ATT Definity Addendum 1 For Ds1, Dmi, Isdn Pri Instructions Manual

ADMINISTRATION OPTIONS AND REQUIREMENTS — GENERIC 27-93
Field 9Specifies the network service that is requested for trunk verification by station (TVS).
The following table shows permitted field entries that support signaling type 20.½
½
Trunks Supporting Signaling Type 20½
½
Trunk
DescriptionTrunkType½
CO
Data
DID
DMI (Note 2)
FX
ISDN
M/S TIE
Special
TIE
WATS16, *17 (Note 1), 18, 19, 20
100—107
*30, *31
*108, *109
21—25
120 (Note 3)
70—78
2, 5, 6, 50—58, 62, 65—67, 90—93
32—40, *41, *42, *43, 44, 45,...

7-94ADMINISTRATION OPTIONS AND REQUIREMENTS — GENERIC 2
ENHANCED MODE — PROCEDURE: 101, WORD: 1
TRUNK GROUP CHARACTERISTICS
1.
2.
3.
4.
5.
6.
7.
8.
9.Trunk Group:
Balance:
Battery Reversal:
Incoming Prefix Digit:
DCS:
Touch-Tone In:
Touch-Tone Out:
CDR Active:
AIOD Billing Number:
TIMED RECALL
10.
11.
Time:Level:
12.
13.
14.
15.
16.CDR Variable Timer:
Pad Group:
Tie Toll:
APLT Features Allowed:
Disconnect Supervision:
Connected to CC0 ON-LINE
enter command:
Figure 7-43. Procedure 101 Word 1: ISDN Trunk...

ADMINISTRATION OPTIONS AND REQUIREMENTS — GENERIC 27-95
Field 8Assigns or not assign the trunk group to CDR record keeping. Field encodes and their
descriptions are:
0 Trunk group usage not applicable for CDR recording
1 Trunk group usage will be recorded by CDR
2 Trunk group usage will be recorded, account code is required
Fields 9-11Not used for ISDN applications.
Field 12This field is only applicable when CDR is being used, and then only to change the
default CDR timer value. Field encodes represent...

7-96ADMINISTRATION OPTIONS AND REQUIREMENTS — GENERIC 2
ENHANCED MODE — PROCEDURE: 103, WORD: 1
NETWORK TRUNK GROUP TRANSLATION
1.
2.
3.
4.
5.
6.
7.
8.
9.
10.
11.
12.
13.
14.Trunk Group:
Facility Restriction Level:
Network Trunk:
Main/Tandem:
Incoming Tie to AAR/ARS or APLT:
Authorization Code Required:
Bridge-On Allowed:
Trunk Reservation Limit:
AAR/ARS Prefix:
Data Protection (Permanent):
Remote Access Echo Suppressor:
AAR Conditional Routing:
Second TCM:
Digit Collection:
Connected to CC0 ON-LINE...

ADMINISTRATION OPTIONS AND REQUIREMENTS — GENERIC 27-97
For traditional modules, each DS1/MFAT carrier will support a maximum of two DS1s, each occupying
one slot and located in slots 5 and 18. When a DSl/DMI/ISDN interface (trunk applications) is located
in slot 5, it uses the six slots 0, 1, 2, 5, 6, and 7. When the interface is located in slot 18, it uses the six
slots 13, 14, 15, 18, 19, and 20. Figure 7-45, Procedure 116 Word 1: DSI/DMI/ISDN-PRI Trunk½
½
½
Assignments, depicts this procedure....

7-98ADMINISTRATION OPTIONS AND REQUIREMENTS — GENERIC 2
TABLE 7-11. DS1/ISDN-PRI Administration — Channel Versus Trunk Assignments½
DS1 ChannelSlot/CircuitDS1 Channel
Slot/Circuit
15/0 or 18/013
0/0 or 13/0
26/0 or 19/0
14
1/0 or 14/0
3
7/0 or 20/0152/0 or 15/0
4
5/1 or 18/1160/1 or 13/1
5
6/1 or 19/1
171/1 or 14/1
67/1 or 20/1
18
2/1 or 15/1
75/2 or 18/2
190/2 or 13/2
86/2 or 19/2201/2 or 14/2
97/2 or 20/2212/2 or 15/2
105/3 or 18/3220/3 or 13/3
116/3 or 19/3
231/3 or 14/3
127/3 or 20/3242/3 or 15/3...

ADMINISTRATION OPTIONS AND REQUIREMENTS — GENERIC 27-99
Field 10Assigns the function of the terminating endpoint. For PRI nodal services, this endpoint
is the network. Field encodes and their descriptions are:½
0 Another customer premises switch
1 A private network connection to a host computer
2 Public network connections
Field 11Translates the D-channel group number. These numbers should be coordinated with
field 1 of procedure 262, word 2. Field encodes and their descriptions are:
l     Dash (–), for...

7-100ADMINISTRATION OPTIONS AND REQUIREMENTS — GENERIC 2
Field 1Assigns either an extension number, vector directory number, or trunk group. Field
encodes and their descriptions are:
l    000 through 99999, for extension and directory numbers. Whether the number is
three, four, or five digits depends on the numbering plan.
l    18 through 999, for trunk group numbers.
Field 2Specifies whether the encode for field 1 is a trunk group or extension/vector directory
number. Field encodes and their...

ADMINISTRATION OPTIONS AND REQUIREMENTS — GENERIC 27-101
ENHANCED MODE — PROCEDURE: 012, WORD: 2
NAME DATABASE — ENTRY
1. Segment:
CHARACTER ENCODES
2.
3.
4.
5.
6.
7.
8.
9.
10.
11.Character 1:
Charaacter 2:
Character 3:
Character 4:
Character 5:
Character 6:
Character 7:
Character 8:
Character 9:
Character 10:
Connected to CC0 ON-LINE
enter command:½
Field 1
Fields 2-11Figure 7-47. Procedure 012 Word 2: Name Database (Generic 2)
Identifies one-of-three 10 character fields. Field encodes and their...

7-102ADMINISTRATION OPTIONS AND REQUIREMENTS — GENERIC 2
ENHANCED MODE — PROCEDURE: 012, WORD:3
NAME DATABASE COMPACTION
1. Compact:
DISPLAY ONLY
2.
3.
4.Names That Can Yet Be Assigned:
Words Available:
Words to Be Gained by Compacting:
Connected to CC0 ON-LINE
enter command:
Figure 7-48. Procedure 012 Word 3: Name Database (Generic 2)½
Field 1Assigns whether the name database is (1) or is not (0) to be compacted.
Fields 2-4Are display only and serve to show status of the database.
Procedure 279 Word 1:...