Dell Projector S320/S320wi User Manual

							    
   
   
 
  
 
 
 
 
     
 
 
   
2 Left  This button acts like the left click button of a 
mouse. 
3  Function  Functions available are listed in the OSD Menu 
"Set function" (see page 70). 
NOTE: Double-clicking the Function button 
will act as Undo, if supported by the 
software. 
4  Mini USB charge 
connector  Allow you use Mini USB cable to charge. See 
"Charging the Interactive Pen Battery" on page 
44. 
5  LED indicators  Two LED indicators are available: Green and 
Amber (see "Interacti ve Pen LED Guiding 
Signals" on page 133). 
6  Right  This button acts like the right-click button of a 
mouse. 
7  Power switch  Turns the Interactive Pen on or off. 
8  Firmw are up grade 
connector  For Interactive Pen and RF board firmware 
upgrade. 
OSD warning messages - low battery 
• 
The Low Battery warning message pops  up when the battery voltage is 
lower than 2 V. At this condition, the pen can still work about 1~2 hours. 
•  The pen will be disabled when the  battery voltage is lower than 1.8 V. 
Combinations of buttons 
• Left + Function:  The Pen Information menu appears on the screen. 
•	  Hold Function:  Hold the Function button for 2 seconds and the 
Function mean will appear on the screen. Use Left/Right to move 
up/down and use Function to enter/apply. 
•  When Toggle is selected in the Set Function menu, press the Function 
button to select Normal/Draw/Stable mode. 
NOTE: Interactive pen cannot support Wi ndows Mouse property function 
"Switch primary and secondary buttons". 
Using Your Projector 41 
Downloaded From projector-manual.com DELL Manuals 
						

							 
 
   
Using the Wrist Strap 
Please use the wrist strap as a safety prec aution in case of loss of grip on the 
Interactive Pen, and prevent damage to the Interactive Pen, surrounding objects, 
or injury to other people. 
1 Feed the cord on the wrist strap through the connector holder. 
2 Wear the wrist strap on your wrist. 
Using Your Projector 
42 
Downloaded From projector-manual.com DELL Manuals 
						

							  
   
Installing the Remote Control Batteries
 
NOTE: Remove the batteries from the remote control when not in use. 
1 Press the tab to lift the battery compartment cover. 1 
2 Check the polarity (+/-) marking on the batteries. 
3 Insert the batteries and alig n their polarity correctly 
according to the marking in the battery compartment. 
NOTE: Avoid mixing different types  of batteries or using 
new and old batteries together. 
4 Slip the battery cover back. 
AAAAAA 
2 
AAAAAA 
3 
4 
Using Your Projector  43 
Downloaded From projector-manual.com DELL Manuals 
						

							  
 
   
 
 
 
 
 
   
 
Charging the Interactive Pen Battery
 
When the Interactive Pen amber battery light starts to blink, its internal battery is 
low (If the battery is fully discharged, you will not be able to turn the Interactive 
Pen on by pressing its nib, left, right or set function buttons). 
To charge the battery, connect a mini US B cable between the Interactive Pen and 
your computer or laptop (If connecting  to computer or laptop, make sure the 
computer or laptop is powered on). The battery light will stay on while the battery 
is charging and turn off when the battery is fully charged. 
MOLEX 
When charging is finished, you can unplug the mini USB cable (or keep the cable 
connected and use the Interactive Pen while it's charging). 
NOTE: For first time use, it takes at leas t 4-5 hours to fully charge the battery. A 
fully charged battery will allow 25 hours  of non-stop use or up to 4 weeks in 
standby. 
CAUTION: The lithium battery is only rechar geable and is not user replaceable 
or serviceable. If your Interact ive Pen cannot charge, contact Dell (See 
"Contacting Dell" on page 144). 
CAUTION: Always use the included mini US B cable and your computer (or use 
the Docking Charger) to charge the Intera ctive Pen. The Docking Charger is not 
shipped with your projector. You can  purchase it on the Dell website at 
www.dell.com. 
Using Your Projector 
44 
Downloaded From projector-manual.com DELL Manuals 
						

							  
 
 
  
Docking Charger Intr oduction (Optional)
 
