Apple macbook pro User Manual
Have a look at the manual Apple macbook pro User Manual online for free. It’s possible to download the document as PDF or print. UserManuals.tech offer 195 Apple manuals and user’s guides for free. Share the user manual or guide on Facebook, Twitter or Google+.
MacBook Pro Take Apart —Thermal Sensors 111 Thermal Sensors Tools This procedure requires the following tools: Black stick (nylon probe 922-5065) (or other non-conductive nylon or plastic flat-blade tool • Razor knife • Kapton tape (922-1731 (0.5-inch x 12-yard roll)) • Fine-point felt-tip permanent marker • Preliminary Steps Before you begin, remove the following: Batter • y Top Cas • e Right Speake • r Fan • s Optical Driv • e Logic Boar • d
MacBook Pro Take Apart —Thermal Sensors 11 2 Part Location
MacBook Pro Take Apart —Thermal Sensors 113 Procedure There are two thermal sensors, each requiring precise placement. One sensor is attached to the bottom case and one to the heatsink. Note: The bottom case sensor has a 90 mm cable, and the heatsink sensor has a 60 mm cable.For either sensor, peel back any Kapton tape, then before removing the board, mark the 1. outline of its position with a permanent fine-point felt-tip marker.
MacBook Pro Take Apart —Thermal Sensors 11 4 Pry up the sensor board with a razor knife. 2. Install the replacement sensors in the exact same location. 3. Replace any Kapton tape. 4.
MacBook Pro Take Apart — Heatsink 11 5 Heatsink Tools This procedure requires the following tools: Black stick (nylon probe 922-5065) (or other non-conductive nylon or plastic flat-blade tool • Thermal grease (922-7144) • Preliminary Steps Before you begin, remove the following: Batter • y Top Cas • e Right Speake • r Right Ambient Light Sensor Len • s Fan • s Optical Driv • e Logic Boar • d Part Location
MacBook Pro Take Apart — Heatsink 11 6 Procedure Once the parts are removed in the preliminary steps, lift out the heatsink. 1. When installing the heatsink, make sure that it fits over the pins, shown, and lays flat. 2. Make sure to install new thermal grease as outlined in the logic board chapter. 3.
MacBook Pro Take Apart — Right Speaker Chamber 11 7 Right Speaker Chamber Tools This procedure requires the following tools: Torx T6 screwdriver (magnetized) • Black stick (nylon probe 922-5065) (or other non-conductive nylon or plastic flat-blade tool • Preliminary Steps Before you begin, remove the following: Batter • y Top Cas • e Right Speake • r Right Ambient Light Sensor Len • s Fan • s Optical Driv • e Logic Boar • d Part Location
MacBook Pro Take Apart — Right Speaker Chamber 11 8 Procedure Remove the screw and lift out the speaker chamber. A light adhesive may be holding the 1. chamber under the speaker holder. When installing, adjust the gasket if needed so that it seats uniformly around the inside of 2. the well.
MacBook Pro Take Apart — Left I/O Board 11 9 Left I/O Board Tools This procedure requires the following tools: Torx T6 screwdriver (magnetized) • 4 mm socket wrench • Black stick (nylon probe 922-5065) (or other non-conductive nylon or plastic flat-blade tool • Preliminary Steps Before you begin, remove the following: Batter • y Top Cas • e AirPort Extreme Car • d Left Ambient Light Senso • r Left Speake • r Part Location
MacBook Pro Take Apart — Left I/O Board 120 Procedure Remove the four screws and 4mm hex standoff. 1. . Lift the board assembly and slide away from the port openings. 2.