Epson Aculaser M 2000 Service Manual

EPSON AcuLaser C9200NRevision D
DISASSEMBLY AND ASSEMBLY      Main Unit Disassembly/Reassembly 291
Confidential4.3.17  
Group 17
CONTENT
DISASSEMBLY FLOWCHART
Parts/Units to be Disassembled
Guide
Vertical Transport DoorSeparation Roller Installation Plate AssyFeed Roller (Optional Cassette Unit)Separation Roller (Optional Cassette Unit)
ABCD
Vertical Transport Door
A
Separation Roller Installation Plate Assy
B
Feed Roller
C
Separation Roller
D
B1
A1
D1
C1
B2D2
C2
C3
D3D4
Start
Separation Roller...

EPSON AcuLaser C9200NRevision D
DISASSEMBLY AND ASSEMBLY      Main Unit Disassembly/Reassembly 292
Confidential
Vertical Transport Door
1. Slide out the paper cassette.
2. Open the Vertical Transport Door.
3. Remove two Claws [1], and remove the Vertical Transport Door [2].
A1
B1
C1
D1
4039F2C048DA
[1] [2]
Separation Roller Installation Plate Assy
1. Remove two Screws [1], and remove the jam processing cover [2].
Make sure the position of the polyester film when installing the jam processing cover.
B2...

EPSON AcuLaser C9200NRevision D
DISASSEMBLY AND ASSEMBLY      Main Unit Disassembly/Reassembly 293
Confidential2. Remove two Screws [3] and the Separation Roller Installation Plate Assy [4].
4038F2C013DA
[3]
[9][4]
Separation Roller (Optional Cassette Unit)
1. Remove two C-rings [1] and the shaft [2], and remove the separation roller fixing plate assy 
[3].
Use care not to miss the spring [4].
2. Remove the C-ring [5] and guide [6], and remove the Separation Roller [7].C3
4038F2C508DA
[3]
[2]...

EPSON AcuLaser C9200NRevision D
DISASSEMBLY AND ASSEMBLY      Main Unit Disassembly/Reassembly 294
Confidential
Right Rear Cover
1. Remove two Screws [1] and remove the Right Rear Cover [2].
D3
4039F2C050DA
[1][2]
Feed Roller (Optional Paper Cassette)

	

The separation roller should be replaced, whenever the pickup roller is replaced.
1. Disconnect the Connector [1].
2. Remove the Screw [2] and remove the Reinforcement plate [3].
D4
4067F2C501DA4039F2C051DA
[1]
[3]
[2] 

EPSON AcuLaser C9200NRevision D
DISASSEMBLY AND ASSEMBLY      Main Unit Disassembly/Reassembly 295
Confidential3. Remove four Screws [4] and remove the pickup roller assy [5].
4. Remove two Screws [6] and the installation flame [7] of the separation roller installation 
plate assy.
4067F2C502DA4067F2C503DA
[4][5]
[4]
[6]
[7] [6]
5. Remove two Screws [8] and pickup roller cover 9].
6. Remove two C-rings [10] and two bushings [11], and remove the pickup roller assy [12].
7. Snap off the C-ring [13], and...

EPSON AcuLaser C9200NRevision D
DISASSEMBLY AND ASSEMBLY      Main Unit Disassembly/Reassembly 296
Confidential8. Remove the C-ring [15] and bushing [16].
9. Remove the C-ring [18] and gear [19] while sliding out the shaft assy [17] in the direction 
indicated in the figure above.
4067F2C505DA
[16]
[15]
[17]
[19]
[18]
10.Remove the C-ring [20] and bushing [21], and remove the shaft assy [22].
11.Remove two E-rings [23] and bushing [24], and remove the pickup roller fixing plate assy 
[25].
12.Remove the...

EPSON AcuLaser C9200NRevision D
DISASSEMBLY AND ASSEMBLY      Others 297
Confidential4.4  OthersThe specific disassembling and assembling procedures are not explained, and 
only points in work are shown.
[1]COOLING FAN MOTOR/2 (M22)
[1]
Cooling Fan Motor/2 (M22)p.297 
[2]
Cooling Fan Motor/1 (M12)p.298 
[3]
Ozone Ventilation Fan Motor (M14)p.298 
[4]
Power Supply Cooling Fan Motor/1 (M8)p.298 
[5]
Fusing Cooling Fan Motor/2 (M11)p.299 
4039F5C502DA
[4]
[1]
[2]
[3][5]
Cooling Fan Motor/2 (M22) Rear...

EPSON AcuLaser C9200NRevision D
DISASSEMBLY AND ASSEMBLY      Others 298
Confidential[2]COOLING FAN MOTOR/1 (M12)[3]OZONE VENTILATION FAN MOTOR (M14)
[4]POWER SUPPLY COOLING FAN MOTOR/1 (M8)
Cooling Fan Motor/1 (M12)Rear Right Connector
Screw
Turn the side that the label 
is attached on to the front.
Ozone Ventilation Fan Motor (M14)Rear Right Connector
Screw
Turn the side that the label 
is attached on to the front.
Left Side Right
Power Supply Cooling Fan Motor/1 (M8)Connector
Screw
Turn the side that...

EPSON AcuLaser C9200NRevision D
DISASSEMBLY AND ASSEMBLY      Others 299
Confidential[5]FUSING COOLING FAN MOTOR/2 (M11)
Fusing Cooling Fan Motor/2 (M11)Top Right Connector
Screw
Turn the side that the label 
is attached on to the back. 

EPSON AcuLaser C9200NRevision D
DISASSEMBLY AND ASSEMBLY      Others 300
Confidential
[1]WASTE TONER FULL SENSOR (PC8)
[1]
Waste Toner Full Sensor (PC8)p.300 
[2]
Front Door Switch/2 (S4)p.301 
[3]
Front Door Switch/1 (S3)p.301 
[4]
Main Power Switch (S1)p.302 
[5]
Primary Interlock Switch (S2)p.302 
[6]
Right Door Switch (S5)p.303 
4039F5C503DA
[3] [1]
[2]
[4][5]
  [6]   
Waste Toner Full Sensor (PC8)
Rear Right
Connector