Konica Minolta bizhub C10P User Manual

Loading Media 69
5Load the paper face up in the 
tray.
Do not load above the 
100% line. Up to 500 
sheets (80 g/m
2 [22 lb]) of 
plain paper can be 
loaded into the tray at 
one time.
6Reattach the lid to Tray 2.
100%
75
50
Downloaded From ManualsPrinter.com Manuals 

Loading Media 70
7Reinsert Tray 2 into the printer.
Downloaded From ManualsPrinter.com Manuals 

Duplexing 71
Duplexing
Select paper with high opacity for duplex (double sided) printing. Opacity 
refers to how effectively paper blocks out what is written on the opposite side 
of the page. If the paper has low opacity (high translucency), then the printed 
data from one side of the page will show through to the other side. Check 
your application for margin information. For best results, print a small quantity 
to make sure the opacity is acceptable.
Duplex (Double sided) printing can be done...

Output Tray 72
In addition, if “N-up” has been set to “Booklet”, autoduplex printing is per-
formed.
The following Order settings are available when “Booklet” is selected.
1Load plain paper into the tray.
2From the printer driver, specify the layout for duplex printing.
3Click OK.
With autoduplexing, the back side is printed first, and then the front 
side is printed.
Output Tray
All printed media is output to the face-down output tray on top of the printer. 
This tray has a capacity of approximately...

Media Storage 73
Media Storage
How do I store media?
„Keep media on a flat, level surface in its original wrapper until it is time to 
load it.
Media that has been stored for a long time out of its packaging may dry up 
too much and cause misfeeding.
„If media has been removed from its wrapper, place it in its original pack-
aging and store in a cool, dark place on a level surface.
„Avoid moisture, excessive humidity, direct sunlight, excessive heat (above  
35°C [95°F]), and dust.
„Avoid media leaning...

Media Storage 74
Downloaded From ManualsPrinter.com Manuals 

Replacing 
Consumables
Downloaded From ManualsPrinter.com Manuals 

Replacing Consumables 76
Replacing Consumables
Note
Failure to follow instructions as outlined in this manual could result in 
voiding your warranty.
About Toner Cartridges
Your printer uses four toner cartridges: black, yellow, magenta, and cyan. 
Handle the toner cartridges carefully to avoid spilling toner inside the printer 
or on yourself.
Install only new toner cartridges in your printer. If a used toner car-
tridge is installed, the indicator message will not clear and the supplies 
status in the...

Replacing Consumables 77
When replacing a toner cartridge, refer to the following table. For optimum 
print quality and performance, use only approved KONICA MINOLTA toner 
cartridges for your specific printer type, as listed in the table below. If you 
open the top cover, you can find your printer type and the toner cartridge part 
numbers on the consumables reorder label inside your printer.
Keep toner cartridges: 
„In their packaging until you’re ready to install them.
„In a cool, dry location away...

Replacing Consumables 78
Replacing a Toner Cartridge
Note
Be careful not to spill toner while replacing a toner cartridge. If toner 
spills, immediately wipe it off with a soft, dry cloth.
If TONER OUT ACTION on the QUALITY/TONER OUT ACTION menu 
is set to 
STOP, the message REPLACE X TONER (where “X” represents the 
color of the toner) appears when a toner cartridge becomes empty. Follow the 
steps below to replace the toner cartridge.
If TONER OUT ACTION on the QUALITY/TONER OUT ACTION 
menu is set to...