Christie Projector Mirage WU-L User Manual

Mirage WU-L User Manual7-1020-100774-01 Rev. 2 (4-2012)
7 Specifications
7.1 Regulatory
7.1.1 Safety
Be aware of the caution label on the projector warning of
possible eye hazard if the projected visible and invisible LED
radiation light is viewed directly through certain optical
instruments at close range. The image below indicates where
the label is located.
  The projector is a class 2M source of visible and invisible LED radiation. 
Directly viewing the LED output with certain optical instruments...

7-2Mirage WU-L User Manual020-100774-01 Rev. 2 (4-2012)
Section 7: Specifications
7.1.3 Emissions
• FCC Code of Federal Regulations, Title 47, Part 15, Conducted and Radiated Emissions, Class A
• EN55022 (CISPR 22) for Information Technology Equipment, Conducted and Radiated, Class A 
• EN61000-3-2 Induced Harmonic Distortion
• EN61000-3-3 Induced Voltage Fluctuations (Flicker)
7.1.4 Electromagnetic Compatibility
• FCC CFR47, Part 15, Subpart B, Class A – Unintentional Radiators 
• CISPR 22: 2005...

Section 7: Specifications
Mirage WU-L User Manual7-3020-100774-01 Rev. 2 (4-2012)
• Color temperature
•  Factory default white color (K) 6500 ± 500
•  Image white color (K) 3200 - 9300
•  Range of adjustment (K) 3200 - 9600
•  Color Temp. variation (K) 500
7.3 Lenses      
LENS (0.637:1 EFFECTIVE WUXGA)
Throw Ratio
WU 0.637 nominal
Projection range (diagonal) 1016mm x 2550mm (40” x 100”)
Lateral color error  0.5 pixels max.
Geometry distortion 0.1% max.
FIXED 0.75:1 HD/WUXGA
Throw Ratio
HD/WUXGA 0.75...

7-4Mirage WU-L User Manual020-100774-01 Rev. 2 (4-2012)
Section 7: Specifications
7.3.1 Power Requirements
• Voltage range 90 - 240VAC nominal
• Line frequency 50 - 60Hz nominal
• Maximum inrush current 30A
• Power consumption 400W max.
• Typical current consumption 4A @ 100V
   
   (normal brightness, 1 input)
• Maximum current consumption 5.9A @ 100V
(max. brightness, multiple inputs & external accessories)
NOTES:
 1) Use of Manual RGB Adjustment to change projector brightness may increase power...

Section 7: Specifications
Mirage WU-L User Manual7-5020-100774-01 Rev. 2 (4-2012)
7.3.4 Projector Dimensions and Mounting Information
 Figure 7-1  Mirage WU-L Front Dimensions
 Figure 7-2   Mirage WU-L Side Dimensions with 1.2 - 1.6:1 Lens
192 274
276
468287 

7-6Mirage WU-L User Manual020-100774-01 Rev. 2 (4-2012)
Section 7: Specifications
 Figure 7-3   Electronic Module Dimensions
 Figure 7-4  Mirage WU-L Side Dimensions with 0.64 Lens 

Section 7: Specifications
Mirage WU-L User Manual7-7020-100774-01 Rev. 2 (4-2012)
 Figure 7-5  Mirage WU-L Side Dimensions with 0.75:1 Lens
7.3.5 Environment
Operating Environment
• Temperature 0°C to +40°C (40°F to 95°F)
• Humidity 15% - 90%
• Altitude 0-3048 m (10,000 ft)
• Vibration 0.5GRMS 10-500Hz, 15 minutes all axes
Non-Operating Environment
• Temperature -25°C to +70°C (-13°F to 158°F) 
with relative humidity varying between 0% - 95%
• Humidity 0% - 95% (non-condensing)
• Altitude 0-9144 m...

7-8Mirage WU-L User Manual020-100774-01 Rev. 2 (4-2012)
Section 7: Specifications
7.3.6 Standard and Optional Components
Due to continuing research, specifications are subject to change without notice. Specifications apply to all 
models unless otherwise noted. 
Standard Components
• Line Cord (North American and European rated)
• Digital input card x2
• VGA input card
Optional Accessories
User Kit (P/N: 125-104106-xx)
• User Manual - electronic and hard copy (P/N: 020-100774-xx)
• Setup Guide -...

Section 7: Specifications
Mirage WU-L User Manual7-9020-100774-01 Rev. 2 (4-2012)
7.4 Inputs 
NOTES: 1) Value specifies frame rate of non-interlaced sources and field rate for interlaced sources. Frame/
field rates higher than the maximum refresh rate of the panels will be displayed at a lower rate.
2) Does not 
apply to sync-on-green/luma.
3) As the horizontal frequency increases and/or as the vertical scaling ratio of 
input lines to output lines increases many sources will run into the internal...

7-10Mirage WU-L User Manual020-100774-01 Rev. 2 (4-2012)
Section 7: Specifications
DVI-I – ANALOG
Input Characteristics Same as Analog RGB, except as noted below.
Formats RGB or YPbPr – video signal cannot be routed to the decoder
Sync Types Separate H and V (direct or swapped)
Bi-level – TTL levels only 
Composite (XOR, OR)
Sync-on-green
Serrations and/or Equalization pulses
MacroVision (standard & progressive)
Analog Sync Logic Low 0V – 0.8v
Analog Sync Logic High 2.4V – 5V
Analog Sync Input Impedance...