Land Rover Body And Paint Air Bag And Safety Belt Rover Manual

Fusible link 2E (permanent 12V supply)3
Fuse 25E (permanent 12V supply)4
Lighting control switch5
LH headlamp levelling motor (if fitted)6
RH headlamp levelling motor (if fitted)7
LH front fog lamp8
RH front fog lamp9
Front fog lamp relay (NAS only)10
Daytime Running Lamps (DRL) relay (if fitted)11
Central Junction Box (CJB)12
Fuse 38P (NAS only)13
Instrument cluster14
Steering angle sensor15
Parking brake module16
Engine Control Module (ECM)17
Air suspension control module18
ABS module19
Stop lamp...

The generator is located at the front RH side of the
engine, on the cylinder block. The generator has an
output of 85/150 Amps and is manufactured by Denso.
A six-ribbed polyvee belt drives the generator pulley,
which in turn is driven from the engine crankshaft
pulley.
The generator comprises a stator, a rotor, a rectifier pack
and a regulator. There is a three-pin connector (C0053)
on the generator:
•Pin 1 – Voltage reference line to the battery via the
Battery Junction Box (BJB)
•Pin 2 – Pulse Width...

information received from its various sensors, hence
voltage will follow the batterys needs a lot more
accurately.
The regulator has transistors, which rapidly switch on
and off to regulate the voltage output according to the
voltage sensed internally. The regulator also provides
a PWM signal output to the ECM, which uses the signal
to adjust the idle speed under varying electrical loads.
Initially, the ignition switch supply provides an
excitation current to the rotor at low generator speeds
via...

GENERAL
Information and Message Displays
Terrain Response™ icons (if applicable)1
Message display2
LCD Message center3
Odometer display4
Miles or KM display5
Trip meter display6
LCD Information display7
Gear position display (Automatic transmission
only)
8
Transmission mode display (Automatic
transmission only)
9
Selected gear position display (Automatic
transmission only)
10
Two variants of the instrument cluster are used; high
line and low line. Both variants also differ depending
on market...

MESSAGE CENTER
The message center is an Liquid Crystal Display (LCD)
located in a central position at the bottom of the
instrument cluster. The LCD has a viewable area of 71
mm X 36 mm with a pixel size of 0.54 mm X 0.54 mm.
When active, the message center is illuminated as
follows:
•At ignition on.
•At ignition off when all current messages are being
displayed to the driver.
•At ignition off, each current message is displayed in
turn for 3 seconds. The message center will remain
active if KEY IN...

FormatDescriptionDisplay
Mode
No display in this modeBlank0
Customer settings
display
Information1
System precheck at
ignition on
Pre-check2
Seven different formats
available (A, B, C, D,
E, F or G) depending on
vehicle specification
and active functions
Normal3
Display Mode 0
This mode is entered when the ignition is off and the
CAN bus system is asleep and no characters or symbols
are displayed. This mode is exited by switching the
ignition on or if the driver selects the Customer Settings
mode....

also be accompanied by the appropriate warning
indicator flashing and a continuous chime from the
instrument cluster. If more than one priority 1
message is present, each message is displayed in turn
at 3 second intervals.
Priority Group 2
•This group of messages do not directly affect the
driving ability or safety of the vehicle, CHECK
BRAKE PADS for example. This message must be
noted by the driver and the cause rectified as soon
as possible. Each of these messages is displayed once
at ignition on or...

ActionReasonOther WarningsMessage
Raise suspension manually
to off-road height if
required
Advisory message for Terrain
Response mud/ruts special program
when in high range, displayed once
every ignition cycle (Suspension
raised automatically when in low
range)
Mud-ruts program
icon illuminated in
message center
RECOMMEND
RAISING
SUSPENSION TO
OFF ROAD HEIGHT
IN DEEP MUD-RUTS
NoneAdvisory message to inform driver
that Terrain Response special
programs are off
All five program
icons illuminated
in message...

ActionReasonOther WarningsMessage
NoneAdvisory message. Terrain
Response Rock Crawl special
program has been selected for more
than 2 seconds and is currently
active
Rock crawl
program icon illu-
minated in
message center
ROCK CRAWL
PROGRAM SELECTED
NoneAdvisory message. Terrain
Response Grass Gravel Snow
special program has been selected
for more than 2 seconds and is
currently active
Grass gravel snow
program icon illu-
minated in
message center
GRASS GRAVEL
SNOW
PROGRAM SELECTED
NoneAdvisory message....

ActionReasonOther WarningsMessage
If operating conditions
change within 60 seconds,
selected program will be
activated. If message
caused by electronically
controlled differential(s)
overheat, allow differen-
tial(s) to cool and attempt
to reselect program.
Vehicle operating conditions
prevent selection of program. This
may be caused by ABS or DSC
activity or electronically controlled
differential(s)
Selected special
program icon illu-
minated in
message center
PROGRAM CHANGE
IN PROGRESS
Connect T4 to...