Canon Lbp 5200 User Guide

Paper Jams7-16
Troubleshooting
7
If paper is jammed in the drum cartridge, do not try to pull the paper out forcefully 
but refer to Paper Jam in the Drum Cartridge, on p. 7-26.
IMPORTANT
•If you touch the inner drum with your hand or scratch it, the printing quality will be 
degraded. Do not touch or open the drum protective shutter under any 
circumstances. Be careful not to hold or touch sensitive areas such as the sensor 
or electrical contacts. Doing so may damage the drum cartridge.
•Do not expose...

Paper Jams7-17
Troubleshooting
7
•Do not hold or touch the electrical contacts. Doing so may damage the drum 
cartridge.
•Do not hold or touch the transfer belt. Doing so will degrade the printing quality. Do 
not jolt the drum cartridge memory or bring it near a magnetic field. Doing so may 
damage the drum cartridge.
6Place the drum cartridge in the protective bag.
Electrical 
Contacts
Electrical Contacts
Drum Cartridge Memory
Transfer Belt
 

Paper Jams7-18
Troubleshooting
7
7Press the green lock release lever a and pull out the jammed 
paper 
b.
IMPORTANT
If you could not find the jammed paper using the above procedures, it is possible 
that the paper is jammed inside the fuser unit in the back of the printer. In this case, 
skip steps 7 to 9 and follow step 10 (
➞ p. 7-20) onwards to clear the jam. Do not 
close the top cover of the printer while you follow these steps. Doing so may make 
the paper jam even harder to clear. Once you have...

Paper Jams7-19
Troubleshooting
7
9Hold the drum cartridge with both hands and insert it into the 
printer.
Align the triangular mark on the drum cartridge with the triangular mark on the 
printer as you insert the drum cartridge a.
Lock the drum cartridge by pulling it down toward you b.
IMPORTANT
Firmly lock the drum cartridge until it is in the state shown in the figure.
a
b
 

Paper Jams7-20
Troubleshooting
7
10Close the top cover. 
Hold the grip on the top cover and close it gently.
If the paper jam message is still displayed after closing the top cover, proceed to 
the following procedure.
11If the paper jammed message is not cleared, press the power 
switch to turn the printer off 
a, remove the USB cable b, and 
disconnect the power plug from the power outlet 
c.
a
bc
 

Paper Jams7-21
Troubleshooting
7
CAUTION
The area around the fuser unit becomes hot when the printer is used. Make 
sure the fuser unit is completely cool before performing the following 
procedure. If you touch the fuser unit while it is still hot you may be 
injured.
12Return the green pressure release levers on the fuser unit to 
their original positions.
13Close the sub-output tray.
 

Paper Jams7-22
Troubleshooting
7
14Turn the two lock release levers located on the back of the 
printer in the direction of the arrows to release the lock.
15Hold the grip on the fuser unit and remove it.
CAUTION
The fuser unit weighs approximately 1.7 kg, and is heavier at the rear end. 
Make sure you have a firm grip when you hold the fuser unit. If you drop 
the fuser unit on your feet you may be injured.
Heavier on the back side
 

Paper Jams7-23
Troubleshooting
7
16Open the sub-output tray.
17Tilt both the green pressure release levers on the left and 
right side of the fuser unit towards you to release the pressure 
in the fuser unit.
18Pull out any jammed paper.
IMPORTANT
If the paper is completely wound around the fusing roller and is impossible to 
remove, contact your Canon dealer.
 

Paper Jams7-24
Troubleshooting
7
19Return the green pressure release levers on the fuser unit to 
their original positions.
20Close the sub-output tray.
21Hold the grip on the fuser unit and install it securely.
 

Paper Jams7-25
Troubleshooting
7
22Lock the fuser unit by turning the two lock release levers in 
the directions of the arrows.
23Connect the interface cables except for the USB cable, and 
connect the power cord.
24Plug the power plug into the AC power outlet.
25Connect the USB cable.
26Press the power switch to turn the printer on.
If a message continues to appear in the Printer Status Window about paper 
jammed behind the printer when the printer is turned on, there is a possibility that 
torn pieces...