Digital Projection Projector E-Vision 8000 Series User Manual

Digital Projection E-Vision 8000 Series  A TOUR OF THE MENUS Operating Guide
45
Notes
 See also Using the Menus, earlier 
in this guide and Menu Map, later in 
this guide.
 Eco Network Power must be set to 
Standard, if you wish to control the 
projector via the LAN connection.
CONTROL menu
Eco Network Power
• Set this to Standard or Eco as required. In Eco mode, the LAN power supply is switched 
off.
Auto Power Off
• Set this to On, if you want the projector to go into Standby mode when no input source...

Digital Projection E-Vision 8000 Series  A TOUR OF THE MENUS Operating Guide
46
Notes
 See also Using the Menus, earlier 
in this guide and Menu Map, later in 
this guide.
 Eco Network Power must be set to 
Standard, if you wish to control the 
projector via the LAN connection.
 To change any of the network 
settings, use the embedded LAN 
IP Configuration Utility (see the 
Remote Communications Guide).
Projector Control
• Set this to Network or RS232 as required.
Network submenu
• Press ENTER to open...

Digital Projection E-Vision 8000 Series  A TOUR OF THE MENUS Operating Guide
47
Startup Logo
• Set this to On if you want the DP logo to show when the projector is first switched on.
Trigger
• Set this to Auto if you want the Trigger output to be activated when the projector is first 
switched on.
• Set this to one of the Aspect Ratio settings, if you want the Trigger output to be 
activated when the projector is switched to that aspect ratio.
Auto Search
• When this is set to On, the projector will...

Digital Projection E-Vision 8000 Series  A TOUR OF THE MENUS Operating Guide
48
SERVICE menu
Information
• The first part of the menu is for information only.
Blue Only
• Set this to On or Off as required.
Factor y Reset
• Projector will ask for confirmation before restoring all settings to factory defaults.
• When the confirmation box appears, use  or to move the blue highlight to OK 
or Cancel, then press ENTER to confirm your selection.
Notes
 See also Using the Menus, earlier 
in this guide and Menu...

Digital Projection E-Vision 8000 Series  MENU MAP Operating Guide
49
Menu Map
Menu Submenus and Controls
INPUT
Input Selection  HDMI, DVI, VGA, Component/BNC, Composite, S-Video, 3G-SDI, Option Board
PIP
PIP Option  Off, On
PIP Input  Select from group B or group A
Position  Top Left, Top Right, Bottom Left, Bottom Right, Split L-R
Test Pattern  Off, Color Bars, Alignment Grid, Burst, Red, Green, Blue, White, Black, Cross Mark, Cross\
 Hatch + 
Mark, Corrected Red, Corrected Green, Corrected Blue,...

Digital Projection E-Vision 8000 Series  MENU MAP Operating Guide
50
LAMPS
Mode  Dual, Single
Power  Normal, Custom Power, Eco
High Altitude  Off, On
Custom Power Level 80-100%
Lamp Status  Information Only: Lamp 1 On, Off     Lamp 2 On, Off
 ALIGNMENT
Projection Mode  Front, Rear, Ceiling + Front, Ceiling + Rear
Fan Mode  Normal, Up, Down
Lens Control  Shift, Zoom/Focus
Lens Memory 
Load Memory  Memory 1-10
Save Memory  Memory 1-10
Center Lens  Press ENTER to execute
Warp
Keystone  Horizontal, Vertical...

Digital Projection E-Vision 8000 Series  MENU MAP Operating Guide
51
CONTROL
Eco Network Power   Standard, Eco
Auto Power Off   On, Off
Auto Power On   On, Off
Projector Control   RS232, Network
Network   Information only: IP Address, Subnet Mask, Gateway, DHCP
Startup Logo   On, Off
Trigger   Auto, 5:4, 4:3, 16:10, 16:9, 1.88, 2.35, Letterbox, Native, Unscaled
Auto Search   On, Off
Dynamic Black   On, Off
Language   Select from list
SERVICE
Information only:  Model, Serial Number, Software Version,...

52 
Rev F July 2014
Digital Projection E-Vision 8000 Series   Operating Guide
This page is intentionally left blank.  

E-Vision 8000 Series
High Brightness Digital Video Projector
REMOTE COMMUNICATIONS GUIDE
Rev F July 2014  

Digital Projection E-Vision 8000 Series  IN THIS GUIDE Remote Communications Guide
IN THIS GUIDE
Introduction ........................................................................\
................................55
Operation commands ...............................................................................................55
Key commands ..........................................................................................................55
The Operation Commands...