Cisco D9854i Manual
Have a look at the manual Cisco D9854i Manual online for free. It’s possible to download the document as PDF or print. UserManuals.tech offer 53 Cisco manuals and user’s guides for free. Share the user manual or guide on Facebook, Twitter or Google+.
L-Band Input and Processing 78-4021470-01 Rev J 277 LNB Power and Control Parameter Specification Voltage (RF1to RF3, RF4 does not have an LNB supply) 13 V Vertical/circular right, 18 V Horizontal/circular left Off Current 350 mA maximum LNB Alarms: No load - 6 mA Overload - 360 mA minimum DVB-S/DVB-S2 DVB-S/DVB-S2 Satellite Receiver Parameter Specification L-Band Input Number of Inputs 4 (one active at a time) Input Connector Type F-type, female, 75 ohms Input Impedance 75 ohms Return Loss > 10 dB Isolation Between Inputs > 40 dB L-band Frequency 950 to 2150 MHz Tuning Step Size 1 MHz Receive Spectrum Sense Normal and Inverted L-Band Power Input Power Level per Carrier -25 to -65 dBm (full transponder power) DVB-S Modulation (EN 300 421) Modulation QPSK Convolutional FEC Rates 1/2, 2/3, 3/4, 5/6, 7/8 Symbol Rate Range 1.0 to 45 MSymbols/s
Appendix A Technical Specifications 278 78-4021470-01 Rev J Parameter Specification Eb/No (C/N) Ratio See DVB-S2 Satellite Receiver Input, DVB-S Eb/No (C/N) Ratio Table DVB-S2 Modulation (EN 302 307) Modulation QPSK, 8PSK Pilots On/Off Pilots On QPSK LDPC FEC Rates 1/2, 3/5, 2/3, 3/4, 4/5, 5/6, 8/9, 9/10 8PSK LDPC FEC Rates 3/5, 2/3, 3/4, 5/6, 8/9, 9/10 LDPC FEC Frame Length Normal Symbol Rate Range 1 to 30 Ms/s Maximum Channel Bit Rate 90 Mb/s Maximum User Bit Rate 78.55 Mb/s DVB-S Eb/No (C/N) Ratio Convolutional FEC Rate Eb/No Ratio (dB) in Linear Channel and IF Loop configuration C/N at DVB Threshold (BW = Symbol Rate) 1/2 4.5 4.1 2/3 5.0 5.9 3/4 5.5 6.9 5/6 6.0 7.9 7/8 6.4 8.5 C/N = Eb/No + 10 log (2 x FEC X 188/204) The D9854 receiver displays the C/N Ratio. DVB-S2 Error Rate Performance Es/No (C/N) Ratio Mode Simulated Es/No (dB) for FEC Frame length = 64,800 Typical Performance (dB) in Linear Channel and IF Loop configuration QPSK 1/2 1.00 1.2 QPSK 3/5 2.23 2.4 QPSK 2/3 3.10 3.2 QPSK 3/4 4.03 4.2
L-Band Input and Processing 78-4021470-01 Rev J 279 Mode Simulated Es/No (dB) for FEC Frame length = 64,800 Typical Performance (dB) in Linear Channel and IF Loop configuration QPSK 4/5 4.68 4.8 QPSK 5/6 5.18 5.3 QPSK 8/9 6.20 6.4 QPSK 9/10 6.42 6.6 8PSK 3/5 5.50 5.8 8PSK 2/3 6.62 6.8 8PSK 3/4 7.91 8.1 8PSK 5/6 9.35 9.6 8PSK 8/9 10.69 10.9 8PSK 9/10 10.98 11.3
