Home
>
Vodavi
>
Communications System
>
Vodavi Infinite Dvx Iii Hybrid Key Telephone System Installation Manual
Vodavi Infinite Dvx Iii Hybrid Key Telephone System Installation Manual
Here you can view all the pages of manual Vodavi Infinite Dvx Iii Hybrid Key Telephone System Installation Manual. The Vodavi manuals for Communications System are available online for free. You can easily download all the documents as PDF.
Page 121
infinite m Digital SystemsTF NO: 58 Tl Trunk Card (Cmt’d) Tl Orderirg information: When ordering a Tl circuit from a carrier, request D4 framing and Alternate Mark Inversion (AMI) Line coding using the superframe (SF). The following are additional ordering information specif@ations:If orderirg:ANIIDNIS/DID/E&MLoop’Ground Start Signalihg * Circuit Information2 wire2 wire Supervisory SignalingE&MLoop or Ground Address SignalingDTMFDTMF Start Dial IndicatorWinkstartDial Tone l ANVDNIS not available on...
Page 122
infinite TM Digiil SystemsTF NO: 58 Tl Trunk Card (Cont’d) operatim The input and output of the Tl trunk card is designed to connect to an external Channel Service Unit (CSU). The Tl kit consists of a Tl trunk card, a stand-alone CSU, power supply for the CSU, and the three cables needed for installation. One CSU and one Tl trunk card are required for each Tl circuit (24channels) from the central Office. The Tl trunk card provides a receive clock recovery output which is connected to the system Voice...
Page 123
Tl Spans NO CSU Required DVX”‘SYSTEMT1- Icsu I ’Fractional Tl Span Figure 1 Tl Trunk Card Configurations infinite m Digital SystemsTF NO: 58 Tl Trunk Card (Cont’d)Page 5 of 46TF NO. 58 83alLRaMreetwe~kR6ll(=1-m
Page 124
idnite n~ Digiil SystemsTF NO: 58 Tl Trwrk Card (Cont’d) Tl LED lnfonnation The Tl trunk card has six (6) LED’s mounted on the edge of the card for troubleshooting purposes. These LED’s either light or flash to indicate a variety of conditions on the Tl circuit. LEDCOLORSTATE FUNCTIONCONDITION DSlGreenLIT+5 Volt dc indicationNormal operation mode DS2RedNormal =not LitReceive Carrier LossNo bits have been received by Tl for Fw156ms. Outgoing calls cannot be made. Solid indicates RCL DS3Red Normal=not...
Page 125
iniinife TM Digital SystemsTF NO: 58 Tl Trurh Card (Cont’d) 1.Four (4) Tl trunk cards may be installed in the system to provide the maximum 96 trunk capability. 2.The installer must program the Tl trunk card type in system programming (Flash 24). The Tl trunk card does not function by simply plugging it into a system card slot. Once programmed, the slot immediately to the left is automatically marked as deleted (vacant). If a card exists in that slot, it Ceases to function after the Tl trunk card is...
Page 126
Mnite TM Diiital SystemsTF NO: 58 Tl Tnrnk Card (Cti’d) InstaIWan of SRAM (Static RAM) Ch@s on hia!& DVX “’ Digiil System: The Central Processor Unit (CPU) of the infinite DVX “1Digitj\,System has two l-Megabyte SHAM chips On it which determine the amount of RAM used by the infinite DVXDigital Key Telephone System. To upgrade the SRAM chips, the SRAMs must be removed and the new SHAMS installed in their place. Refer to Figure 2 for switch and chip locations.TO RFMOVF FXISTING SEAM CHIPS; Before...
Page 127
infinite rm Digital SystemsTF NO: 58 Tl Tnrnk Card (Cortt’d) Figure 2 Central Processing Unit (CPU)Page 9 of 46TF NO. 58 mLRiaRfwolivelkdtd&R65260WQ)W~
Page 128
hifnife m Diiltal SystemsTF NO: 58 Tl Trud Card (Coded) Installation of Tl trunk and Chsmel Service Unit The installation of a Tl circuit can be broken down into the following main phases: 1.Install the Tl trunk card in the system. 2.Program the Tl circuit channels (lines) using System Programming. 3.Mount the Channel Service Unit (CSU) and connect it to the trunk card, 4.Connecting the Tl circuit to the CSU. Pre-Installation Requirements: 0Be sure that the SBAM on the Central Processing Unit (CPU) has...
Page 129
M&e TM Digital SystemsTF NO: 58 Tl Truk Card (Cont’d) Figure 3 Tl Trunk Card Pagellof 46TF NO. 58
Page 130
White TM Digital SystemsTF NO: 58 Tl TN& Card (Coded) 1. 1. hstall the Tl trur& csrd h the system. Set all switches on the edge of the Tl trunk card to OFF. This selects D4 or Super-frame framing and Alternate Mark Inversion (AM) line coding. These switches are intended for future use to select the desired framing and format type and must be set to the OFF position.See the Tl trunk card illustration. 2.Install the Tl trunk card in one of the trunk card slots.Do not hstall a twk cstd in the slot to the...