Lexicon Rv5 User Manual

RV-5Tuner, PC, & Dock Controls
5-7
To remove the factory installed
insert, hold the Dock with one
hand as you grab the edges of
the insert in the Dock with
your other hand, then pull
straight up. Use the following
as a guide to determine which
insert is correct for your iPod model:
 For any iPod with a color screen, including all iPod photo
models, use the insert with “COLOR/PHOTO” on the back.
This insert is already installed in the Dock at the factory.
 For 20GB or 30GB iPod photo models only, remove...

Tuner, PC, & Dock ControlsLexicon
5-8
As the menus on the iPod are scrolled through, the top left side
indicates the menu item selected and the bottom left side indicates
the menu items as they are scrolled through, as shown: 
Note: The allotted space for iPod navigation descriptions is 14 characters. If
a menu item is longer than this limitation, the displayed name is simply cut
off at the 14-character point.
When a song is playing, the bottom of the 2-line display identifies
the track counter, the time...

RV-5Tuner, PC, & Dock Controls
5-9
 AUTO/MAN mimics the MENU button on the iPod.  The MENU
button backs out of the menu structure, one level at a time,
each time it is pressed.  
 SAVE mimics the SELECT button on the iPod. The SELECT
button acts as a play button at the song level.  The select
button drills deeper into the menu structure, one level at a
time, each time it’s pressed. 
 ST/MON and FM/AM both mimic the Play/Pause (
|| ) control
of the iPod. If the playlist is not active, pressing this...

Tuner, PC, & Dock ControlsLexicon
5-10 

6
Troubleshooting & Maintenance
Troubleshooting ......................................................................... 6-2
RV-5 Error Messages ................................................................... 6-7
Video Error Messages ................................................................................ 6-7
Autocal Error Messages ............................................................................. 6-8
Video Resolutions Table...

Troubleshooting & MaintenanceLexicon
6-2
TROUBLESHOOTING
The RV-5 does not power on.
1. Make sure the rear panel power switch is set to the ON
position.
2. Attempt to power on the RV-5 with the front panel Standby
button and remote control ON button.
3. Examine the power cord to ensure a good connection between
the rear panel AC input connector and the wall outlet.
4. Check the electrical circuit and breaker.
The remote control does not work.
1. Make sure that the remote control touch screen is in the...

RV-5Troubleshooting & Maintenance
6-3
A humming sound is present in the audio.
1. If a cable TV connection is present, disconnect the cable from
the wall outlet. If this eliminates the humming sound, a ground
loop isolation device is required. Contact your dealer or cable
provider for assistance.
2. Disconnect components one at a time to isolate the problem.
Once the problem is identified, make sure the associated
component is properly grounded and connected to the same
electrical circuit as the RV-5...

Troubleshooting & MaintenanceLexicon
6-4
The RV-5 is powered on, but there is no video.
1. Examine the video cables – particularly the S-Video cables – 
to ensure a good connection to the associated component. 
2. Check the INPUT SETUP menu VIDEO IN  parameter to ensure
the appropriate video connector is assigned to the selected
input.
3. Set the V-PROCESS parameter to BYPASS.  This setting doesn’t
apply any video processing and outputs the signal in the same
resolution and format as the incoming signal....

RV-5Troubleshooting & Maintenance
6-5
VIDEO IN is set to NONE, but the monitor has a video error, or
is showing a blue screen.
When the VIDEO IN parameter is set to NONE, the RV-5 outputs a
blue screen at 480i resolution. This blue screen cannot be disabled.
If the monitor does not support 480i resolution, the monitor may
display an error message. 
Note: This condition can also exist when the VIDEO IN parameter
has been setup, but there is no active incoming signal.
The 2-line OSD display does not appear...

Troubleshooting & MaintenanceLexicon
6-6
Using the PC input, the remote control commands on page 4 of
the LEX menu, page 3 of the TUNER menu, and page 2 of the
ZONE 2 menu do not work.
1. Make sure that the computer is properly connected to the USB
input of the RV-5 Receiver.
2. Make sure that PC is selected as the active input on the RV-5
Receiver.
3. Make sure that the media player has been opened on the
computer and is playing audio.
4. Make sure the media player is the “top” or active screen on the...