2012 Na Yamaha Super Tenere Manual
Here you can view all the pages of manual 2012 Na Yamaha Super Tenere Manual. The Yamaha manuals for Motorcycle are available online for free. You can easily download all the documents as PDF.
Page 531
haha ABS (ANTI-LOCK BRAKE SYSTEM)8-82
Page 532
haha ABS (ANTI-LOCK BRAKE SYSTEM)8-83 EAS27750 ABS COUPLER LOCATION CHART R/B YW/LR/W BBr G/Y R/BBBr L/WR/W L/W R R/W R R B L W L/BDg YB/L L/W LgB Sb WW/R G/RW/L R Br/W B/W B BSb W/RLg WLB W WLBW W GDg Y/L ChB/WG/RR/WSb/WR/GY (GRAY) 1 2 3 4 5 6 7 8
Page 533
haha ABS (ANTI-LOCK BRAKE SYSTEM)8-84 1. Right handlebar switch coupler 2. Starter relay coupler 3. Main fuse coupler 4. ABS ECU coupler 5. ABS test coupler 6. Rear wheel sensor coupler 7. Front wheel sensor coupler 8. Meter assembly coupler
Page 534
haha ABS (ANTI-LOCK BRAKE SYSTEM)8-85 EAS27770 MAINTENANCE OF THE ABS ECU Checking the ABS ECU 1. Check:Terminals “1” of the ABS ECU Cracks/damage Replace the hydraulic unit assembly and the brake pipes that are con- nected to the assembly as a set. Terminals “2” of the ABS ECU coupler Defective connections/contamination/discon- nections Repair or clean.TIP If the ABS ECU coupler is clogged with mud or dirt, clean with compressed air. EAS27790 ABS TROUBLESHOOTING OUTLINE This section...
Page 535
![Page 535
haha ABS (ANTI-LOCK BRAKE SYSTEM)8-86
TIP
The ABS performs a self-diagnosis test for a few seconds each time the vehicle first starts off after the
main switch was set to “ ON”. During this test, a “ clicking” noise can be heard from under the rider seat,
and if the brake lever or brake pedal are even slightly applied, a vibration can be felt at the lever and
pedal, but these do not indicate a malfunction.
Special precautions for handling and servicing a vehicle equipped with A\
BS
NOTICE
ECA23P1050...](http://img.usermanuals.tech/thumb/83/49007/w300_2012-na-yamaha-super-tenere-service-manual-534.png "Page 535
haha ABS (ANTI-LOCK BRAKE SYSTEM)8-86
TIP
The ABS performs a self-diagnosis test for a few seconds each time the vehicle first starts off after the
main switch was set to “ ON”. During this test, a “ clicking” noise can be heard from under the rider seat,
and if the brake lever or brake pedal are even slightly applied, a vibration can be felt at the lever and
pedal, but these do not indicate a malfunction.
Special precautions for handling and servicing a vehicle equipped with A\
BS
NOTICE
ECA23P1050...")
haha ABS (ANTI-LOCK BRAKE SYSTEM)8-86 TIP The ABS performs a self-diagnosis test for a few seconds each time the vehicle first starts off after the main switch was set to “ ON”. During this test, a “ clicking” noise can be heard from under the rider seat, and if the brake lever or brake pedal are even slightly applied, a vibration can be felt at the lever and pedal, but these do not indicate a malfunction. Special precautions for handling and servicing a vehicle equipped with A\ BS NOTICE ECA23P1050...
Page 536
![Page 536
haha ABS (ANTI-LOCK BRAKE SYSTEM)8-87
EAS27810
BASIC PROCESS FOR TROUBLESHOOTING
[A] Set the main switch to “ON” and check the
ABS warning light.
[B-1] Does the ABS warning light fail to come on?
[B-2] Does the ABS warning light flash?
[B-3] Does the ABS warning light remain on?
[B-4] Does the ABS warning light come on for 2
seconds, then go off?
No malfunctions are
currently detected.
Connect the test coupler adapter
to the ABS test coupler, and then
check for past fault codes using
the ABS...](http://img.usermanuals.tech/thumb/83/49007/w300_2012-na-yamaha-super-tenere-service-manual-535.png "Page 536
haha ABS (ANTI-LOCK BRAKE SYSTEM)8-87
EAS27810
BASIC PROCESS FOR TROUBLESHOOTING
[A] Set the main switch to “ON” and check the
ABS warning light.
