Konica Minolta bizhub C10P User Manual

							Loading Media 69
5Load the paper face up in the 
tray.
Do not load above the 
100% line. Up to 500 
sheets (80 g/m
2 [22 lb]) of 
plain paper can be 
loaded into the tray at 
one time.
6Reattach the lid to Tray 2.
100%
75
50
Downloaded From ManualsPrinter.com Manuals 
						

							Loading Media 70
7Reinsert Tray 2 into the printer.
Downloaded From ManualsPrinter.com Manuals 
						

							Duplexing 71
Duplexing
Select paper with high opacity for duplex (double sided) printing. Opacity 
refers to how effectively paper blocks out what is written on the opposite side 
of the page. If the paper has low opacity (high translucency), then the printed 
data from one side of the page will show through to the other side. Check 
your application for margin information. For best results, print a small quantity 
to make sure the opacity is acceptable.
Duplex (Double sided) printing can be done automatically with the duplex 
option installed and selected.
Note
Only plain paper, 60–90 g/m2 (16–24 lb bond) can be autoduplexed. See 
“Media Specifications” on page 50. 
 
Duplexing envelopes, labels, transparencies, or glossy is not 
supported.
How do I autoduplex?
You should verify that the duplex option is physically installed on the printer to 
successfully duplex the job.
Check your application to determine how to set your margins for duplex  
printing.
The following Binding Position settings are available.
If “Short Edge” is selected, the pages will be laid out to flip 
at the top.
If “Long Edge” is selected, the pages will be laid out to flip 
at the sides.
1
3
1
21
111
12
3
Downloaded From ManualsPrinter.com Manuals 
						

							Output Tray 72
In addition, if “N-up” has been set to “Booklet”, autoduplex printing is per-
formed.
The following Order settings are available when “Booklet” is selected.
1Load plain paper into the tray.
2From the printer driver, specify the layout for duplex printing.
3Click OK.
With autoduplexing, the back side is printed first, and then the front 
side is printed.
Output Tray
All printed media is output to the face-down output tray on top of the printer. 
This tray has a capacity of approximately 200 sheets (A4/Letter) of 80 g/m2 
(22 lb) paper. 
If the media is stacked too high in the output tray, your printer may 
experience media misfeeds, excessive media curl, or static buildup. 
Remove transparencies as soon as possible from the output tray to 
avoid static buildup.
If “Left Binding” is selected, the pages can be folded as a 
left-bound booklet.
If “Right Binding” is selected, the pages can be folded as a 
right-bound booklet.
1
12
3
3
3
1 12
Downloaded From ManualsPrinter.com Manuals 
						

							Media Storage 73
Media Storage
How do I store media?
„Keep media on a flat, level surface in its original wrapper until it is time to 
load it.
Media that has been stored for a long time out of its packaging may dry up 
too much and cause misfeeding.
„If media has been removed from its wrapper, place it in its original pack-
aging and store in a cool, dark place on a level surface.
„Avoid moisture, excessive humidity, direct sunlight, excessive heat (above  
35°C [95°F]), and dust.
„Avoid media leaning against other objects or placing it in an upright posi-
tion.
Before using stored media, do a trial print and check print quality. 
Downloaded From ManualsPrinter.com Manuals 
						

							Media Storage 74
Downloaded From ManualsPrinter.com Manuals 
						

							Replacing 
Consumables
Downloaded From ManualsPrinter.com Manuals 
						

							Replacing Consumables 76
Replacing Consumables
Note
Failure to follow instructions as outlined in this manual could result in 
voiding your warranty.
About Toner Cartridges
Your printer uses four toner cartridges: black, yellow, magenta, and cyan. 
Handle the toner cartridges carefully to avoid spilling toner inside the printer 
or on yourself.
Install only new toner cartridges in your printer. If a used toner car-
tridge is installed, the indicator message will not clear and the supplies 
status in the Status Display will not be updated.
The toner is nontoxic. If you get toner on your skin, wash it off with 
cool water and a mild soap. If you get toner on your clothes, lightly 
dust them off as best as you can. If some toner remains on your 
clothes, use cool, not hot water, to rinse the toner off.
CAUTION
If you get toner in your eyes, wash it out immediately with cool water 
and consult a doctor. 
Note
Do not use refilled toner cartridges or unapproved toner cartridges. Any 
damage to the printer or quality problems caused by a refilled toner 
cartridge or unapproved toner cartridge will void your warranty. No 
technical support is provided to recover from these problems.
Downloaded From ManualsPrinter.com Manuals 
						

							Replacing Consumables 77
When replacing a toner cartridge, refer to the following table. For optimum 
print quality and performance, use only approved KONICA MINOLTA toner 
cartridges for your specific printer type, as listed in the table below. If you 
open the top cover, you can find your printer type and the toner cartridge part 
numbers on the consumables reorder label inside your printer.
Keep toner cartridges: 
„In their packaging until you’re ready to install them.
„In a cool, dry location away from sunlight (due to heat). 
The maximum storage temperature is 35° C (95° F) and the maximum 
storage humidity is 85% (noncondensing). If the toner cartridge is moved 
from a cold place to a warm, humid place, condensation may occur, 
degrading print quality. Allow the toner to adapt to the environment for 
about one hour before use.
„Level during handling and storage. 
Do not hold, stand or store 
cartridges on their ends or turn 
them upside down; the toner 
inside the cartridges may 
become caked or unequally 
distributed.
„Away from salty air and corrosive gases such as aerosols.
Printer 
Ty p ePrinter Part 
NumberToner Cartridge TypeToner Cartridge 
Part Number
AMA00V-015
High-Capacity Toner Cartridge - Black (K)A00W-864
High-Capacity Toner Cartridge - Yellow (Y)A00W-865
High-Capacity Toner Cartridge - Magenta (M)A00W-866
High-Capacity Toner Cartridge - Cyan (C)A00W-867
EUA00V-025
High-Capacity Toner Cartridge - Black (K)A00W-874
High-Capacity Toner Cartridge - Yellow (Y)A00W-875
High-Capacity Toner Cartridge - Magenta (M)A00W-876
High-Capacity Toner Cartridge - Cyan (C)A00W-877
Downloaded From ManualsPrinter.com Manuals 
						

							Replacing Consumables 78
Replacing a Toner Cartridge
Note
Be careful not to spill toner while replacing a toner cartridge. If toner 
spills, immediately wipe it off with a soft, dry cloth.
If TONER OUT ACTION on the QUALITY/TONER OUT ACTION menu 
is set to 
STOP, the message REPLACE X TONER (where “X” represents the 
color of the toner) appears when a toner cartridge becomes empty. Follow the 
steps below to replace the toner cartridge.
If TONER OUT ACTION on the QUALITY/TONER OUT ACTION 
menu is set to 
CONTINUE, the message X EMPTY appears.
1Check the message window to see which color of toner is empty. 
Perform the operation described below to automatically rotate the carou-
sel to move the toner cartridge for the specified color, so that it can be 
replaced.
Press KeyUntil Display Reads
REPLACE X TONER or  
X EMPTY
MENU  
PRINT MENU
If the hard disk drive is installed, the 
PROOF/PRINT MENU appears.
 × 2 (or × 3)MENU  
QUALITY MENU
REPLACE TONER
BLACK
 Press until appropriate 
color (X) is displayed. 
X 
Downloaded From ManualsPrinter.com Manuals