79
7013-XXX
Transfer roll removal
Note:  A flashlight may be useful to remove the transfer roll.
1.Open the front access door. 
2.At the right side of the transfer roll, squeeze the holder arms (A) with the left hand while lifting. Stop when 
the holder is unlatched.
3.At the left side of the transfer roll, squeeze the holder arms with the right hand while lifting with the left 
hand. Stop when the left holder is unlatched. 
4.With a hand at each end, lift the transfer roll out....

4-80  Service Manual 7013-XXX
Upper front guide assembly removal
1.Open the front access door.
2.Remove the four screws (A) from the upper front guide.
3.Remove the upper front guide.
A 

Repair information 4-81
7013-XXX
Wear strip (tray 1 and 250-sheet tray 2) removal
1.Hold the tray with the bottom up.
2.Use a spring hook to disconnect the strip from the top of the tray.
3.Remove the strip from inside the tray. 

4-82  Service Manual 7013-XXX
Wear strip (550-sheet tray 2) removal
1.Use a spring hook to disconnect the strip from the top of the tray.
2.Life the strip, and remove.
Note:  When replacing the strip (for all trays):
•Carefully insert the strip from the top of the tray, and push it down through the opening until it clicks 
into place.
•Turn the tray over to view the bottom of the strip. Using the spring hook, check to make sure that the 
end of the strip is fastened tightly.
•Be sure that the drafted...