Canon Pixma Ip110 User Guide

1200Cause
The print head cover is open.
Action Close the print head cover and wait for a while.
Do not close it while you are replacing an ink tank.
Important
•
When you replace the ink tank, do not touch the print head lock lever.
491
 

1401Cause
The print head may be damaged.
Action
Contact the service center.492
 

1403Cause
The print head may be damaged.
Action
Contact the service center.493
 

1405Cause
The print head may be damaged.
Action
Contact the service center.494
 

1410Cause
The ink tank cannot be recognized.
ActionOpen the print head cover and check that the ink tank which lamp is off is installed properly.
If the front (innermost) part of the ink tank is sticking up, push down on the "Canon" logo on the ink tank to install it properly.
If the ink lamp is off even though the ink tank is installed properly, replace the ink tank.495
 

1411Cause
The ink tank cannot be recognized.
ActionOpen the print head cover and check that the ink tank which lamp is off is installed properly.
If the front (innermost) part of the ink tank is sticking up, push down on the "Canon" logo on the ink tank to install it properly.
If the ink lamp is off even though the ink tank is installed properly, replace the ink tank.496
 

1600Cause
If the lamp on the ink tank is flashing, ink may have run out.
Action Replacing the ink tank is recommended.
If printing is in progress and you want to continue printing, press the printer's  RESUME/CANCEL button
with the ink tank installed. Then printing can continue. Replacing the ink tank is recommended after the
printing. The printer may be damaged if printing is continued under the ink out condition.
Note
•
If multiple ink lamps are flashing red, check the status of each ink tank.
497
 

1660Cause
The ink tank is not installed.
Action
Install the ink tank.498
 

1681Cause
More than one ink tanks of the same color are installed. (The lamp on the ink tank flashes.)
Action Confirm that the ink tanks are installed in the appropriate positions.499
 

1687Cause
The print head lock lever is not locked or an ink tank is installed improperly.
Action Open the print head cover, then take the corresponding actions below.•
Make sure that the ink tank is installed properly.
Push the ink tank until it clicks into place.
If the front (innermost) part of the ink tank is sticking up, push down on the "Canon" logo on the ink tank.
•
There are the right and left tabs on the print head lock lever. Push both tabs of the print head locklever and make sure that...