Apple macbook pro 17 inch mid 2010 User Manual
Here you can view all the pages of manual Apple macbook pro 17 inch mid 2010 User Manual. The Apple manuals for Notebook are available online for free. You can easily download all the documents as PDF.
Page 121
MacBook Pro (17-inch, Mid 2010) Take Apart — Battery 121 2010-06-11 First Steps Remove: • Bottom case Before you begin this procedure, disconnect the battery from the logic board. Failure to do so could damage the computer. Tools • Clean, soft, lint-free cloth • ESD wrist strap and mat • Black stick • Large tri-lobe #0 screwdriver (922-8991) Battery
Page 122
MacBook Pro (17-inch, Mid 2010) Take Apart — Battery 122 2010-06-11 Removal Important: Battery removal is only required when replacing the battery, trackpad, or top case. Other internal repairs require disconnecting the battery cable but not removing the battery. 1 Use pull-tab to disconnect battery cable. 2 Remove 3 (6.4-mm) tri-lobe 922-9431 screws.
Page 123
MacBook Pro (17-inch, Mid 2010) Take Apart — Battery 123 2010-06-11 3 Peel up battery label, and discard it. 4 Remove any label residue from speaker, and from battery if it is to be reused. 5 Without pulling cable, tilt out battery. Warning: Underside of battery is soft. • Do not puncture or press on battery. • Hold battery by edges only. • If setting battery aside, make sure surface is clean—free of dust, dirt, screws, etc. Warning: If mylar covering battery is punctured, do not re-use...
Page 124
MacBook Pro (17-inch, Mid 2010) Take Apart — Battery 124 2010-06-11 Replacement 1 Slide front edge of battery under 3 tabs. 2 Install screws. Note: If installing new battery, attach the new battery label (refer to battery label inbox instructions). 3 If performing other repairs, be sure to leave battery cable disconnected.
Page 125
MacBook Pro (17-inch, Mid 2010) Take Apart — Battery 125 2010-06-11 4 Using black stick or pull-tab, connect battery cable. 5 Apply new battery label, and reassemble computer. 6 Press battery indicator light to check charge level.
Page 126
MacBook Pro (17-inch, Early 2009) Take Apart — Hard Drive Bracket, Rear 126 2010-06-11 First Steps Remove • Bottom case Caution: Make sure data is backed up before removing the hard drive. Before you begin this procedure, disconnect the battery from the logic board. Failure to do so could damage the computer. Hard Drive Bracket, Rear
Page 127
MacBook Pro (17-inch, Early 2009) Take Apart — Hard Drive Bracket, Rear 127 2010-06-11 Tools • Clean, soft, lint-free cloth • ESD wrist strap and mat • Magnetized Phillips #00 screwdriver Removal 1 Loosen 2 (5.5 mm) captive screws. 2 Lift out bracket. Replacement Note: Make sure 2 rubber grommets are included in bracket before installing it.
Page 128
MacBook Pro (17-inch, Mid 2010) Take Apart — Hard Drive 128 2010-06-11 First Steps Remove: • Bottom case • Rear hard drive bracket Caution: Make sure data is backed up before removing the hard drive. Before you begin this procedure, disconnect the battery from the logic board. Failure to do so could damage the computer. Hard Drive
Page 129
MacBook Pro (17-inch, Mid 2010) Take Apart — Hard Drive 129 2010-06-11 Tools • Clean, soft, lint-free cloth • ESD wrist strap and mat • Magnetized Phillips #00 screwdriver • Torx T6 screwdriver Removal 1 Make sure hard drive bracket is removed. 2 Use pull tab to tilt hard drive out.
Page 130
MacBook Pro (17-inch, Mid 2010) Take Apart — Hard Drive 130 2010-06-11 3 Hold hard drive by the sides only. 4 Disconnect hard drive connector. 5 Follow safe handling: • Do not press drive • Do not touch connector • Do not touch circuitry