[B-1] Does the ABS warning light fail to come on?
[B-2] Does the ABS warning light flash?
[B-3] Does the ABS warning light remain on?
[B-4] Does the ABS warning light come on for 2
seconds, then go off?
No malfunctions are
currently detected.
Connect the test coupler adapter
to the ABS test coupler, and then
check for past fault codes using
the ABS...")
haha ABS (ANTI-LOCK BRAKE SYSTEM)8-87 EAS27810 BASIC PROCESS FOR TROUBLESHOOTING [A] Set the main switch to “ON” and check the ABS warning light. [B-1] Does the ABS warning light fail to come on? [B-2] Does the ABS warning light flash? [B-3] Does the ABS warning light remain on? [B-4] Does the ABS warning light come on for 2 seconds, then go off? No malfunctions are currently detected. Connect the test coupler adapter to the ABS test coupler, and then check for past fault codes using the ABS...
Page 537
![Page 537
haha ABS (ANTI-LOCK BRAKE SYSTEM)8-88
WARNING
EWA23P1019
When maintenance or checks have been performed on components related to the ABS, be sure
to perform a final check before delivering the vehicle to the customer. (Refer to “[D-3] FINAL
CHECK ” on page 8-121.)
EAS27830
[A] CHECKING THE ABS WARNING LIGHT
Set the main switch to “ ON”. (Do not start the engine.)
1. The ABS warning light does not come on. [B-1]
2. The ABS warning light flashes. [B-2]
3. The ABS warning light remains on. [B-3]
4. The...](http://img.usermanuals.tech/thumb/83/49007/w300_2012-na-yamaha-super-tenere-service-manual-536.png "Page 537
haha ABS (ANTI-LOCK BRAKE SYSTEM)8-88
WARNING
EWA23P1019
When maintenance or checks have been performed on components related to the ABS, be sure
to perform a final check before delivering the vehicle to the customer. (Refer to “[D-3] FINAL
CHECK ” on page 8-121.)
EAS27830
[A] CHECKING THE ABS WARNING LIGHT
Set the main switch to “ ON”. (Do not start the engine.)
1. The ABS warning light does not come on. [B-1]
2. The ABS warning light flashes. [B-2]
3. The ABS warning light remains on. [B-3]
4. The...")
haha ABS (ANTI-LOCK BRAKE SYSTEM)8-88 WARNING EWA23P1019 When maintenance or checks have been performed on components related to the ABS, be sure to perform a final check before delivering the vehicle to the customer. (Refer to “[D-3] FINAL CHECK ” on page 8-121.) EAS27830 [A] CHECKING THE ABS WARNING LIGHT Set the main switch to “ ON”. (Do not start the engine.) 1. The ABS warning light does not come on. [B-1] 2. The ABS warning light flashes. [B-2] 3. The ABS warning light remains on. [B-3] 4. The...
Page 538
![Page 538
haha ABS (ANTI-LOCK BRAKE SYSTEM)8-89
2. The ABS warning light flashes every 0.5 second for more than 6 seconds. The ABS warning light flashes every 0.5 second if no fault code for a past malfunction is stored in
the memory of the ABS ECU. If no fault code is indicated, make sure that the customer understands
the possible conditions that may cause the ABS warning light to come on \
or flash even if the system
is normal.
TIP
The test coupler adapter must be connected to the ABS test coupler to...](http://img.usermanuals.tech/thumb/83/49007/w300_2012-na-yamaha-super-tenere-service-manual-537.png "Page 538
haha ABS (ANTI-LOCK BRAKE SYSTEM)8-89
2. The ABS warning light flashes every 0.5 second for more than 6 seconds. The ABS warning light flashes every 0.5 second if no fault code for a past malfunction is stored in
the memory of the ABS ECU. If no fault code is indicated, make sure that the customer understands
the possible conditions that may cause the ABS warning light to come on \
or flash even if the system
is normal.
