Vodavi Starplus 616ex Electronic Key System Installation Manual

STARPLUS 616EX ISSUE 2 JULY 1,1987 
Code 41 -Allow Table A 
11 
Bin 12 1 
’ I 
Bin 13 
I 
Bin 14 
/ 
I 
, 
I 
I I 
I I 
I I 
Bin 15 ! I 
I I 
I I I 
1 Bin 16 / I I I I I I I I I I 
I I I 
I I I I 1 
Code 42 -Deny Table A Digits 
I 
I I I I 
i 
I 
Code 43-Allow Table B Digits 
5-24 
Code 44-Deny Table B  

STARPLUS Si SEX ISSUE 2 JULY 1,1987 
SO0 FUNCTIONAL TEST PROCEDURES 
This section describes the procedures that should 
be followed during system start-up. The installer will 
also find these tests to be helpful in the event of 
system malfunction and trouble shooting. 
System trouble shooting will be confined to 
replacement of key telephone sets and fuses. 
600.1 
PRELIMINARY CHECKLIST 
, 
Before starting the functional test procedures it is 
recommended that the following checklist be com- 
pleted....

STARPLUS 616EX ISSUE 2 JULY I, 1987 
600.2 
KEY STATION TESTING (Cont.) 
OPERATIONAL TEST 
5. 
Tone ringing volume. 
NOTE: Instrument must be 
in tone signaling 
mode. 
5.1 From another instrument 
place an intercom call to 
set under test. 
5.2 Adjust the tone volume. 
6. Transmitting of Data Signals. 
6.1 When incorrect or no data 
signals are transmitted 
between KSU and 
instrument. 
RESULT PROCEDURE 
5.1 .1 Warble tone is heard. 5.1.1 Normal 
Adjust volume. 
5.1.2 Warble tone is not heard. 5.1.2...

STARPLUS 616EX ISSUE 2 JULY I,1987 
600.3 INTERCOM FUNCTIONS TEST 
OPERATIONAL TEST 
Intercom Call 
Depress the DSS button 
for 
the desired instrument. 
a. If the called instrument is 
a speakerphone and is 
placed in the handsfree 
talk back (voice) mode. 
If the called station answers 
by lifting the handset. 
Call Pick-Up 
Lift Handset and depress 
DSS button for called 
station. 
To answer at another 
station, lift the handset or 
depress the ON/OFF 
button. 
Depress 6 on the 
dial pad. T 
RESULT 
1...

STARPLUS 616EX ISSUE 2 JULY 1,1987 
600.3 INTERCOM FUNCTIONS TEST (Cont.) 
___ 
OPERATIONAL TEST RESULT PROCEDURE 
1.4 Intercom-Conference 
a. During an intercom 
conversation, depress 
the CONF button. 
b. Depress the DSS button 
for another party. 
(3rd instrument) 1.4.a Party goes on HOLD. 
1.4.b No change. 
Busy tone is heard. 1.4.a Normal 
1.4.b Normal 
The 3rd instrument is busy 
or not installed; Normal. 
c. When third party answers, / 1.4.~ Ringing tone is heard. 1.4.~ Normal 
depress CONF...

STARPLUS 616EX ISSUE 2 JULY 1,1987 
^ 
600.4 CO LINE FUNCTIONS TEST 
OPERATIONAL 
TEST 
RESULT PROCEDURE 
1. Outgoing Calls 
1.1 Lift the handset or depress 
the ON/OFF button and 
depress a CO line button. 
2. Incoming Calls 
2.1 Incoming CO ringing. 1 .l .1 The CO line lamp is lit 1 .l .l Normal 
steady. 
1 .l .2 Dial tone is heard. / 1.1.2 Normal 
1 .1 .3 CO lamp is not lit. 
I 1 .l .3 Check line access Programming 
1 .1.4 Dial tone is not heard. ) 1 .1.4 Check the connections 
of CO line at RJl 1 C...

STARPLUS 616EX ISSUE 2 JULY 1,1987 
600.4 CO LINE FUNCTIONS TEST (Cont.) 
OPERATIONAL 
TEST RESULT PROCEDURES 
4. 
Add-On-Conference 
4.1 During a CO line 
conversation, depress the 
CONF button then depress 
the DSS button for station 
desired. 
Press CONF again. 4.1 .l The CO line is placed on 
HOLD. 
4.1.2 The three parties are 
connected for conferencing. 
4.1.3 At the 1 st station: 
The CO line lamp is 
lit steady. 
4.1.4 2nd station: 
The CO line lamp is 
lit steady. 4.1 .l Normal 
4.1.2 Normal...

STARPLUS 616EX ISSUE 2 JULY 1,1987 
700 MAINTENANCE AND TROUBLESHOOTING 
700.1 GENERAL INFORMATION 
700.2 INTRODUCTION 
This section provides common maintenance, trouble 
shooting and repair instructions for the STARPLUS 
Key Telephone System. It is advisable to use the 
latest issue manual and supporting documentation 
whenever possible. 
< 
The 616 architecture is designed such that all 
solid 
state 
circuitry is enclosed in the KSU. There are no 
modular or replaceable type printed circuit cards...

STARPLUS 616EX ISSUE 2 JULY I,1987 
700.9 SYSTEM FAILURES 
Various problems will affect the entire system. 
These are normally related to power failures, central 
processor failures, or memory failures. Where central 
processor or memory failures occur, the KSU must 
be replaced. When loss of power occurs, steps can 
be taken to localize the problem. 
700.10 
POWER FAILURES 
The loss of commercial power will shut the system 
down, unless external battery back-up is provided. 
This loss of power could...

. 
L 
I 
-l---r 
CPU MODULE 
1. CPU 
2. RAM’S 
3. ROM’S 
4. DECODE 
5. CLOCK 
6. RECOVERY RELAY DRIVER I~---------~ LOUD BELL CTL 
SELtCT 
I r CMOS SWITCH 4 
, 
1 
INTERCOM 1 
CHANNELS , 
C6 
------------,6 
1 RING DETECT 1 i 1 
1 1 VOICE SIGNAL  3 CHANNEL 
PARALLEL 
IN/OUT 
PI0 
SELECT 
DATA COMMUNICATION 
PATH MULTIPLEXER 
I 16 KEY STATION INTERFACES 
I 
STAR PLUS SYSTEM BLOCK DIAGRAM 
FIGURE 7.1 
6C0 
LINE 
INTERFACES