Land Rover Range Rover Body Repair Rover Manual

75SUPPLEMENTARY RESTRAINT SYSTEM NEW RANGE ROVER
10
PRECAUTIONS
7.Press both operating buttons to deploy airbag
module.
8.DO NOT return to airbag module for 30 minutes.
9.Using gloves and face mask, remove airbag
module from fascia. Place airbag module in
plastic bag adn seal bag.
10.Transport deployed airbag module to designated
area for incineration.
NOTE: DO NOT transport airbag module in
the vehicle passenger compartment.
11.Scrap all remaining parts of airbag system. DO
NOT re-use or salvage any...

SUPPLEMENTARY RESTRAINT SYSTEM
11
PRECAUTIONS Deployment with module removed from vehicle
These guidelines are written to aid authorised
personnel to carry out the safe disposal of airbag
modules when removed from the vehicle.
WARNING: Only use Land Rover approved
deployment equipment. Deploy airbag
modules in a well ventilated, designated
area.
Drivers airbag module
1.Carry out deployment tool self test.
2.Remove airbag module from steering wheel.
See Repair.
3.Position tool SMD 4082/2 in vice, ensuring...

75SUPPLEMENTARY RESTRAINT SYSTEM NEW RANGE ROVER
12
PRECAUTIONS
9.Press both operating buttons to deploy airbag
module.
10.DO NOT return to airbag module for 30 minutes.
11.Using gloves and face mask, remove airbag
module from tool, place airbag module in plastic
bag and seal bag.
12.Wipe down tool with damp cloth.
13.Transport deployed airbag module to designated
area for incineration
NOTE: DO NOT transport airbag module in
the vehicle passenger compartment.Passengers airbag module
1.Carry out...

SUPPLEMENTARY RESTRAINT SYSTEM
13
PRECAUTIONS 6.Ensure airbag module mounting brackets are
secure.
WARNING: Ensure tool SMD 4082/1 is not
connected to battery.
7.Connect flylead SMD 4082/5 to airbag module.8.Connect flylead SMD 4082/5 to tool SMD
4082/1.
WARNING: Do not lean over module whilst
connecting.
9.Connect tool SMD 4082/1 to battery.
WARNING: Ensure all personnel are
standing at least 15 metres away from
module.
10.Press both operating buttons to deploy airbag
module.
11.DO NOT return to airbag...

SUPPLEMENTARY RESTRAINT SYSTEM
1
REPAIR AIRBAG MODULE - PASSENGER SIDE
Service repair no - 76.73.69
WARNING: All the airbag system
components, including the wiring harness,
MUST be renewed after the airbags have
deployed.
Remove
1.Disconnect both battery terminals, disconnect
negative lead first.
2.Remove glove box assembly.
See CHASSIS
AND BODY, Repair.
3.Release and disconnect air bag module
multiplug.
4.Remove 4 bolts and washers (E-10 Torx Bit)
securing air bag module to fascia frame.
5.Carefully...

75SUPPLEMENTARY RESTRAINT SYSTEM NEW RANGE ROVER
2
REPAIR SRS ECU
Service repair no - 76.73.72
Remove
WARNING: Always disconnect negative
lead from battery first. Disconnection of
positive lead with negative lead connected
risks short circuit and severe sparking through
accidental grounding of spanner. Personal injury
could result.
1.Disconnect both battery terminals.
2.Remove centre console.
See CHASSIS AND
BODY, Repair.
3.Lift rear of sound deadener pad from
transmission tunnel.
4.Disconnect SRS ECU...

SUPPLEMENTARY RESTRAINT SYSTEM
3
REPAIR SRS HARNESS - SINGLE POINT SENSED SYSTEM
Service repair no - 76.73.73
The SRS harness is incorporated into the fascia
harness.
See ELECTRICAL, Repair.
SRS HARNESS - DISTRIBUTED SYSTEM
Service repair no - 76.73.73
Remove
1.Raise the vehicle.
WARNING: Support on safety stands.
2.Remove battery.
See ELECTRICAL, Repair.
3.Remove centre console.See CHASSIS AND
BODY, Repair.
4.Remove passenger air bag module.See this
section.
5.Remove radio.See ELECTRICAL, Repair....

75SUPPLEMENTARY RESTRAINT SYSTEM NEW RANGE ROVER
4
REPAIR 13.Remove screw securing each A post lower trim
panel. Release panels from sprag clips. Remove
both trim panels.
14.Remove 4 scrivet fasteners securing drivers side
lower closing panel.
15.Disconnect footwell lamp multiplug. Remove
closing panel.
16.Disconnect SRS harness from main harness.
Release multiplug from clip.
17.Remove sound deadener pad from transmission
tunnel.
18.Disconnect multiplug from SRS ECU. Release 3
harness clips.
19.Remove...

SUPPLEMENTARY RESTRAINT SYSTEM
5
REPAIR 20.Remove 2 trim studs securing air cleaner baffle
beneath LH wheel arch. Remove baffle.
21.Disconnect both SRS crash sensor multiplugs.
22.Remove 4 bolts securing battery tray. 

75SUPPLEMENTARY RESTRAINT SYSTEM NEW RANGE ROVER
6
REPAIR
23.Remove 2 bolts securing air cleaner to valance.
24.Raise air cleaner and battery tray to gain accessto crash sensor harness clips.
25.Release clips securing each crash sensor
harness to valance.
26.Release harness grommets. Feed both
harnesses through valance into wheel arches.
27.Release 3 clips securing each crash sensor
harness to underside of wheel arches.
28.Release harness bulkhead grommets. Feed
harnesses through bulkhead into passenger...