Digital Projection M-vision Cine 400 3d Series User Guides

Digital Projection M-Vision Cine 400 3D seriesOPERATING THE PROJECTORInstallation and Quick-Start Guide
Revision A, May 2012 
Operating the projector
Switching the projector on
1. Connect the power cable between the mains supply and the projector. The projector begins a self-test.
2. When the self-test has completed, the power indicator on the projector control panel shows blue to indicate that the\
 projector is in 
STANDBY mode and the lamp is switched off. Press and hold for three seconds either of...

Digital Projection M-Vision Cine 400 3D seriesOPERATING THE PROJECTORInstallation and Quick-Start Guide
Revision A, May 2012 
Adjusting the lens
Zoom
Turn the smooth ring on the lens, closest to the case, to adjust the zoom so that the image fills the screen.
Focus
Turn the knurled ring at the outer end of the lens, to adjust the focus u\
ntil the image is sharp.
Shift
1. To reveal the adjustment access holes, slide the Digital Projection badge\
 in the direction shown below, then gently lift it off by...

Digital Projection M-Vision Cine 400 3D seriesOPERATING THE PROJECTORInstallation and Quick-Start Guide
Revision A, May 2012 
Selecting an input signal or test pattern
Input signal
Connect an image source to the projector. The signal should be automatically detected by the projector, and should be displayed within 
two or three seconds.
If more than one signal is connected, select the image you want to displ\
ay in one of the following ways:
 ●Access the Main menu (either from the remote control or from...

Digital Projection M-Vision Cine 400 3D seriesOPERATING THE PROJECTORInstallation and Quick-Start Guide
Revision A, May 2012 
Adjusting the image
Orientation
To change the image orientation, access the System menu and then open the Rear Projection and Ceiling Mode settings.
Aspect ratio
To set up an aspect ratio for your image, do either of the following:
 ●Press the ASPECT RATIO button on the remote control to cycle through the available settings.
 ●Access the Main menu and then select the Aspect Ratio...

M-Vision Cine 400 3D series
High Brightness Digital Video Projector
16:9 widescreen display
Revision A, May 2012 112-855A
CONNECTION GUIDE 

Digital Projection M-Vision Cine 400 3D series Connection Guide
Revision A, May 2012 
CONTENTS
Important information ............................................................Con-01
Symbols used in this guide ........................................................................\
.....Con-01
Special formatting ........................................................................\
....................Con-01
Product revision ........................................................................\...

Digital Projection M-Vision Cine 400 3D seriesIMPORTANT INFORMATIONConnection Guide
Revision A, May 2012 Con-01
Important information
Symbols used in this guide
Many pages in this document have a dedicated area for notes. The information in that area is accompanied by the following symbols:
FURTHER INFORMATION
This symbol shows important additional information.
Special formatting
 ●Buttons on the projector control panel or the remote control appear in BLOCK CAPITALS, e.g. MENU. Where necessary, the name...

Digital Projection M-Vision Cine 400 3D seriesSIGNAL INPUTSConnection Guide
Revision A, May 2012 
Signal inputs
Component 1 and 2
RGsB
In the Advanced Image menu, set Colorspace to Auto, or if necessary to 
RGB Video.
YPbPr/YCbCr
In the Advanced Image menu, set Colorspace to Auto, or if necessary to 
REC709 or REC601.
RGB
In the Advanced Image menu, set Colorspace to Auto, or if necessary to 
RGB PC.
HDMI 1 and 2
If you are using a Dual Pipe 3D signal, connect the left signal to one input 
and the right...

Digital Projection M-Vision Cine 400 3D seriesSUPPORTED SIGNAL INPUT MODESConnection Guide
Revision A, May 2012 
Supported signal input modes
SignalResolutionFrame Rate 
(Hz)
3D Support
ComponentVGA RGBHVVGA YUVHDMI RGBHDMI YUV 8 bitHDMI YUV 10 bitHDMI YUV 12 bit
Frame PackingSide by Side (Horizontal)Top and Bottom
PC
640 x 48059.94
640 x 48074.99
640 x 48085
800 x 60060.32
800 x 60075
800 x 60085.06
848 x 48047.95
848 x 48059.94
1024 x 76860
1024 x 76875.03
1024 x 76885.03
1024 x...

Digital Projection M-Vision Cine 400 3D seriesSUPPORTED SIGNAL INPUT MODESConnection Guide
Revision A, May 2012 
SignalResolutionFrame Rate 
(Hz)
3D Support
ComponentVGA RGBHVVGA YUVHDMI RGBHDMI YUV 8 bitHDMI YUV 10 bitHDMI YUV 12 bit
Frame PackingSide by Side (Horizontal)Top and Bottom
PC (continued)
1440 x 90075
1400 x 105060
1400 x 105075
1600 x 120060
1920 x 108047.95
1600 x 120060
1920 x 120060
1680 x 105059.94
Apple Mac
640 x 48066.59
832 x 62474.54
480i59.94
576i50...