Home > Yamaha > Motorcycle > 2012 Na Yamaha Super Tenere Manual

2012 Na Yamaha Super Tenere Manual

Here you can view all the pages of manual 2012 Na Yamaha Super Tenere Manual. The Yamaha manuals for Motorcycle are available online for free. You can easily download all the documents as PDF.

Page 541

haha ABS (ANTI-LOCK BRAKE SYSTEM)8-92
16 Rear wheel sensor circuit is short-cir-
cuited. 
Rear wheel sensor circuit
 Wire harness (ABS circuit)
 Connection of the rear wheel sensor cou-
pler and ABS ECU coupler
 Rear wheel sensor
17 Missing pulses detected in the front 
wheel sensor signal. 
Front wheel sensor rotor
 Front wheel sensor housing
 Front wheel
18 Missing pulses detected in the rear 
wheel sensor signal. 
Rear wheel sensor rotor
 Rear wheel sensor housing
 Rear wheel
21 Hydraulic...

Page 542

haha ABS (ANTI-LOCK BRAKE SYSTEM)8-93
* A fault code is indicated if the rear wheel rotates for longer than about 20 seconds (fault code No. 11) or for longer than about 2 seconds (fault code No. 25) with the front wheel stopped (e.g.,\
 when the 
vehicle is on the centerstand).
TIP
Fault codes No. 15 (front wheel) and 16 (rear wheel) are indicated if a defective connection is detected 
in the front or rear wheel sensor when the vehicle is not being ridden.59 Solenoid valve data is abnormal.
Hydraulic...

Page 543

haha ABS (ANTI-LOCK BRAKE SYSTEM)8-94
TIP
With the front wheel stopped, the rear wheel was rotated for longer than about 20 seconds (fault code 
No. 11) or for longer than about 2 seconds (fault code No. 25).Fault code No. 11
25Symptom Front wheel sensor signal is not received prop-
erly.
Order Item/components and probable  cause Check or maintenance job Reinstatement 
confirmation 
method
1 Installed condition of wheel sensor. Check for looseness. Repair or  replace the wheel sensor if nec-
essary....

Page 544

haha ABS (ANTI-LOCK BRAKE SYSTEM)8-95
Fault code No. 12 Symptom Rear wheel sensor signal is not received proper- ly.
Order Item/components and probable  cause Check or maintenance job Reinstatement 
confirmation 
method
1 Installed condition of wheel sensor. Check for looseness. Repair or  replace the wheel sensor if nec-
essary.
Set the main 
switch to  “ON” 
and check 
that the ABS 
warning light 
comes on for 
2 seconds, 
then goes off.
 Perform a tri-
al run at a 
constant 
speed of 30 
km/h and...

Page 545

haha ABS (ANTI-LOCK BRAKE SYSTEM)8-96
TIP
Vehicle possibly ridden on uneven roads.Fault code No. 13
26Symptom Incorrect signal from the front wheel sensor is 
detected.
Order Item/components and probable  cause Check or maintenance job Reinstatement 
confirmation 
method
1 Installed condition of wheel sensor. Check for looseness. Repair or  replace the wheel sensor if nec-
essary.
Set the main 
switch to  “ON” 
and check 
that the ABS 
warning light 
comes on for 
2 seconds, 
then goes off.
 Perform a...

Page 546

haha ABS (ANTI-LOCK BRAKE SYSTEM)8-97
TIP
Vehicle possibly ridden on uneven roads.Fault code No. 14
27Symptom Incorrect signal from the rear wheel sensor is 
detected.
Order Item/components and probable  cause Check or maintenance job Reinstatement 
confirmation 
method
1 Installed condition of wheel sensor. Check for looseness. Repair or  replace the wheel sensor if nec-
essary.
Set the main 
switch to  “ON” 
and check 
that the ABS 
warning light 
comes on for 
2 seconds, 
then goes off.
 Perform a...

Page 547

haha ABS (ANTI-LOCK BRAKE SYSTEM)8-98
Fault code No. 15 Symptom Front wheel sensor circuit is short-circuited.
Order Item/components and probable  cause Check or maintenance job Reinstatement 
confirmation 
method
1 Connections Front wheel sensor coupler
 ABS ECU coupler 
Check the coupler for any pins 
that may be pulled out.
 Check the locking condition of 
the coupler.
 If there is a malfunction, repair it 
and connect the coupler se-
curely.
TIP
Set the main switch to  “OFF” be-
fore...

Page 548

haha ABS (ANTI-LOCK BRAKE SYSTEM)8-99
2 Wire harness continuity. Check for continuity between 
the white terminal “1” and the 
white terminal  “3” and between 
the black terminal  “2” and the 
black terminal  “4”. 
 If there is no continuity, the wire 
harness is defective. Properly 
repair or replace the wire har-
ness.
 Check that there is no continuity 
between the ground and the 
white terminal  “1” or white ter-
minal  “3”.
 If there is continuity, the wire 
harness is defective. Properly...

Page 549

haha ABS (ANTI-LOCK BRAKE SYSTEM)8-100
3 Defective wheel sensor. If the above items were per-
formed and no malfunctions were 
found, connect the ABS ECU 
coupler and front wheel sensor 
coupler, and then delete the fault 
codes. If fault code No. 15 could 
not be deleted, the front wheel 
sensor is defective. Replace the 
front wheel sensor.
TIP
Before deleting the fault codes, 
record all of the fault codes and 
perform the related checks and 
maintenance.
Fault code No. 16 Symptom Rear wheel sensor...

Page 550

haha ABS (ANTI-LOCK BRAKE SYSTEM)8-101
2 Wire harness continuity. Check for continuity between 
the white terminal “1” and the 
white terminal  “3” and between 
the black terminal  “2” and the 
black terminal  “4”. 
 If there is no continuity, the wire 
harness is defective. Properly 
repair or replace the wire har-
ness.
 Check that there is no continuity 
between the ground and the 
white terminal  “1” or white ter-
minal  “3”. 
 If there is continuity, the wire 
harness is defective. Properly...
Start reading 2012 Na Yamaha Super Tenere Manual

Related Manuals for 2012 Na Yamaha Super Tenere Manual

All Yamaha manuals