ATT Definity Addendum 1 For Ds1, Dmi, Isdn Pri Instructions Manual

ADMINISTRATION OPTIONS AND REQUIREMENTS — GENERIC 27-73½
½
½
Table 7-8, Codeset Mapping Requirements, summarizes the current codeset mapping requirements for
Generic 2:½
½
Table 7-8. Codeset Mapping Requirements½
½
IECodeset MapOpcode Map
When Required½
TCM
DisplayMap from codeset 6 to codeset
7 outgoing.
Map from codeset 7 to codeset
6 incoming.
Map from codeset 6 to codeset
7 outgoing.
Map from codeset 7 to codeset
6 incoming.
Map from opcode 8 to opcode
8 in both directions.½
½If a System 85 R2V4 is...

7-74ADMINISTRATION OPTIONS AND REQUIREMENTS — GENERIC 2
Field 1*Assigns a codeset map number (such as defined in procedure 262, word 3). Field
encodes and their descriptions are:
l     Dash (–), which disables codeset mapping.
l     Any number between 0 and 15 that is previously defined with procedure 262, word
3.
Field 2* Specifies whether codeset mapping is for incoming messages or outgoing messages.
Field encodes and their descriptions are:
0
1Assigns mapping for incoming messages.
Assigns mapping for...

ADMINISTRATION OPTIONS AND REQUIREMENTS — GENERIC 27-75
Field 5Specifies a mapped-to codeset number. Permitted encodes are numbers within the
range (0 through 7) These numbers correspond to the respective codesets on a
number-per-number basis.
If field 2 is translated one for incoming, then encode seven is appropriate for field 5.
Field 6
Identifies the IE code to be mapped to. Permitted encodes are the same as field 4.
Field 7
Each code set map number may contain up to a maximum of 255 incoming and 255...

7-76ADMINISTRATION OPTIONS AND REQUIREMENTS — GENERIC 2
ENHANCED MODE — PROCEDURE: 354, WORD: 3
NPA-NXX ASSIGNMENTS
1.
2.
3.
4.
NPA-NXX Deesignator:
NPA:
NXX:
Thousands Digit:
Connected to CC0 ON-LINE
enter command:
Figure 7-33. Procedure 354 Word 3: NPA-NXX Digits Assignment (Generic 2)½
Field 1
This field should be translated for both private and public network connections. The
NPA-NXX designator is a 2-digit field and within the range of 1 through 99.
Field 2
This 3-digit field should contain the...

ADMINISTRATION OPTIONS AND REQUIREMENTS — GENERIC 27-77
The 10 BCs are defined in field 16 of procedure 014, word 1. This definition codes the BC information
element (IE) in the setup message when the extension (that is, the extension in field 1 of procedure 000,
word 3) accesses an ISDN-PRI trunk for an outgoing call. Figure 7-34, Procedure 000 Word 3: Line-½
½
½
½
Side BCCOS Designator, depicts this procedure.
ENHANCED MODE — PROCEDURE: 000, WORD: 3
SINGLE TERMINAL - MISCELLANEOUS FEATURES
1.
2.
3.
4....

7-78ADMINISTRATION OPTIONS AND REQUIREMENTS — GENERIC 2
Procedure 000 Word 4: NPA-NXX Index Designator
Depending on how the switch is used, procedure 000, word 4, may or may not be translated.
Specifically, word 4, field 4, is used for partitioning, ISDN, or both, and must be translated when:
a.     The switch transmits SID or connected number to the network
b.     The switch provides unique extension number partitions
Field 4 of procedure 000, word 4, need not be translated when: the switch does not...

ADMINISTRATION OPTIONS AND REQUIREMENTS — GENERIC 27-79
Field 3Assigns the extension partition identification for the tenant services feature. This
number associates the single or block of extension numbers to a particular ISDN
facility (NPA-NXX Designator).
Field 4Associates an NPA-NXX Designator with the previously defined extension.
Procedure 210 Word 2: LDN, NPA, and NNX Attendant Partition Assignments
This procedure is used to configure the attendant consoles into groups known as attendant...

7-80ADMINISTRATION OPTIONS AND REQUIREMENTS — GENERIC 2
Field 3Assigns the one console in the attendant partition that will be the controlling console.
All other members of this group must have control denied. Field encodes and their
descriptions are:
0 For all but the controlling console
1 Only for the controlling console
Field 4
Field 5Assigns or associate the LDN with a particular console or console partition. The
number is dependent on the switch or private network numbering plan.
Assigns or...

ADMINISTRATION OPTIONS AND REQUIREMENTS — GENERIC 27-81
ENHANCED MODE — PROCEDURE: 014, WORD: 1
BEARER CAPABILITY CLASS OF SERVICE — CALL OPTIONS
1.
2.
3.Bearer Capability COS:
Transport Mode:
Information Type:DEFAULT CAPABILITIES
14.
15.
16.Transport Mode:
Information Type:
Bearer Capability:
CALL TYPES AND ACTION TAKEN
4.
5.
6.
7.
8.
9.
10.
11.
12.
13.Voice:
Voice Grade Data:
Mode 0:
Mode 1:
Mode 2:
Mode 3:
Unknown Digital:
Unknown Analog:
Mode 3/2:
X.25:
Connected to CC0 ON-LINE
enter command:
Field...

7-82ADMINISTRATION OPTIONS AND REQUIREMENTS — GENERIC 2
Fields 4-13The translation parameters administered for fields 4 through 13 determine what actions
the switch will take for the BCCOS specified in field 1. Regarding Generic 2, it is
important to remember that the administration (of the BCCOS) determines when a
modem pool member is added and not the particular trunk type. By administering the
BCCOS on an AAR/ARS preference basis allows a single trunk group to support both
circuit switched and modem...