Apple macbook pro User Manual
Have a look at the manual Apple macbook pro User Manual online for free. It’s possible to download the document as PDF or print. UserManuals.tech offer 195 Apple manuals and user’s guides for free. Share the user manual or guide on Facebook, Twitter or Google+.
MacBook Pro Take Apart — Sleep Magnet 141 Procedure Remove two screws. 1. Remove the bracket and magnet. 2. Replacement Note: 3. Make sure that the bracket’s overhang is oriented away from the bezel to prevent the magnet from sliding out.
MacBook Pro Take Apart — Inverter Board 142 Inverter Board Note: The inverter cable is a separate assembly that includes the camera cable and can be removed by following the procedures in the Clutch Cover chapter. Tools This procedure requires the following tools: Black stick (nylon probe 922-5065) (or other non-conductive nylon or plastic flat-blade tool • Preliminary Steps Before you begin, remove the following: Batter • y Top Cas • e Display Assembl • y Display Rear Housin • g Part Location
MacBook Pro Take Apart — Inverter Board 143 Procedure Lift the left side of the inverter. 1. Disconnect the connector. Peel back Kapton tape as needed. 2.
MacBook Pro Take Apart — Inverter Board 14 4 Lift the inverter and disconnect the connector. 3.
MacBook Pro Take Apart — Clutch Cover 145 Clutch Cover Tools This procedure requires the following tools: #0 Phillips screwdriver (magnetized) • Torx T6 screwdriver (magnetized) • Black stick (nylon probe 922-5065) (or other non-conductive nylon or plastic flat-blade tool • Kapton tape (922-1731 (0.5-inch x 12-yard roll)) • Preliminary Steps Before you begin, remove the following: Batter • y Top Cas • e Display Assembl • y Display Rear Housin • g Inverter Boar • d Part Location
MacBook Pro Take Apart — Clutch Cover 146 Procedure Note the desired orientation of the cables coming out of both sides of the clutch cover.
MacBook Pro Take Apart — Clutch Cover 14 7 Disconnect the LVDS cable at the top of the display panel. 1. Peel back tape securing the LVDS cable to the display panel at the clutch cover and pull back 2. the cable to gain access to the clutch cover screw behind it. Peel up the antenna assembly tabs from the display panel to gain access to the clutch cover 3. screws behind them. Remove the seven phillips #0 screws along the back side of the clutch cover. Note the 4. location of the three black screws.
MacBook Pro Take Apart — Clutch Cover 14 8 Grab the clutch cover at one end and carefully slide it straight down, slightly, away from the 5. clutch. Do not remove the cover. Note the cable routing. Grab the clutch cover at the other end and carefully slide it straight down, note the cable 6. routing as you remove the cover, being careful not to catch any wires.
MacBook Pro Take Apart — Clutch Cover 149 Replacement Procedure Route cables over clutches as shown, below 1. .
MacBook Pro Take Apart — Clutch Cover 150 Slide the clutch cover over the clutches, capturing the cables, without pinching. Verify that 2. the ends are flush with the cosmetic end caps. Use a black stick if necessary to guide the ends of the clutch cover over the end caps. Secure the 3. ground loop on the right inverter cable with a black screw..