Appendix A Technical Specifications 280 78-4021470-01 Rev J Video Inputs/Outputs and Processing General Parameter Specification System MPEG-2/DVB Compatible EN 300 421, EN 300 468 Video Outputs Analog SD Video Output Item Test Signal Specification CVBS1 Specification CVBS2 Number of Channels One SD source program One SD source program Video Decompression MPEG-2 4:2:0 MPEG-2 4:2:0 Output Impedance 75 Ω 75 Ω 525 Line Bar level NTC-7 comp 700 mV ± 7 mV (± 1%) 700 mV ± 35 mV (± 5%) Line Time Distortion VITS17 ≤ 1% ≤ 1% Bar Tilt NTC-7 comp < 0.5% < 0.5% Sync Level NTC-7 comp 40 IRE ± 0.5 IRE 40 IRE ± 2.0 IRE DC Offset NTC-7 comp ± 100 mV ± 100 mV Chrominance- to-Luminance Gain Inequality NTC-7 comp 100 ± 5% 100 ± 5% Chrominance- to-Luminance Phase Inequality NTC-7 comp < 20 ns < 20 ns K factor K 2T NTC-7 comp < 1% < 1% Jitter < 5 ns < 5 ns
Video Inputs/Outputs and Processing 78-4021470-01 Rev J 281 Item Test Signal Specification CVBS1 Specification CVBS2 Frequency Response FCC multi-burst 0.5 MHz, 0 dB 1.25 MHz, 0 dB ± 0.2 dB 2 MHz, 0 dB ± 0.2 dB 3 MHz, 0 dB ± 0.3 dB 3.58 MHz, 0 dB ± 0.3 dB 4.1 MHz, 0 dB ± 0.3 dB 0.5 MHz, 0 dB 1.25 MHz, 0 dB ± 0.2 dB 2 MHz, 0 dB ± 0.2 dB 3 MHz, 0 dB ± 0.3 dB 3.58 MHz, 0 dB ± 0.3 dB 4.1 MHz, 0 dB ± 0.3 dB Differential Gain NTC-7 comp < 3.0% < 3.0% Differential Phase NTC-7 comp < 4° < 4° Luminance Non-linearity < 5% < 5% Line Time Distortion NTC-7 comp ≤ 1% ≤ 1% Weighted Signal Video-to-Noise 50% Grey Field ≤ -70 dB rms ≤ -70 dB rms Weighted Signal Video-to-Noise Luminanace Ramp ≤ -55 dB rms ≤ -55 dB rms Return Loss DC to 10 MHz, > 30 dB DC to 10 MHz, > 30 dB 625 Line Bar level VITS17 700 mV ± 7 mV (± 1%) 700 mV ± 35 mV (± 5%) Line Time Distortion VITS17 ≤ 1% ≤ 1% Bar Tilt VITS17 < 0.5% < 0.5% Sync Level VITS17 300 mV ± 3 mV 300 mV ± 15 mV DC Offset VITS17 ± 100 mV ± 100 mV Chrominance- to-Luminance Gain Inequality Colour Bars 100 ± 5% 100 ± 5% Chrominance- to-Luminance Phase Inequality Colour Bars < 20 ns < 20 ns K factor K 2T VITS17 < 1% < 1% Jitter < 5 ns < 5 ns
Appendix A Technical Specifications 282 78-4021470-01 Rev J Item Test Signal Specification CVBS1 Specification CVBS2 Frequency Response VITS18 0.5 MHz, 0 dB 1 MHz, 0 dB ± 0.2 dB 2 MHz, 0 dB ± 0.3 dB 4 MHz, 0 dB ± 0.3 dB 4.8 MHz, +0 dB, -0.5 dB 0.5 MHz, 0 dB 1 MHz, 0 dB ± 0.2 dB 2 MHz, 0 dB ± 0.2 dB 4 MHz, 0 dB ± 0.3 dB 4.8 MHz, +0 dB, -0.5 dB Differential Gain VITS330 < 3.0% < 3.0% Differential Phase VITS330 < 3° < 3° Luminance Non-linearity VITS17 < 5% < 5% Weighted Signal Video-to-Noise 50% Grey Field ≤ -70 dB rms ≤ -70 dB rms Weighted Signal Video-to-Noise Luminanace Ramp ≤ -55 dB rms ≤ -55 dB rms Return Loss DC to 10 MHz, > 30 dB DC to 10 MHz, > 30 dB Analog SD Video Output, CVBS1 and CVBS2 for monitoring Item Specification Number of Channels One down-converted source HD program Video Decompression Type MPEG-2 4:2:0 Output Level 1.0 Vpp ± 5% Output Impedance 75 ohms HD Component Video Output (Monitoring Output) Item Test Signal Typical Performance Values Y Pb, Pr Amplitude 100% Color Bars 700 mV ± 5% 700 mV ± 5% Sync Amplitude 100% Color Bars 300 mV ± 5% 300 mV ± 5% Bandwidth Multi-burst DC to 30 MHz, ± 0.6 dB DC to 15 MHz, ± 0.6 dB Noise, Unified Weighting Flat Field -70 dB -70 dB
