Xerox WorkCentre 4112 User Manual

Configuration
Xerox 4112/4127 Copier/Printer 2-5
System Administration Guide
f. Select Enable and then select Save.
3. If necessary, set the IP Address (Chapter 1 Setting the IP address on page 1-11).
4. Exit the System Administrator Mode (Chapter 1 Exiting the System Administrator mode on 
page 1-11).
5. After the machine is restarted, print out the Printer Settings List to confirm that the SMB 
port is enabled.
Note
If using the NetBEUI protocol, select NetBEUI as the protocol used by SMB for the port...

Configuration
2-6   System Administration Guide
Xerox 4112/4127 Copier/Printer
Notes
• The configuration can also be performed using IP configuration tools included in 
CentreWare Internet Services or CentreWare Utilities. Refer to “Using CentreWare Internet 
Services”
• Enable the SOAP port and the SNMP port in most cases.
1. Enter the System Administrator Mode (Chapter 1 Entering the System Administrator mode 
on page 1-10.)
2. Enable the IPP port.
a. Select System Settings.
b. Select Connectivity &...

Configuration
Xerox 4112/4127 Copier/Printer 2-7
System Administration Guide
Configuration on the machine (EtherTalk)
This section describes the configuration procedure to connect the machine to EtherTalk 
network.
Enable the EtherTalk port
Note
The configuration can also be performed using CentreWare Internet Services or CentreWare 
Utilities. Refer to “Using CentreWare Internet Services”.
Note
Enable the SOAP port and the SNMP port in most cases.
1. Enter the System Administrator Mode (Chapter 1...

Configuration
2-8   System Administration Guide
Xerox 4112/4127 Copier/Printer
Downloaded From ManualsPrinter.com Manuals 

Xerox 4112/4127 Copier/Printer 3-1
System Administration Guide
3
Using CentreWare 
Internet Services
 
Preparations
Tip
The User Interface (UI) screens shown in this guide may or may not reflect the screens 
displayed on your system. The UI screens vary from system to system and from marketplace to 
marketplace. Therefore, the UI screens in this guide are a representation of the type of screens 
that may be seen on your particular system.
The following items are needed to use CentreWare Internet...

Using CentreWare Internet Services
3-2   System Administration Guide
Xerox 4112/4127 Copier/Printer
Configuration on the machine
This section describes the configuration procedure for using CentreWare Internet Services on 
the machine.
First enable the Internet service port, then set the IP address.
1. Enter the System Administrator Mode (Chapter 1 Entering the System Administrator mode 
on page 1-10.)
2. Enable either the LPD port or the Port 9100 port as appropriate. In this example, the LPD 
port is...

Using CentreWare Internet Services
Xerox 4112/4127 Copier/Printer 3-3
System Administration Guide
Notes
• If your network uses DNS (Domain Name System) and host name for the machine is 
registered with the domain name server, you can access the device using a combination of 
the host name and the domain name as the "Internet address." For example, if the host 
name is "dcf1100", and the domain name is "mycompany.com", then the "Internet address" 
becomes...

Using CentreWare Internet Services
3-4   System Administration Guide
Xerox 4112/4127 Copier/Printer
The following browsers have been confirmed to operate with CentreWare Internet Services:
For Windows
• Microsoft Internet Explorer ver.6.0 Service Pack 1 (SP1) or later.
• Netscape 7.0 or later.
For MacOS 10.2 or later
• Microsoft Internet Explorer 5.2 or later.
• Netscape 7.0 or later.
Ethernet
This section describes the settings for the Ethernet interface.
1. Connect to CentreWare (See Chapter 3 Connect...

Using CentreWare Internet Services
Xerox 4112/4127 Copier/Printer 3-5
System Administration Guide
EtherTalk
This section describes the settings for EtherTalk.
1. Connect to CentreWare (See Chapter 3 Connect to CentreWare Internet Services from a 
computer on page 3-2).
2. Click the Properties tab.
3. Click + on the left of Connectivity and + on the left of Protocols to display the items in the 
fo ld er.
4. Click the EtherTalk.
5. Set the Printer Name.
6. Set Zone Name.
7. Reflect the values as the...

Using CentreWare Internet Services
3-6   System Administration Guide
Xerox 4112/4127 Copier/Printer
d. Click Reboot. The machine will reboot and the setting value will be reflected.
Microsoft Networking (SMB)
This section describes the settings for Microsoft Networking.
1. Connect to CentreWare (See Chapter 3 Connect to CentreWare Internet Services from a 
computer on page 3-2).
2. Click the Properties tab.
3. Click the Properties tab.
4. Click + on the left of Connectivity and + on the left of Protocols...