Front View 
Back View 
1 
2 
3 
4 
1 Power LED light 
2  Mini USB connector 
3  Po w e r  s w i t c h 
4  Po w e r  c o rd c o n ne c t or 
NOTE: The Docking Charger is not shipped wit h your S320 or S320wi projector. 
You can purchase the Docking Charger on the Dell website at  www.dell.com. 
LED Indicator on Docking Charger 
Green LED Solid 
On  When the docking charger is switched on, the Green LED 
will turn solid ON. 
Green LED Off  The Green LED will turn  Off when the docking charger is 
switched off. 
Using Your Projector 45 
Downloaded From projector-manual.com DELL Manuals 
						

							   
 
 
   
LED Indicator on Interactive Pen 
Amber LED Solid 
On The Amber LED will turn soli
d ON during the charge 
process. 
Amber LED Off  Once battery is fully charged, the LED will turn OFF 
indicating "Charge Complete". 
Amber LED 
Flashing  If the Amber LED starts FLAS
HING (0.4 sec ON, 0.6 sec 
OFF, 1 sec per flashing cycle), it indicates no charging takes 
place. Charger error or bad battery is identified. 
Docking Charger Specification (Power Supply) 
Model:  Interactive Projector Pen Charging Station 
Power Supply:  Input AC 100-240 V, 50-60 Hz, 0.2 A 
Output DC 5 V/1 A 
Maximum temperature:  40 ºC 
Using Your Projector 
46 
Downloaded From projector-manual.com DELL Manuals 
						

							      
 
Charging the Interactive Pen Battery by 
Docking Charger 
When the Interactive Pen amber battery light starts to blink, its internal battery is 

low (If the battery is fully discharged, you won't be able to turn the Interactive Pen 

on by pressing its nib, left,  right or set function buttons).
 
To charge the battery, you can follow the following steps:
 
1 Connect the power cable to the wall outlet. 
2 Plug the Interactive Pen into the Mini USB port of the docking charger. 
3 Turn On the power switch on the docking charger. 
Using Your Projector  47 
Downloaded From projector-manual.com DELL Manuals 
						

							  
 
 
 
   
 
NOTE: During the charging process, Interactive Pen amber battery light will be 
lit all the time until the charging process is complete. 
NOTE: For first time use, it takes at leas t 4-5 hours to fully charge the battery. A 
fully charged battery will allow up to 25 hours of non-stop use or up to 4 weeks 
in standby. 
CAUTION: If your docking charger cannot charge, contact DELL. 
Using Your Projector 
48 
Downloaded From projector-manual.com DELL Manuals 
						

							    
 
Using Your Projector 49
Operating Range with Remote Control
NOTE:Actual operating range may slightly  differ from the diagram. Weak 
batteries will also prevent the remote  control from properly operating the
projector.
Angle
Distance
Distance
Angle
Operating range
Angle ±20° 
Distance 7 m/22.97 feet
ZOOM
ZOOM
INFO
VIDEO
VGA
S-VIDEO
FREEZE
AUTO ADJ.
KEYSTONE
SOURCE
VIDEO MODEASPECT
MENU POWER
MOUSE
BLANK
ENTER
VOL
VOL
MUTE
TM
ZOOM
ZOOM
INFO
VIDEO
VGA
S-VIDEO
FREEZE
AUTO ADJ.
KEYSTONE
SOURCE
VIDEO MODEASPECT
MENU POWER
MOUSE
BLANK
ENTERVOL
VOL
MUTE
TM
Downloaded From projector-manual.com DELL Manuals 
						

							  
 
 
Operating Range with Interactive Pen 

Angle 
Operating range DistanceAngle Distance 
0° 
20° 45° 
9 m/29.53 feet 
7 m/22.97 feet  5 m/16.4 feet 
Distance 
Angle 
NOTE: 
•  Projector is at 2000 lm brightness, with 100 inches image size, and in 
Bright mode. 
•  Can support multiple pens (up to 10 pens) connecting to one projector 
but the pens cannot be used simultaneously. 
•  Actual operating range may slightly differ from the diagram. 
•  The projector brightness decay will affect the operating range of the pen. 
Using Your Projector 
50 
Downloaded From projector-manual.com DELL Manuals