Brother Hl 4150cdn User Manual

							Troubleshooting 145
6
Paper jams and how to clear them6
If paper jams inside the machine, the machine will stop. One of the following LCD messages will appear to 
tell you where to find the jammed paper.
 
JamMPTray  (1)
Paper jam in the MP tray. (See page 146.)
 JamTray1  (2)
Paper jam in the standard paper tray (Tray 1). (See page 146.)
 JamTray2  (3)
Paper jam in the lower tray (Tray 2). (See page 146.)
 Jam Duplex (4)
Paper jam underneath the standard paper tray (Tray 1) or in the fuser unit. (See page 149.)
 Jam Rear (5)
Paper jam where the paper comes out of the machine. (See page 152.)
 Jam Inside (6)
Paper jam inside the machine. (See page 155.)
If the error message still appears on the LCD after you remove the jammed paper, there may be more paper 
jammed somewhere else. Check the machine thoroughly.
Note
Always remove all paper from the paper tray and straighten the stack when you add new paper. This helps 
prevent multiple sheets of paper from feeding through the machine at one time and prevents paper jams.
 
1
23 6
5
4
 
						

							Troubleshooting 146
6
Jam MP Tray (paper jam in the MP tray)6
 
Jam MP Tray
If a paper jam occurs inside the MP tray, follow these steps:
aRemove the paper from the MP tray.
bRemove any jammed paper from in and around the MP Tray.
cFan the paper stack, and then put it back in the MP tray. 
dWhen loading paper in the MP tray, make sure that the paper stays under the maximum paper height 
guides on both sides of the tray.
ePress Go  to resume printing.
Jam Tray 1 / Jam Tray 2 (Paper jam inside the paper tray)6
Note
The LCD names for the paper trays are as follows.
• Standard paper tray:  Tray1
• Optional lower tray:  Tray2
 
 
Jam Tray 1
 
Jam Tray 2
 
						

							Troubleshooting 147
6
If a paper jam occurs inside the paper tray, follow these steps:
aPull the paper tray completely out of the machine. 
WARNING 
DO NOT touch the shaded parts shown in the illustration. These rollers may be rotating at high speed and 
can pinch or entrap your hand.
 
 
 
						

							Troubleshooting 148
6
bUse both hands to slowly pull out the jammed paper. 
Note
Pulling out the jammed paper downward allows you to remove the paper easier.
 
cMake sure that the paper is below the maximum paper mark (bbb). While pressing the green 
paper-guide release lever, slide the paper guides to fit the paper size. Make sure that the guides are 
firmly in the slots.
dPut the paper tray firmly back in the machine.
 
						

							Troubleshooting 149
6
Jam Duplex (paper jam underneath the standard paper tray (tray 1) or in the 
fuser unit)6
 
Jam Duplex
If a paper jam occurs inside the duplex unit, follow these steps:
aLeave the machine turned on for 10 minutes to cool down.
bPull the paper tray completely out of the machine and check inside the machine. 
WARNING 
DO NOT touch the shaded parts shown in the illustration. These rollers may be rotating at high speed and 
can pinch or entrap your hand.
 
 
 
						

							Troubleshooting 150
6
cIf paper is not caught inside the machine, check underneath the paper tray. 
Note
Do not put the paper tray back in at this point.
 
dIf the paper is not caught in the paper tray, open the back cover. 
WARNING 
After you have just used the machine, some internal parts of the machine will be extremely hot. Wait for the 
machine to cool down before you touch the internal parts of the machine.
 
 
 
						

							Troubleshooting 151
6
ePull out the jammed paper slowly. 
fFully close the back cover.
gPut the paper tray back in the machine.
 
						

							Troubleshooting 152
6
Jam Rear (Paper jam behind the back cover)6
 
Jam Rear
If a paper jam occurs behind the back cover, follow these steps:
aLeave the machine turned on for 10 minutes to cool down.
bOpen the back cover. 
WARNING 
After you have just used the machine, some internal parts of the machine will be extremely hot. Wait for the 
machine to cool down before you touch the internal parts of the machine.
 
 
 
						

							Troubleshooting 153
6
cPull the green tabs (2) at the left and right hand sides toward you and fold down the fuser cover (1). 
Note
If the envelope levers (3) inside the back cover are pulled down to the envelope position,  lift these levers 
to the original position before pulling the green tabs (2) down.
 
dUsing both hands, gently pull the jammed paper out of the fuser unit. 
12
3
2
3
 
						

							Troubleshooting 154
6
eClose the fuser cover (1). 
Note
If you print on envelopes, pull down the envelope levers (2) to the envelope position again before closing 
the back cover.
 
fClose the back cover.
12
2