Digital Projection Titan Pro Series III User Guides

Digital Projection Titan Pro series III  A TOUR OF THE MENUS  Operating Guide
Page Op_21Rev A   May 2012
Information Menu
The sub-menus give information about lamp operating times, software and \
hardware configurations, the input source and Digital Projection.
Projector
Source
Digital Projection
Notes
 See also Using the Menus, earlier 
in this guide and Menu Map, later in 
this guide.
Main MenuInformationProjector
 The number of lamps is dependent 
on the projector model.
Main MenuInformationSource...

Digital Projection Titan Pro series III  MENU MAP  Operating Guide
Page Op_22Rev A   May 2012
Menu Map
Main Menu Sub Menus
Input Selection
CVBS 1, CVBS 2, S-Video, Component, VGA, 3G-SDI, DVI, HDMI, Test Pattern, Main/DVI, Sub/HDMI, Dual Pipe
Test Pattern
Grey V Bars, Grey H Bars, Aspect Test, Alignment Grid, Warp Adjust, SMPTE, Chequerboard, White Field, Black 
Field
Global Settings
Projector
Orientation  Desktop Front, Ceiling Front, Desktop, Rear, Ceiling Rear
Latency  Minimal, Best Video...

Digital Projection Titan Pro series III  MENU MAP  Operating Guide
Page Op_23Rev A   May 2012
Advanced Geometry
Mode  Off, Keystone, Cornerstone, Rotation, Warp
Warp Map  Off, 1 to 8
H Keystone
V Keystone
Pincushion/Barrel
Rotation
Cornerstone  Upper Left X, Y, Upper Right X, Y, etc
Input Configuration
DVI/HDMI   Boost DVI EQ, DVI/HDMI Colour Space, DVI/HDMI Range, DVI Port,  
Main/Sub Operation, Main/Sub Range
SDI  3G Level B Stream
Component  Colour Space, Sync Type
Lamp
Lamp Mode  Single lamp, Two...

Digital Projection Titan Pro series III  MENU MAP  Operating Guide
Page Op_24Rev A   May 2012
Input Settings
Picture
Brightness
Contrast
Hue
Saturation
Black Level Offset  0 IRE
Video Filters   Sharpness, Detail, Luma Sharpness, Chrome Sharpness, Recursive Noise Red\
uction, 
Mosquito Noise Reduction, Cross Colour Suppression
VGA  Phase, Total H Samples, Auto setup
Colour Trim
RGB Lift and Gain
Geometry
Aspect Ratio  Source, Fill, Fill & Crop, Anamorphic, TheatreScope
H Position
V Position
Overscan...

Digital Projection Titan Pro series III  WEB CONFIGURATION UTILITY  Operating Guide
Page Op_25Rev A   May 2012
Web Configuration Utility
The LAN IP Address of the projector can be set by using the Network submenu, which can 
be found in the Global Settings menu.
Once the LAN IP Address has been set, it is possible to control all the functions availa\
ble on 
the OSD by using the embedded Web Configuration Utility:
Point your browser at the projector by typing the url 
http:// into the address bar, then...

Digital Projection Titan Pro series III  WEB CONFIGURATION UTILITY  Operating Guide
Page Op_26Rev A   May 2012
Sliders are represented by similar 
sliders, as in the Array Width slider 
shown here.
Items that are not available are shown 
greyed-out, as in the Array H Position 
slider and Blending list shown here.
To return from a sub-menu to the 
previous menu, click on the Back link at 
the bottom of the menu.
•
•
•
Notes
 For full details of how to use the 
menu system, see earlier in this 
Guide....