TIP
The test coupler adapter must be connected to the ABS test coupler to...")
haha ABS (ANTI-LOCK BRAKE SYSTEM)8-89 2. The ABS warning light flashes every 0.5 second for more than 6 seconds. The ABS warning light flashes every 0.5 second if no fault code for a past malfunction is stored in the memory of the ABS ECU. If no fault code is indicated, make sure that the customer understands the possible conditions that may cause the ABS warning light to come on \ or flash even if the system is normal. TIP The test coupler adapter must be connected to the ABS test coupler to...
Page 539
![Page 539
haha ABS (ANTI-LOCK BRAKE SYSTEM)8-90
2. BatteryCheck the condition of the battery.
Refer to “CHECKING AND CHARGING THE BATTERY ” on page 8-132.
If the battery is defective, clean the battery terminals and recharge it\
, or replace the battery.
3. Main fuse Check the fuse for continuity.
Refer to “CHECKING THE FUSES” on page 8-131.
If the main fuse is blown, replace the fuse.
4. Circuit
Check the meter assembly circuit.
Refer to “CIRCUIT DIAGRAM ” on page 8-79.
If the meter assembly circuit...](http://img.usermanuals.tech/thumb/83/49007/w300_2012-na-yamaha-super-tenere-service-manual-538.png "Page 539
haha ABS (ANTI-LOCK BRAKE SYSTEM)8-90
2. BatteryCheck the condition of the battery.
Refer to “CHECKING AND CHARGING THE BATTERY ” on page 8-132.
If the battery is defective, clean the battery terminals and recharge it\
, or replace the battery.
3. Main fuse Check the fuse for continuity.
Refer to “CHECKING THE FUSES” on page 8-131.
If the main fuse is blown, replace the fuse.
4. Circuit
Check the meter assembly circuit.
Refer to “CIRCUIT DIAGRAM ” on page 8-79.
If the meter assembly circuit...")
haha ABS (ANTI-LOCK BRAKE SYSTEM)8-90 2. BatteryCheck the condition of the battery. Refer to “CHECKING AND CHARGING THE BATTERY ” on page 8-132. If the battery is defective, clean the battery terminals and recharge it\ , or replace the battery. 3. Main fuse Check the fuse for continuity. Refer to “CHECKING THE FUSES” on page 8-131. If the main fuse is blown, replace the fuse. 4. Circuit Check the meter assembly circuit. Refer to “CIRCUIT DIAGRAM ” on page 8-79. If the meter assembly circuit...
Page 540
![Page 540
haha ABS (ANTI-LOCK BRAKE SYSTEM)8-91
Set the main switch to “ON ”, and then check the ABS warning light.
If the ABS warning light is on, the internal circuit of the meter assembly is defective. Replace the
meter assembly.
If the ABS warning light does not come on, the ABS ECU is defective. Replace the hydraulic unit
assembly.
8. The hydraulic unit assembly is defective.
EAS23P1054
[C-4] THE ABS WARNING LIGHT FLASHES
1. Check whether the T/C terminal (sky blue) of the ABS test coupler is...](http://img.usermanuals.tech/thumb/83/49007/w300_2012-na-yamaha-super-tenere-service-manual-539.png "Page 540
haha ABS (ANTI-LOCK BRAKE SYSTEM)8-91
Set the main switch to “ON ”, and then check the ABS warning light.
If the ABS warning light is on, the internal circuit of the meter assembly is defective. Replace the
meter assembly.
If the ABS warning light does not come on, the ABS ECU is defective. Replace the hydraulic unit
assembly.
8. The hydraulic unit assembly is defective.
EAS23P1054
[C-4] THE ABS WARNING LIGHT FLASHES
1. Check whether the T/C terminal (sky blue) of the ABS test coupler is...")
haha ABS (ANTI-LOCK BRAKE SYSTEM)8-91 Set the main switch to “ON ”, and then check the ABS warning light. If the ABS warning light is on, the internal circuit of the meter assembly is defective. Replace the meter assembly. If the ABS warning light does not come on, the ABS ECU is defective. Replace the hydraulic unit assembly. 8. The hydraulic unit assembly is defective. EAS23P1054 [C-4] THE ABS WARNING LIGHT FLASHES 1. Check whether the T/C terminal (sky blue) of the ABS test coupler is...