Lexmark X264 Service Manual

Repair information 4-23
7013-XXX
Fax card removal
1.Remove the rear door and cover. See “Rear door and cover removal” on page 4-69.
2.Remove the right side printer cover. See “Right side printer cover removal” on page 4-73.
3.Remove the two screws (A) securing the fax card to the printer frame.
4.Disconnect the cable (B) from the controller board.
5.Remove the fax card.
CAUTION
This product contains a lithium battery. THERE IS A RISK OF EXPLOSION IF THE BATTERY 
IS REPLACED BY AN INCORRECT TYPE. Discard...

4-24  Service Manual 7013-XXX
Flatbed removal
1.Remove the ADF. See “ADF removal” on page 4-4 or “Toner level sensor removal” on page 4-77.
2.Remove the left side scanner cover. See “Left side scanner cover removal” on page 4-35.
3.Remove the right side scanner cover. See “Right side scanner cover removal” on page 4-75.
4.Remove the right side printer cover. See “Right side printer cover removal” on page 4-73.
5.Remove the operator panel. See “Operator panel removal” on page 4-65.
6.Remove the two screws...

Repair information 4-25
7013-XXX
9.Remove the torroid (C) from the ribbon cable.
10.Lift the scanner, and remove all cables.
11.Remove the scanner. 

4-26  Service Manual 7013-XXX
Installation note:
1.Remove the clear plastic guide from the old flatbed and attach it to the new flatbed.
2.Route the CCD ribbon cable through the guide as shown below.
3.Install the large torroid from the old ribbon cable onto the CCD ribbon cable as shown above.
4.Route the flatbed motor cable and the home sensor cables in the channel and under the tab (D). 

Repair information 4-27
7013-XXX
5.Route the flatbed motor cable and the home sensor cables under the ribbon cable folding guide (E) and 
torroid (F).
6.After the cables are folded and routed, the flatbed assembly should look like the picture below. 

4-28  Service Manual 7013-XXX
Front door access cover blank removal
1.Remove the nameplate blank cover. See “Nameplate blank cover removal” on page 4-64.
2.Remove the two screws (A).
3.Remove the front door access cover blank.
A 

Repair information 4-29
7013-XXX
Front scanner cover removal
1.Use a flathead screwdriver to pry the front scanner cover away from the printer.
Note:  Be careful to not mar the finish of the printer.
2.Pull the scanner cover away from the operator panel.
3.Remove the front scanner cover. 

4-30  Service Manual 7013-XXX
Fuser removal
1.Remove the rear exit guide. See “Rear exit guide assembly with sensor and reversing solenoid 
removal” on page 4-71.
2.Remove the two screws (A).
3.Partially pull the fuser forward for better access. 

Repair information 4-31
7013-XXX
4.Push in on the cable connector cover (B), and remove.
5.Disconnect the AC cable (C).
6.Disconnect the thermistor cable (D).
C
B
D 

4-32  Service Manual 7013-XXX
7.Disconnect the exit sensor cable (E) from the controller board.
8.Remove the fuser.
Note:  
•Be careful to not damage the gears during the fuser installation.
•Be sure to reinstall the AC cable during the fuser installation.
E