GGP Italy SPA LAWN MOWER 71520122 2 M150 OPERATORS MANUAL

1EN
READING AND UNDERSTANDINGTHE MANUAL
Some paragraphs in the manual containing infor-mation of particular importance for safety andoperation are highlighted at various levels ofemphasis, and signify the following:
or These give details or further information onwhat has already been said, and aim to preventdamage either to the engine or other damages.
Non-observance will re-sult in the risk of injury to oneself or others.
Non-observance will re-sult in the risk of serious injury or death tooneself or...

– if you have spilt some fuel, do not attemptto start the engine but move the machineaway from the area of spillage and avoidcreating any source of ignition until the fuelhas evaporated and fuel vapours have dis-sipated.– always put the tank and fuel container capsback on and tighten well. 4) Replace faulty silencers and the guard, ifdamaged.
C) OPERATION
1) Do not operate the engine in a confinedspace where dangerous carbon monoxide fu-mes can collect.2) Do not use starting fluids or similar...

The engine performance, reliability and life areinfluenced by many factors, some external andsome strictly associated with the quality of theproducts used and with the scheduled mainte-nance. 
The following information allow a better under-standing and use of your engine.
ENVIRONMENTAL CONDITIONS
The operation of a four-stroke endothermicengine is affected by:
a) Temperature:– Working in low temperatures could lead to adifficult cold starting.– Working in very high temperatures could leadto a difficult...

BEFORE EVERY USE
Before every use, perform the following checkingprocedures in order to assure a regular opera-tion.
Check oil level
See the specific chapter (see 8.1) for the oil to beused. 
a)Place engine level.b)Clean around oil fill.c)Remove the fillercap (1), clean the tip of thedipstick (2), insert and tighten down.d)Remove dipstick again and check the oil levelthat must be between the “MIN” and “MAX”marks.e)If oil is required, add oil of the same kind upto the “MAX” mark, being careful not to...

engine running, do not get loose-fittingclothing (ties, scarves, etc.) or hair closer tothe top part of the engine.
Do not operate on over 15°inclines to prevent malfunctioning of theengine.
STOPPING DURING OPERATION
a)Move the throttle (1) to “SLOW”.b)Stop the engine as described in the machi-ne’s instructions manual.
STOPPING AT THE ENDOF OPERATION
a)Move the throttle (1) to “SLOW”.b)Stop the engine as described in the machi-ne’s instructions manual.c)Once the engine has cooled, disconnect thespark...

CHANGE OIL
See the specific chapter (see 8.1) for the oil to beused.
Drain oil while the engineis warm, being careful not to touch the hotengine nor the drained oil.
a)Place engine level.b)Clean around oil fill (1).c)Remove the fillercap (1). d)Have a container ready (2) to collect the oil.e)Lay the engine on its left side to allow the oilto flow from the refill inlet (3) or follow the pro-cedures indicated in the Machine’s Instruc-tion Manual.f)When the engine is upright, top it up with newoil.g)Check...

ADJUSTMENT OF THEACCELERATOR CABLE
If the engine does not reach its maximum rpmwith the throttle control in “FAST” position, this islikely due to an out-of-phase connection betwe-en the accelerator lever and the governor lever. 
To restore the correct phase:a)Stop the engine, remove the spark plug capand wait until the engine has cooled.
6.7b)Loosen the screw (1) of the clamp (2) so thatthe cable casing (3) is free to move.
c)Move the throttle control to “SLOW”.
d)Move governor control lever (4) forward...

8EN
REFILLING AND OPERATION MATERIALS
Fuel  ........................................................................\
.................. Unleaded gasoline, minimum 90 octaneTank capacity  ........................................................................\
...................................................... 0.8 literEngine oil:  from 5 to 35 °C ........................................................................\
................................. SAE 30from -15 to +5 °C...

1DE
HINWEISE ZUR VERWENDUNG
Im Text des Handbuches sind einige Abschnitte, diebesondere Informationen zum Zweck derBetriebssicherheit enthalten, nach den folgendenKriterien unterschiedlich hervorgehoben:
oder Liefert erläuternde Hinweise oder andere Angabenüber bereits an früherer Stelle gemachte Aussagen,in der Absicht, den Motor nicht zu beschädigen oderSchäden zu vermeiden.
Im Falle der Nichtbeachtungbesteht die Möglichkeit, sich selbst oder Drittezu verletzen.
Im Falle der Nichtbeachtungbesteht die...

sowie bei jeder Handhabung mit Benzin nicht.– Benzin ist vor dem Starten des Motors einzufül-len. Während der Motor läuft oder bei heißerMaschine darf der Tankverschluss nicht geöff-net oder Benzin nachgefüllt werden.– Falls Benzin übergelaufen ist, darf kein Versuchunternommen werden, den Motor zu starten.Statt dessen ist die Maschine von der benzinver-schmutzten Fläche zu entfernen. Bis das Benzinnicht vollständig verdampft ist und die Benzin-dämpfe nicht verflüchtigt sind, vermeiden Siealles, was...