Xerox Synergix 510dp User Manual

OFF-LINE SETUP MENU
XEROX WIDE FORM AT 510dp OPERATOR MANUAL21
Table 1.  Printer Menu options (continued)
Option Sub-option Function
TEST PLOT Allows you to run a test print in off-line mode
from each media source.  The selections are
ROLL 1, ROLL 2, ROLL 3, and BYPASS.
PRINTER DIAGNOSTICS Reserved for use by the service
representative and is password protected.
DIAGNOSTICS
RECENT FAULT LOG Displays a record of the last 99 printer faults.
You may be asked to provide information from
this log when placing...

OFF-LINE SETUP MENU
22XEROX WIDE FORM AT 510dp OPERATOR MANUAL
Accessing the Printer Menu
Note: If there is a Scanner connected, the message displayed will
be SYNERGIX CS 510dp.  If there is no Scanner connected the
message will be SYNERGIX PS 510dp.
To access the Printer Menu:
1. Press the On-line/Off-line key to enter off-line mode.
•  The on-line/off-line indicator will go out.
•  The display will indicate  SYNERGIX CS 510dp PAUSED
or SYNERGIX PS 510dp.
2. Press the Enter key to access the SYNERGIX CS...

OFF-LINE SETUP MENU
XEROX WIDE FORM AT 510dp OPERATOR MANUAL23
Setting the timers
To set the Power Saver mode and Rest mode timers:
1.  Access the PRINTER MENU.  See Accessing the Printer
Menu in this chapter.
2. Press the Previous or Next key until TIMERS is displayed.
3. Press the Enter key to select TIMERS.  The current setting for
the READY TO POW ER SAVER option is displayed.
4.  Do one of the following:
•  To select the READY TO POWER SAVER option, press
the Enter key.
•  To select the POW ER SAVER...

OFF-LINE SETUP MENU
24XEROX WIDE FORM AT 510dp OPERATOR MANUAL
Specifying the finisher configuration type
Note: If there is a Scanner connected, the message displayed will
be SYNERGIX CS 510dp.  If there is no Scanner connected the
message will be SYNERGIX PS 510dp.
To specify the finisher configuration type:
1. Access the PRINTER MENU.  See Accessing the Printer
Menu in this chapter.
2. Press the Previous or Next key until FINISHER SETTINGS is
displayed.
3. Press the Enter key to select FINISHER...

OFF-LINE SETUP MENU
XEROX WIDE FORM AT 510dp OPERATOR MANUAL25
•  The display will indicate  SYNERGIX CS 510dp IDLE or
SYNERGIX PS 510dp
Viewing the recent fault log
Note: If there is a Scanner connected, the message displayed will
be SYNERGIX CS 510dp.  If there is no Scanner connected the
message will be SYNERGIX PS 510dp.
To view the recent fault:
1. Access the PRINTER MENU.  See Accessing the Printer
Menu in this chapter.
2. Press the Previous or Next key until DIAGNOSTICS is
displayed.
3. Press the...

OFF-LINE SETUP MENU
26XEROX WIDE FORM AT 510dp OPERATOR MANUAL
This page has been intentionally left blank.
Downloaded From ManualsPrinter.com Manuals 

XEROX WIDE FORM AT 510dp OPERATOR MANUAL27
5. Care
The printer requires a minimum of operator maintenance.  You will
need to replace the toner cartridge and toner waste bottle when
the cartridge empties.  You also will need to clean the outside
surface of the printer when necessary.
This chapter provides the procedures for performing the required
tasks and for ordering supplies.
When the toner cartridge needs replacement
When the toner cartridge is empty, the following occur:
•  The toner supply access...

CARE
28XEROX WIDE FORM AT 510dp OPERATOR MANUAL
Replacing the toner cartridge
To replace the toner cartridge:
CAUTION:  Toner identified for use in the XEROX Wide Format
510dp is a two-component material made specifically for this
printer.  Use of toner not identified for the XEROX Wide Format
510dp will damage the printer.
1.  Open the replacement toner carton.
•  Remove the replacement toner cartridge.
•  Remove the replacement toner waste bottle.
•  Save all the replacement toner packaging for...

CARE
XEROX WIDE FORM AT 510dp OPERATOR MANUAL29
6.  Carefully lift the used toner cartridge out of the printer.
•  Try not to tilt the cartridge too much to avoid toner
spillage.
7.  Wipe any excess toner off the used toner cartridge.
8.  Seal the used toner cartridge dispenser patch with tape.
9.  Place the used toner cartridge in the empty replacement toner
carton.
•  Do not seal the carton until you have added the toner
waste bottle to it as well.  Recycle the used cartridge and
waste bottle according...

CARE
30XEROX WIDE FORM AT 510dp OPERATOR MANUAL
12.  Lower the toner cartridge into position while pushing the
plunger to the left.
13.  Release the plunger.
14.  Rotate the toner cartridge back and forth until the cartridge
locks into position.
CAUTION:  Remove the cover tape carefully.  Do not remove the
clear, perforated seal.
15.  Remove the cover tape from the toner cartridge.
•  Do not remove the seal under the tape.
16.  Slide the gold cartridge dispenser patch cover to the right to
conceal the...