Video Inputs/Outputs and Processing 78-4021470-01 Rev J 283 Linearity 5-step 3% 3% Interchannel Delay 100% Color Bars 2 ns 2 ns DC Offset ± 50 mV ± 50 mV Return Loss DC to 30 MHz, -20 dB DC to 30 MHz, -20 dB Aspect Ratio Item Specification Aspect Ratio Conversions for Down- Conversion Aspect Ratio Conversions for SD Programs 4:3 16:9 4:3 16:9 16:9 Letterbox 14:9 Letterbox Center Center Cutout 16:9 Letterbox 14:9 Letterbox Center Cutout Scale to 16:9 Embedded Data in SDI VBI Processing Item Specification Closed Captioning Output formats SMPTE-334M embedded in HD-SDI Embedded Audio Item Specification Format According to SMPTE-299M Audio sampling frequency 48 kHz locked to the video. According to SMPTE-272M Resolution 20 bits
Appendix A Technical Specifications 284 78-4021470-01 Rev J Audio Outputs Analog Audio Outputs Item Specification Number of Channels 2 stereo pairs/4 mono channels, 5.1 channel downmix Audio decompression: MPEG or Dolby Digital. HE-AAC single stereo pair or Dolby Digital Plus single stereo pair available as future software download. Frequency Response ±0.5 dB, 20 Hz to 20 kHz (ref., 100 kilohms) Total Harmonic Distortion < 0.3% at 1 kHz (ref. 100 kilohms) Dynamic Range 85 dB (CCIR/Arm weighting) Crosstalk 80 dB at 1 kHz (typical) Digital Audio Outputs Item Specification Number of Channels 2 (one stereo channel each) Format AES-3id Connector BNC Conditional Access Item Specification PowerVu CA DES or DVB DVB Scrambling BISS Mode 1, BISS Mode E DVB-CI (Future Use) Interface: 2 CI slots - EN 50221 CA Method: Multicrypt, Simulcrypt, Roscrypt (CI only supports one Roscrypt CAM at a time) CAS: Irdeto, Viaccess, Nagravision, Conax CAS: MediaGuard, Cryptoworks available in an anticipated future software release Note: Viasat (uses NDS/VideoGuard) only authorizes decoders equipped with an ASI output to receive/decrypt Viasat-encrypted programs.
Transport Stream Outputs 78-4021470-01 Rev J 285 Transport Stream Outputs ASI Output Item Specification Number of outputs 1 Type of connector 75 ohms BNC Output impedance 75 ohms according to EN 50083-9 Data amplitude 800 mV peak-peak ± 10% according to EN 50083- 9 Return loss >17 dB, 27 to 270 MHz Transport stream bit rate 1 to 120 Mbit/s ± 100 ppm ASI bit rate 200 Mbit/s ± 100 ppm Transport stream formats According to EN 50083-9 188 bytes structure 204 bytes without Reed Solomon Burst or packet format MPEGoIP Output (optional) Item Specification Number of outputs 1 Type of connector RJ-45, 10/100/1000 BASE-T Output modes UDP RAW, RTP IP Addressing Multicast TS Streaming MPTS TS Bit Rate 1 to 120 Mbps MPE Output Item Specification Number of Outputs 1
Appendix A Technical Specifications 286 78-4021470-01 Rev J Item Specification Type of connector RJ-45, 100/1000 BASE-T Output modes IPv4 datagrams IP Addressing Multicast TS Input up to 5 PIDs Bit Rate up to 10 Mbps (for 1500 byte packets)