Xerox Workcentre 5020 B Manual

Replacing Consumables 
Xerox WorkCentre 5016/5020 User Guide 111
Checking the status of consumables
If the Drum Cartridge needs to be replaced in the near future, or toner levels fall below 
a certain threshold, the respective indicators on the Machine Diagram (mimic) light up. 
If the Drum Cartridge needs to be replaced immediately, or the toner has run out, 
respective error codes appear on the Display.
For more information on the Machine Diagram (mimic), refer to Machine Diagram (mimic) (P.90).
Adding...

Replacing Consumables 
Xerox WorkCentre 5016/5020 User Guide 112
The following procedure describes how to add toner to the Drum Cartridge.
1.Make sure that the machine is not 
processing a job, and then open the 
Front Cover.
2.Pull up the Left Side Cover Latch to 
open the Left Side Cover.
3.Lightly press the orange tab to unlock 
the Drum Cartridge.
WARNING
• Use a broom or a wet cloth to wipe off spilled toner. Never use a vacuum cleaner 
for the spills.
CAUTION
• Keep the Toner Bottle out of the...

Replacing Consumables 
Xerox WorkCentre 5016/5020 User Guide 113
4.Pull the Drum Cartridge out halfway.
Important • Do not touch the drum (blue roller) 
when pulling out the Drum 
Cartridge.
5.Take a new toner bottle out of the box.
6.Shake the toner bottle well about 15 
times. 
7.Position the toner bottle into the 
opening on the Drum Cartridge, and 
align the orange arrow of the toner 
bottle with that of the Drum Cartridge.
8.Turn the toner bottle around in a 
clockwise direction once, and align the...

Replacing Consumables 
Xerox WorkCentre 5016/5020 User Guide 114
10.Turn the toner bottle around in a 
counter-clockwise direction until the 
two orange arrows are aligned, and 
remove the toner bottle from the Drum 
Cartridge.
Note • Follow the instruction given on the 
packaging for recycling the empty 
toner bottle.
11 .Push in the Drum Cartridge until it locks into position.
12.Close the Left Side Cover and the Front Cover. 
Replacing the Drum Cartridge
The machine comes with a Drum Cartridge. The...

Replacing Consumables 
Xerox WorkCentre 5016/5020 User Guide 115
The following procedure describes how to replace the Drum Cartridge.
1.Make sure that the machine is not 
processing a job, and then open the 
Front Cover.
2.Open the Left Side Cover.
3.Lightly press the orange tab to unlock 
the Drum Cartridge.
4.Pull out the Drum Cartridge carefully.
Important • Do not touch the drum (blue roller) 
when pulling out the Drum 
Cartridge.
5.Take a new Drum Cartridge out of the 
box, and remove the...

Cleaning the Machine 
Xerox WorkCentre 5016/5020 User Guide 116
Cleaning the Machine
The cleaning instructions are specific to each part of the machine, such as the machine 
exterior, Document Cover, Document Glass, Film, Constant Velocity Transport Glass, 
Document Feeder Roller, and Corotron Wire.
This section describes how to clean each component of the machine.
Cleaning the Exterior
The following describes how to clean the exterior of the machine.
Important • Always switch off the power to the...

Cleaning the Machine 
Xerox WorkCentre 5016/5020 User Guide 117
Note • If dirt does not come off easily, gently wipe it with a soft cloth moistened with a small 
amount of neutral detergent.
Cleaning the Film and Constant Velocity Transport Glass
If the Film and Constant Velocity Transport Glass are dirty, streaks or smears may 
appear on copies, and the machine may not properly detect the size of the original 
documents. To ensure clean copies at all times, clean the Film and Constant Velocity...

Cleaning the Machine 
Xerox WorkCentre 5016/5020 User Guide 118
2.Turn the Document Feeder Roller to 
clean it with a soft cloth moistened with 
water.
Important • Do not use cleaning agents other 
than water or neutral detergent.
•Use a firmly wrung cloth to avoid 
water drops from falling onto the 
machine. If water gets into the 
machine, it may cause the machine 
malfunction.
Note • If dirt does not come off easily, 
gently wipe it with a soft cloth moistened with a small amount of neutral...

Xerox WorkCentre 5016/5020 User Guide 119
11 Appendix
This chapter provides the machine specifications, system settings menu list, optional 
accessory list.
Specifications
This section lists the main specifications of the machine. Note that the specifications 
and the appearance of the product may change without prior notice.
Copy Feature Specifications
Type Console
Copying method Laser Xerography
Scan resolution 600 x 600 dpi (23.6 x 23.6 dots/mm)
Output resolution 600 x 600 dpi (23.6 x 23.6 dots/mm)...

Specifications 
Xerox WorkCentre 5016/5020 User Guide 120
First copy output time
Important
•The values may vary 
depending on the 
machine configuration.
7.5 seconds*
*: When using A4 LEF or 8.5 x 11” LEF, zoom ratio 100%, 
Document Glass, Tray 1, and 1 sided.
Magnification Size-for-Size 1:1
±0.7%
Preset %
    Inch 1:0.500, 1:0.640, 1:0.785, 1:1.294, 1:2.000
    Metric 1:0.500, 1:0.707, 1:0.820, 1:1.414, 1:2.000
Variable % 1:0.5-1:2.00 (1% increments)
Continuous copy speed
Important
•The speed may be...