GE Cardiocap 5 Service Manual

Functional Check Form 
NeuroMuscular Transmission (NMT) test 
 OK N.A. Fail 
29. Recognition    
30. Communication and memory    
31. ElectroSensor recognition    
32. Stimulus current test    
33. TOF measurement with NMT simulator 
T1%  950-1059 Supramax. current  < 70 mA 
T2%  950-1059 TOF%  95-105 
T3%  950-1059 Count  4 
T4%  950-1059 T1%  95-105 
Ratio%  950-1059 
Noise  < 50 
34. Stimulus pulse width 
 100 µs 300 µs Allowed range 
TOF%   95-105 
Count   4 
T1%   95-105 
 OK N.A. Fail 
35. No...

Functional Check Form 
Performance Checks 
General OK N.A. Fail 
1. Screen setup    
2. Waveforms    
InvBP measurement    
3. Test with patient simulator    
SpO2 measurement    
4. SpO2 sensor detection    
5. Test measurement     
6. “Probe off” detection    
NIBP measurement    
7. Test measurement and cuff identification    
Gas measurement    
8. D-fend check    
9. CO2 waveform    
 
Notes  
 
 
 
 
 
 
 
 
 
 
 
 
Signature  Date  
 
Appendix A 4    

EMC Guidance 
EMC GUIDANCE  
Table 1. Guidance and manufacturer’s declaration – electromagnetic emissions 
 
Guidance and manufacturer’s declaration – electromagnetic emissions 
The Cardiocap/5 is intended for use in the electromagnetic environment specified below. The customer 
or the user of the Cardiocap/5 should assure that it is used in such an environment. 
Emissions test Compliance Electromagnetic environment - guidance 
RF emissions 
CISPR 11 
Group 1 The Cardiocap/5 uses RF energy only for its...

Functional Check Form 
Table 2. Guidance and manufacturer’s declaration – electromagnetic immunity 
Guidance and manufacturer’s declaration – electromagnetic immunity 
The Cardiocap/5 is intended for use in the electromagnetic environment specified below. The 
customer or the user of the Cardiocap/5 should assure that it is used in such an environment. 
Immunity test IEC 60601 test 
level 
Compliance level Electromagnetic environment - 
guidance 
Electrostatic 
discharge (ESD) 
IEC 61000-4-2 
±6 kV...

EMC Guidance 
Table 3. Guidance and manufacturer’s declaration – electromagnetic immunity 
Guidance and manufacturer’s declaration – electromagnetic immunity 
The Cardiocap/5 is intended for use in the electromagnetic environment specified below. The customer or the user 
of the Cardiocap/5 should assure that it is used in such an environment. 
Immunity test IEC 60601 test 
level 
Compliance 
level 
Electromagnetic environment - guidance 
   Portable and mobile RF communications equipment 
should be...

Functional Check Form 
Table 4. Recommended separation distances between portable and mobile RF communications 
equipment and the Cardiocap/5. 
Recommended separation distances between portable and mobile RF communications 
equipment and the Cardiocap/5. 
The Cardiocap/5 is intended for use in an electromagnetic environment in which radiated RF 
disturbances are controlled. The customer or the user of the Cardiocap/5 can help prevent 
electromagnetic interference by maintaining a minimum distance...

Contents 
Chapter 3. Planned Maintenance  
3.1 Introduction ........................................................................\
. 3-1 
3.1.1 Using the Planned Maintenance Form .......................................................... 3-1 
3.1.2 Recommended parts........................................................................\
........... 3-1 
3.1.3 Recommended tools and accessories .......................................................... 3-2 
3.2 Planned maintenance...

Planned Maintenance 
3. PLANNED MAINTENANCE 
3.1 Introduction 
These instructions include procedures for planned maintenance (PM) of the Datex-Ohmeda 
Cardiocap/5 monitor. Performance of planned maintenance procedures is recommended once each 
year after installation of the monitor.  
These instructions are for the maximum functional configuration of the monitor. Perform the 
procedures in order and skip items that do not correspond with the configuration of your monitor. 
Complete instructions on how...

Cardiocap/5 Technical Reference Manual 
3.1.3 Recommended tools and accessories 
Tool Order Number 
Patient simulator for ECG, Impedance Respiration, and BP Obtain locally 
Pressure manometer Obtain locally 
Temperature test set 884515 
5-lead ECG cable Obtain locally 
SpO2 finger sensor (compatible with the installed pulse oximetry) Obtain locally 
InvBP transducer Obtain locally 
Adult NIBP cuff 572435 
Adult NIBP hose 877235 
Infant NIBP cuff 877407 
Infant NIBP hose 877514 
Flowmeter Obtain locally...