Comdial ExecuTech Model XE Key System Instructions Manual

IMI 66-064 System Operation 
SECTION 2 
ATTENDANT STATION OPERATION 
The attendant station provides additional operating fea- 
tures that are not available from other stations in the 
system. l Press Al (top, left-hand softke ) to toggle feature on i 
and off. Associated light wil Y turn on when night 
transfer is active and turn off when it is inactive. 
SYSTEM SPEED DIAL PROGRAMMING 
A special system-wide list of numbers can be 
programmed for automatic dialing by all users. 
l Press SPKR. 
MUSIC ON...

IhA 66-064 
Svstem ODeration 
TELEPHONE LINE 
. DIRECT STATION SELECTION (DSS) l INTERCOM CALLING BETWEEN STATIONS WITH CALLED STATION STATUS (ELF) l AUTO DIALING OF STORED NUMBERS OF 
MUTE KEY -bt il = 
l FEATURE CODE ACCESS iWHEN STORED1 
, DSS KEY/AUTO DIAL LOCATIONS 1-6 (HOLD KEY PLUS AUTO DIAL KEY FOR AUTO DIAL 
LOCATIONS WHEN DSS/BLF IS ALSO PROGRAMMED) 
-DSS h- KEY/AUTO DIAL LOCATIONS 7-12 . MUTES SPEAKERPHONE 
OR HANDSET 
I (HOLD KEY PLUS AUTO DIAL KEY FOR AUTO DIAL 
LOCATIONS WHEN DSSIBLF IS...

IMI 66-064 System OperaticA 
,,. 
SECTION 3 
SYSTEM OPERATING CHARACTERISTICS 
FEATURE DIALING CODE NUMBERING PLAN 
To program: ITCM, t % 1, SOFTKEY, #, SPKR 
Do Not Disturb 
Handsfree Answer Inhibit 
Message Waiting 
Cancel On Line 
Retrieve Message ITCM +++ 3 + Ext No. 
lTCM # 3 + Ext. No. 
lTCM HOLD 
Pulse/Tone Switching 
Speed Dial 
Redial (Last number dialed) 
Voice Announce Block 
Zone Page I Set Tone 4 
ITCM S +f 44 
# 
Station 1 - 0 (HOLD 1 - 0 when on line) 
System 01 - 30 (HOLD 01 - 30 when on...

liAl66-064 System Operation 
RINGER VOLUME CONTROL 
The station ringer volume control is located on the front 
edge of the telephone. Adjust the control lever to OFF, 
LOW or HIGH volume as desired. 
STATUS INDICATORS AND TONE SEQUENCES 
The following pages describe the light and ring patterns 
associated with system operation. The values shown 
are typical and are provided for illustration only. 
5-9  

Y 
c 
.RINGING PATTERN’S 
%O/PBX Line Ring Host system ring cadence RING CADENCE DEPENDENT UPON HOST SYSTEM 
Intercom Tone Signalling 
Two 140 msec. tone bursts 
sounded every four seconds 
Voice Signalling alert One 210 msec. tone burst 
. 
Timed hold recall at Three 140 msec. tone bursts 
station that put call 
sounded at the end of each 
on hold 
timeout period 
I-LnlL J-u-u-, -l-wL  

INTERCOM CALL PROGRESS TONES 
(Heard through handset receiver or over monitor speaker) 
Dial Tone 
3ase Level Tone  7 
E 
F 
C 
L Continuous on 
-I 
Called station ring-back 560 msec. tone burst 
sounded twice every 4 sec. 
Called station busy 
on outside line 
Base level 
program entry 
‘rogramming 
xxfirmation 70 msec. tone burst 
sounded once 
System speed dial 
entry confirmation 
Memory dial intercom, 
line, group and/or recall 
selection confirmed 
All-call page 
selection confirmed 
PA station...

Error tone - 560 msec. tone burst 
incorrect entry 
sounded three times 
uu 
Busy tone - intercom 560 msec. tone bursts 
1 u Ll u 
U U L 
Called station in do-not- 140 msec.tone burst 
disturb mode 
sounded twice every sec. 
Fasy busy tone 
System isawaiting 70 msec. tone bursts sounded 
memory dial number 
continuously 
or key mapping entry 
after location is specified 
,.  

lh66-064 System Operation 
5-13  

Exclusive hold 
Steady on 
Held call timeout your 
station 
Held call timeout other 
station Flutter with repeative off periods 
(flutter rate - 560 msec. off) 
Continuous flutter 
(70 msec. on - 70 msec. off) 
/lESSAGE WAITING LIGHT 
Message Waiting 
Continuous flash (560 msec. on 
- 560 msec. off)  

Y 
d 
INTERCOM LIGHT 
In use-your station Steady on with wink off 
(2.3 sec. on - 70 msec. off) 
All links busy Steady on 
Auto redial active Continuous flutter 
(70 msec. on - 70 msec. off) 
Night mode - Station 10 Flutter with repeative off periods 
(flutter rate - 560 msec. off)