GE Logiq 7 Service Manual
Here you can view all the pages of manual GE Logiq 7 Service Manual. The GE manuals for Medical Equipment are available online for free. You can easily download all the documents as PDF.
Page 31
GE HEALTHCARE DIRECTION 2286865, REVISION 14LOGIQ™ 7 SERVICE MANUAL Section 1-2 - Important Conventions 1-9 Indicates the presence of hazardous substance(s) above the maximum concentration value. Maximum concentration values for electronic information products, as set by the People’s Republic of China Electronic Industry Standard SJ/ T11364-2006, include the hazardous substances of lead, mercury, hexavalent chromium, cadmium, polybrominated biphenyl (PBB), and polybrominated diphenyl ether...
Page 32
GE HEALTHCARE DIRECTION 2286865, REVISION 14LOGIQ™ 7 SERVICE MANUAL 1-10Section 1-2 - Important Conventions Section 1-3 Safety Considerations 1-3-1 Introduction The following safety precautions must be observed during all phases of operation, service and repair of this equipment. Failure to comply with these precautions or with specific warnings elsewhere in this manual, violates safety standards of design, manufacture and intended use of the equipment. 1-3-2 Human Safety Operating personnel must not...
Page 33
GE HEALTHCARE DIRECTION 2286865, REVISION 14LOGIQ™ 7 SERVICE MANUAL Section 1-2 - Important Conventions 1-11 1-3-4 Electrical Safety To minimize shock hazard, the equipment chassis must be connected to an electrical ground. The system is equipped with a three-conductor AC power cable. This must be plugged into an approved electrical outlet with safety ground. If an extension cord is used with the system, make sure that the total current rating of the system does not exceed the extension cord rating....
Page 34
GE HEALTHCARE DIRECTION 2286865, REVISION 14LOGIQ™ 7 SERVICE MANUAL 1-12Section 1-2 - Important Conventions 1-3-5 Label Locations (For BT07 or later, including R7.5.x) NOTE: For the symbols shown in the illustration below, refer to previous pages in this chapter. Figure 1-1 OUTSIDE MARKING S OF LOGIQ™ 7 For BT07 or later, including R7.5.x (Back Side) 7™ Japan/USA/Asia Console(100V) (9) (10) (11) (8) (2) (1) (3) (4) (6) (7) 7™ GE Yokogawa Medical Systems ETL LISTEDCONFORMS TO UL STD....
Page 35
GE HEALTHCARE DIRECTION 2286865, REVISION 14LOGIQ™ 7 SERVICE MANUAL Section 1-2 - Important Conventions 1-13 1-3-5 Label Locations (For BT07 or later, including R7.5.x) (cont’d) 1.) Possible Shock Hazard 2.) Caution for devices near by the equipment 3.) Caution for Transportation 4.) Prescription Devices (For USA Only) 5.) CE Marking of conformity 6.) WEEE mark 7.) CISPR 8.) Voltage Range 9.) Signal Ground Point Label 10.) Power Indication Label 11.) Caution for Grounding Reliability (For USA, Canada and...
Page 36
GE HEALTHCARE DIRECTION 2286865, REVISION 14LOGIQ™ 7 SERVICE MANUAL 1-14Section 1-2 - Important Conventions 1-3-6 Label Locations (For BT04, BT06, and V65x) NOTE: For the symbols shown in the illustration below, refer to previous pages in this chapter. 1.) Possible Shock Hazard 2.) Caution for devices near by the equipment 3.) Caution for Transportation 4.) Prescription Devices (For USA Only) 5.) CE Marking of conformity and WEEE mark 6.) CISPR 7.) Voltage Range 8.) Signal Ground Point Label 9.) Power...
Page 37
GE HEALTHCARE DIRECTION 2286865, REVISION 14LOGIQ™ 7 SERVICE MANUAL Section 1-2 - Important Conventions 1-15 1-3-6 Label Locations (For BT04, BT06, and V65x) (cont’d) 1.) ETL Label 2.) Identification and Rating Plate 3.) SFDA or SDA Label (For China ONLY) Figure 1-3 OUTSIDE MARKINGS OF LOGIQ™ 7 For BT04 or later ~ /05(çùù÷ ç 65ï0./;ç0+,ð 2. 1. 3.
Page 38
GE HEALTHCARE DIRECTION 2286865, REVISION 14LOGIQ™ 7 SERVICE MANUAL 1-16Section 1-2 - Important Conventions 1-3-7 Label Locations (For BT03 or lower) NOTE: For the symbols shown in the illustration below, refer to previous pages in this chapter. 1.) Possible Shock Hazard 2.) Caution for devices near by the equipment 3.) Caution for Transportation 4.) Prescription Devices (For USA Only) 5.) CE Marking of conformity 6.) CISPR 7.) Voltage Range 8.) Signal Ground Point Label 9.) Power Indication Label 10.)...
Page 39
GE HEALTHCARE DIRECTION 2286865, REVISION 14LOGIQ™ 7 SERVICE MANUAL Section 1-2 - Important Conventions 1-17 1-3-7 Label Locations (For BT03 or lower) (cont’d) 1.) ETL Label 2.) Identification and Rating Plate 3.) SDA Label (For China ONLY) Figure 1-5 OUTSIDE MARKINGS OF LOGIQ™ 7 For BT03 or lower (Left Side) ~ $IJOB7$POTPMF 3JHIU4JEF 2. 1. 3.
Page 40
GE HEALTHCARE DIRECTION 2286865, REVISION 14LOGIQ™ 7 SERVICE MANUAL 1-18Section 1-2 - Important Conventions 1-3-8 Dangerous Procedure Warnings Warnings, such as the example below, precede potentially dangerous procedures through our this manual. Instructions contained in the warnings must be followed. 1-3-9 Lockout/Tagout Requirements (For USA Only) Follow OSHA Lockout/Tagout requirements by ensuring you are in total control of the electrical Mains plug. 1-3-10 Returning/Shipping Probes and Repair...