Vivitek Projector D8800 Series User Manual

11
DLP Projector - User’s Manual
KEYPAD
MENUEXIT
POWER
INPUTAUTO SYNC ASPECT OPENCLOSE
S HUTTER
LENS
SHIFT FOCUS
ZOOM
 
y POWER
Use the button to turn on/off the projector.
 
y INPUT
Press to select a video source. HDMI, DVI, VGA, Component / BNC Composite, S-Video or 3D-SGI.
        Press this to re-acquire the current active source.
 
y ASPECT
Press this to change the aspect ratio of the current image.
 
y SHUTTER
Use the buttons to turn on/off shutter.
 
y MENU
Press this button to show or hide the...

DLP Projector - User’s Manual
12
 
y ON
Use this button to turn the projector on. 
 
y OFF
Use this button to turn the projector off. 
 
y FOCUS
Focuses the projected images.
 
y ZOOM
Zoom in/out the projected image.
 
y TEST PATTERN
Use this to enter test pattern menu.
 
y LENS SHIFT
Button to shift control of the lens, up/down or left/right.
 
y ENTER, , , , 
Use these buttons to select items or settings, adjust settings or switch 
display patterns. ENTER: Press to select a highlighted menu item or...

13
DLP Projector - User’s Manual
To install batteries in the remote control
STEP 1STEP 2STEP 3
1. Slide the battery compartment cover in the direction of the arrow to remove it. 
2.  Install two AA batteries with the correct polarity. 
3.  Replace the cover.
Notes on Batteries
 
y Make sure that the battery polarities are correct when installing the batteries. 
 
y Do not mix an old battery with a new one or different types of batteries. 
 
y If you will not use the remote control for a long time, remove...

DLP Projector - User’s Manual
14
Installation Considerations
Proper installation of your projector will ensure the quality of your display. Whether you are installing a projec-
tor temporarily or permanently, you should take the following into account to ensure your projector performs 
optimally.
Ambient Light
In general, minimize or eliminate light sources directed at the screen. Contrast ratio in your images will be noticeably 
reduced if light directly strikes the screen, such as when a shaft of light...

15
DLP Projector - User’s Manual
Modes of installation
 
„ Frontal projection - desktop installation
Advantages:    easy to install can be easily moved or adjusted 
easy to operate.
Disadvantage:   occupies floor space and limits seating 
capacity.
Projec tor
 
„ Rear projection - desktop installation
Advantage:    the projector is completely hidden from plain 
view the projector can be easily operated this 
setup usually offers better reduction of ambi-
ent noise.
Disadvantage:   requires an...

DLP Projector - User’s Manual
16
Allow at least 50 cm clearance around the exhaust vent.
The device need to have enough space to prevent issues as stated in this image.
Side Way
50cm
Or Greater
50cm
Or Greater
Back Side
70cm
Or Greater
Celling Mount
30cm
Or Greater   

17
DLP Projector - User’s Manual
Lens Shift
Vertical Lens Shift
The D8800/D8900/D8010W have a lens shift capability which allows the vertical movement of the image without mov-
ing the projector. Lens shift is generally expressed as a percentage of the screen height. For ceiling mounted projectors, 
the lens can be moved 50% (0.6V) downward, while the lens can be moved 50% (0.6V) up or down on a desktop mount -
ed projector.
Desktop Front Projection
Height of projected image
Vertical Shift
Max.
0.5VMax....

DLP Projector - User’s Manual
18
Connecting the projector to other devices.
Proceed as follows to connect the D8800/D8900/D8010W to your video sources, external controller(s) - if present - and 
AC power. When connecting your equipment: •Use the correct signal cables for each source. •Ensure that the cables are 
securely connected. Tighten the thumbscrews on connectors that have them. Connecting Source Components to the 
D8800/D8900/D8010W Connect your video sources to the D8800/D8900/D8010W as shown and...

19
DLP Projector - User’s Manual
IR Input connection
If infrared signals from the remote control cannot reach the projector due to excessive distance or obstructions such as 
walls or cabinet doors, you can connect an external IR repeater system to the IR INPUT on the D8800/D8900/D8010W to 
extend the range of the remote control.
IR sensor
IR repeater
Remote control
B/Pb G/YR /Pr
VH WIRED REMOTE
TRIGGER
RS-232 S-VIEDOV
IEDO
S-VIDEO, VIDEO connection
If the image input device offers both S-Video and Video...

DLP Projector - User’s Manual
20
COMPONENT connection
Take the 3/5 cabled RGB component video connectors from the source equipment to the projector’s COMPONENT jacks.
INSDI OUT
LAN HDMI
DVI-D
RGB B/Pb
G/YR /Pr
VH WIRED REMOTE
TRIGGER
RS-232 S-VIEDOV
IEDO
DTV set-top-box or other compo-
nent (YPbPr) input source
YPbPr
RS-232 Connection
Connect a PC or home theater control/automation system (if present) to the RS-232 port on the D8800/D8900/D8010W. 
Use a standard, 9-pin serial cable, wired...