Brother MFC 465CN User Manual

Section VI
AppendixesVI
Safety and Legal106
Troubleshooting and Routine Maintenance117
Menu and Features141
Specifications154
Glossary166
 

106
A
Choosing a locationA
Put your machine on a flat, stable surface that is free of vibration and shocks, such as a desk. Put 
the machine near a telephone wall jack and a standar d AC power outlet. Choose a location where 
the temperature remains between 50 ° F and 95 ° F (10 °C and 35 ° C).
CAUTION 
• Avoid placing your machine in a high-traffic area.
• Avoid placing your machine on a carpet.
• DO NOT put the machine near heaters, air conditioners, refrigerators, medical equipment, 
chemicals or...

Safety and Legal107
A
To use the machine safelyA
Please keep these instructions for later reference and read them before attempting any 
maintenance.
WARNING 
There are high voltage electrodes inside the machine. Before you clean the inside of the 
machine, make sure you have unplugged the telephone line cord first and then the power cord 
from the AC power outlet. Doing this will prevent an electrical shock.
 
 
 
DO NOT handle the plug with wet hands. Doing this might cause an electrical shock....

108
DO NOT put your hands on the edge of the machine under the document cover or the scanner 
cover. Doing this may cause injury.
  
DO NOT put your hands on the edge of the paper tray under the output paper tray cover. Doing 
this may cause injury.
 
 
 
DO NOT touch the paper feed roller. Doing this may cause injury.
 
 
 
 
 
 

Safety and Legal109
ADO NOT touch the area shade d in the illustration. Doing this may cause injury.
  
When moving the machine you must lift it from the base, by placing a hand at each side of the 
unit as shown in the illustration. DO NOT carry the machine by holding the scanner cover.
 
 
 
DO NOT use flammable substances or any type of spray to clean the inside or outside of the 
machine. Doing this may cause a fire or electrical shock.
  
If the machine becomes hot, releases smoke, or generates any...

110
WARNING 
• Use caution when installing or modifying telephone lines. Never touch telephone wires or terminals that are not insulated unless the telephone line has been unplugged at the wall 
jack. Never install telephone wiring during a lightning storm. Never install a telephone wall 
jack in a wet location.
• This product must be installed near an AC power outlet that is easily accessible. In case of  an emergency, you must unplug the power cord from the AC power outlet to shut off the 
power...

Safety and Legal111
A
5 DO NOT use this product near water.
6 DO NOT place this product on an unstable cart, stand, or table. The product may fall, causing serious damage to the product.
7 Slots and openings in the cabinet and the back or bottom are provided for ventilation. To  ensure reliable operation of the product and to protect it from overheating, these openings 
must not be blocked or covered. The openings should never be blocked by placing the product 
on a bed, sofa, rug, or other similar...

112
17 To reduce the risk of fire, electric shock and injury to people, note the following:„DO NOT use this product near appliances that use water, a swimming pool, or in a wet 
basement.
„ DO NOT use the machine during an electrical storm (there is the remote possibility of an 
electrical shock) or to report a gas leak in the vicinity of the leak.
Standard telephone and FCC Notices (These notices are in effect 
on models sold and used in the United States only.)A
When programming emergency numbers or...

Safety and Legal113
A
Connection to party line service is subject to  state tariffs. Contact the state public utility 
commission, public service commission or corporation commission for information.
If your home has specially wired alarm equipment connected to the telephone line, ensure the 
installation of this equipment does not disable your alarm equipment. If you have questions about 
what will disable alarm equipment, call your telephone company or a qualified installer.
If you are not able to...

114
This equipment has been tested and found to comply with the limits for a Class B digital device, 
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection 
against harmful interference in a residential installation. This equipment generates, uses, and can 
radiate radio frequency energy and, if not installed and used in accordance with the instructions, 
may cause harmful interference to radio communications. However, there is no guarantee that 
interference...