Apple macbook pro User Manual
Have a look at the manual Apple macbook pro User Manual online for free. It’s possible to download the document as PDF or print. UserManuals.tech offer 195 Apple manuals and user’s guides for free. Share the user manual or guide on Facebook, Twitter or Google+.
MacBook Pro Take Apart — Fans 91 Slide the fan out from under the left speaker screw tab. 6.
MacBook Pro Take Apart — Fans 92 Replacement Procedure For both fans, after replacing, apply Kapton tape over the length of the cut tape, to seal. 1. Secure the ambient light sensor flex cable to the left fan cover with Kapton tape, if needed. 2. V 3. erify that the thermal sensor cable is not caught under the right fan.
MacBook Pro Take Apart — Speakers 93 Speakers The right and left speakers are one assembly. Tools This procedure requires the following tools: #0 Phillips screwdriver (magnetized) • Torx T6 screwdriver (magnetized) • Black stick (nylon probe 922-5065) (or other non-conductive nylon or plastic flat-blade tool • Kapton tape (922-1731 (0.5-inch x 12-yard roll)) • Preliminary Steps Before you begin, remove the following: Batter • y Top Cas • e AirPort Extreme Car • d (for left speaker) Right Ambient Light Sensor Len • s (for right speaker) Part Location
MacBook Pro Take Apart — Speakers 94 Procedure To remove the right speaker: Remove the LVDS grounding strap screw to access the tape along the right side of the speaker. 1. Pry up the tape next to the speaker to allow the speaker to rotate. 2.
MacBook Pro Take Apart — Speakers 95 Push on the screw tab to rotate the speaker a short distance until it releases from the 3. speaker chamber under the logic board. Lift out the speaker and move to the side. Disconnect the thermal sensor connector, shown, if its wire crosses over the speaker wire. 4.
MacBook Pro Take Apart — Speakers 96 Replacement Note: Check the circle gasket in the lower speaker chamber and re-seat if needed. Replacement Note: Route the wires as shown.
MacBook Pro Take Apart — Speakers 97 To remove the left speaker: Remove two screws. 1. Disconnect the connector shown and lift the flex cable from the ExpressCard cage to gain 2. access to the speaker cables and connector.
MacBook Pro Take Apart — Speakers 98 Note cable routing, then disconnect the speaker cable connector. 3.
MacBook Pro Take Apart — Logic Board 99 Logic Board Tools This procedure requires the following tools: #0 Phillips screwdriver (magnetized) • Torx T6 screwdriver (magnetized) • Black stick (nylon probe 922-5065) (or other non-conductive nylon or plastic flat-blade tool • Needle-point metal probe • Multi-compartment screw tray (such as a plastic ice cube tray) • Kapton tape (922-1731 (0.5-inch x 12-yard roll)) • Thermal grease (922-7144) • Gasket kit (076-1206) • Alcohol pads • Preliminary Steps Before you begin, remove the following: Batter • y Memor • y Top Cas • e Right Speake • r Fan • s Optical Driv • e
MacBook Pro Take Apart — Logic Board 100 Part Location Procedure Disconnect the cables shown. 1. .