Canon Lbp 3200 User Guide

Printing on Plain Paper / Heavy Paper / Label / Transparency2-24
Loading and Delivering Paper
2
2Display the [Page Setup] sheet, then from [Page Size], select 
the size of a document that you created in the application.
3From [Output Size], select the size of the loaded paper as 
needed.
Select [A4] or [Letter] for printing on transparencies or labels.
If the size of a document is the same as that of paper set in the cassette or 
manual feed slot, select [Match Page Size].
IMPORTANT
If the settings are...

Printing on Plain Paper / Heavy Paper / Label / Transparency2-25
Loading and Delivering Paper
2
4From [Paper Type], select the type of paper that you loaded.
Select [Plain Paper] for using plain paper, [Heavy Paper] for heavy paper or 
labels, and [Transparencies] for transparencies.
NOTE
•If paper curls excessively when printed with [Plain Paper] selected, select [Plain 
Paper L].
•If print fixing is not sufficient when printed with [Heavy Paper] selected, select 
[Heavy Paper H].
5Click [OK] to close the...

Printing on Plain Paper / Heavy Paper / Label / Transparency2-26
Loading and Delivering Paper
2
6Click [OK] to start printing.
 

Printing on Envelope2-27
Loading and Delivering Paper
2
Printing on Envelope
This section describes the procedure for printing on envelopes.
Loading Envelope
The paper sources in which you can load envelopes are the cassette and the 
manual feed slot. For continuous print, load envelopes in the cassette.
For printing on one envelope that differs in type from paper in the cassette, set it in 
the manual feed slot.
IMPORTANT
•Before printing on envelopes that are fed from the cassette, make sure that paper...

Printing on Envelope2-28
Loading and Delivering Paper
2
-Wrinkled or creased envelopes
-Poorly manufactured envelopes in which the glued parts are uneven.
-Irregularly-shaped envelopes
•Before loading the envelopes, flatten the stack of envelopes to release any remaining air, 
and press the fold lines at edges tightly.
•Do not print on the back of an envelope.
Loading Envelope in the Cassette
Follow the procedure below to load envelopes in the cassette.
Load envelopes lengthways in the cassette....

Printing on Envelope2-29
Loading and Delivering Paper
2
•Do not lift the cassette by holding only the rear part of the cassette. If you do so, the rear 
part of the cassette may come off.
1Pull out the cassette.
 

Printing on Envelope2-30
Loading and Delivering Paper
2
2While holding the lock release lever on the paper guide at the 
rear of the cassette, slide the paper guide to the mark 
indicating the desired paper size.
NOTE
The following shows the abbreviations of the paper size that are indicated on the 
paper guide.
Paper SizePaper Guide
Envelope C5 ENV.  ISO-C5
Envelope COM10 ENV.  COM10
Envelope DL ENV.  DL
Envelope Monarch ENV.  MONARCH
ENV. ISO-
C5
ENV. DLLT RA4
B5
A5 EXEC
ENV. COM10
ENV. MONARCH
 

Printing on Envelope2-31
Loading and Delivering Paper
2
3Place the stack of envelopes on a flat surface, flatten them to 
release any remaining air, and press the fold lines at edges 
tightly.
CAUTION
Be careful not to cut your hands with the edges of the envelopes.
4Loosen the hard corners of the envelopes and flatten curls as 
shown in the figure.
5Align the edges of the envelopes on a flat surface.
 

Printing on Envelope2-32
Loading and Delivering Paper
2
6Load the envelopes so that the rear edges of the envelopes 
touch the paper guide.
CAUTION
When loading envelopes, be careful not to cut your hands with the edges 
of the envelopes.
IMPORTANT
•Make sure that the paper guide is at the appropriate position of paper size. If the 
paper guide is not adjusted properly, this may result in misfeeds.
•The back of an envelope cannot be printed on.
NOTE
To print on an envelop, load the envelope so that the...

Printing on Envelope2-33
Loading and Delivering Paper
2
7While holding the lock release lever on the paper guide at 
either side of the cassette, slide the paper guide to the mark 
indicating the desired envelope size.
The paper guides on the sides of the cassette move together.
IMPORTANT
Be sure to align the paper guides with the width of the envelopes. If the paper 
guides are too loose or too tight, this may result in misfeeds or paper jams.