Vivitek Projector D8800 Series User Manual

							User’s Manual
D8800 Series 
						

							Contents
COPYRIGHT INFORMATION 4
 
y Copyright   4
 
y Disclaimer   4
 
y About this manual   4
IMPORTANT SAFETY INSTRUCTIONS 5
 
y Disposal of old electrical and electronic equipment   6
 
y Important Recycle Instructions:   6
INTRODUCTION 7
 
y About This Manual  7
 
y Description, Features and Benefits  7
 
y Parts List   8
CONTROLS AND FUNCTIONS 9
 
y D8800/D8900/D8010W at a Glance  9
 
y I/O Panel  10
 
y KEYPAD 11
 
y Remote control  12
 
y To install batteries in the remote control  13
 
y Range of effective remote control signal reception  13
Installation Considerations 14
 
y Ambient Light   14
 
y Throw Distance  14
 
y Modes of installation  15
 
y Allow at least 50 cm clearance around the exhaust vent.  16
Lens Shift  17
 
y Vertical Lens Shift   17
 
y Horizontal Lens Shift   17
Connecting the projector to other devices. 18
 
y HDMI Connection  18
 
y Trigger connection  18
 
y IR Input connection  19
 
y S-VIDEO, VIDEO connection  19
 
y COMPONENT connection  20
 
y RS-232 Connection  20
 
y LAN Connection  21
Start using the projector - Adjustments 22
 
y Connecting to AC Power  22
 
y Turning on the Power  22
 
y Changing the OSD Language  23
 
y Adjusting the Picture Orientation  23
 
y Lens Adjustments  24 
						

							Start using the projector - Operation 25
 
y Selecting An Input Source  25
 
y Selecting an Aspect Ratio  25
 
y Using the OSD  25
Start using the projector - OSD Introduction 26
 
y OSD Menu Tree  26
 
y OSD Introduction - INPUT  28
 
y OSD Introduction - PICTURE  31
 
y OSD Introduction - LAMPS  34
 
y OSD Introduction - ALIGNMENT  35
 
y OSD Introduction - CONTROL  39
 
y OSD Introduction - SERVICE  45
Change Lamp 47
 
y To replace the projector lamp1  47
 
y To replace the projector lamp2  48
Change Lens 49
 
y To replace the projector Lens  49
Change Filter 51
 
y To replace the Filter on the left side of the projector  51
 
y To replace the Filter on the right side of the projector  52
LED Status 53
 
y Power LED  53
 
y Status LED  53
 
y Lamp1/Lamp2 LED  53
 
y Temp LED  53
 
y Shutter LED  53
SPECIFICATIONS 54
SERIAL INTERFACE SPECIFICATIONS 55
 
y Transfer Specifications  55
 
y RS-232 Commands  55
 
y IR Codes and Key names  55
 
y Operations Commands  56
Dimensions 62
Supported Timings 63
Projection Distance and Screen Size  64
 
y D8800 64
 
y D8900 67
 
y D8010W 70 
						

							DLP Projector - User’s Manual
4
COPYRIGHT INFORMATION
Copyright 
This publication, including all photographs, illustrations and software, is protected under international copyright laws, 
with all rights reserved. Neither this manual, nor any of the material contained herein, may be reproduced without writ-
ten consent of the manufacturer. The Vivitek logo is a trademark of “Vivitek Corporation.” © Copyright 2012
Disclaimer 
The information in this document is subject to change without notice. The manufacturer makes no representations or 
warranties with respect to the contents hereof and specifically disclaims any implied warranties of merchantability or 
fitness for any particular purpose. The manufacturer reserves the right to revise this publication and to make changes 
from time to time in the content here without obligation of the manufacturer to notify any person of such revision or 
changes.
About this manual 
This manual is intended for end users and describes how to install and operate the DLP projector. Wherever possible, 
relevant information such as an illustration and its description has been kept on one page. This printer-friendly format is 
both for your convenience and to help save paper, thereby protecting the environment. It is suggested that you only print 
sections that are relevant to your needs.   
						

							5
DLP Projector - User’s Manual
IMPORTANT SAFETY INSTRUCTIONS
Thank you for your purchase of this quality product! For best performance, please read this manual carefully as it is your 
guide through the menus and operation.1.  Read and Keep these instructions.
2.  Heed all warnings.
3.  Follow all instructions.
4 .  Do not use this apparatus near water. And not install near any heat sources such as radiators, heat registers, 
stoves, or other apparatus (including amplifiers) that produce heat.
5 . Clean only with a dry cloth.
6.  Do not block any of the ventilation openings. Install in accordance with the manufacturer’s instructions.
7.   Do not defeat the safety purpose of the polarized or grounding type plug. A polarized plug has two blades with 
one wider than the other. A grounding type plug has two blades and a third grounding prong. The wide blade or 
the third prong is provided for your safety. When the provided plug does not fit into your outlet, consult an electri-
cian for the replacement of the obsolete outlet.
8.  Protect the power cord from being walked on or pinched particularly at plugs, convenience receptacles and the 
point where they exit from the apparatus.
9.  Only use the attachments/accessories specified by the manufacturer.
10.  Use only with a cart, stand, tripod, bracket or table specified by the manufacturer or sold with the apparatus. 
When a cart is used, use caution when moving the cart/apparatus to avoid injury from tip-over.
11. Unplug this apparatus during lightning storms or when unused for long periods of time.
12.  Refer all servicing to qualified service personnel. Servicing is required when the apparatus has been damaged in 
any way, such as power supply cord or plug is damaged, liquid has been spilled or objects have fallen into the ap-
paratus, the apparatus has been exposed to rain or moisture, does not operate normally, or has been dropped. 
13.  The +12V trigger only outputs 12V DC signal for triggering. Do not connect to any other power input or output. 
This could cause damage to this unit.
14 .  Keep the packing material in case the equipment should ever need to be shipped.
15 .  Never look into the lens when the projector is on.
AVOID EYE CONTA CT TO  THE LIGHT   
						

							DLP Projector - User’s Manual
6
Disposal of old electrical and electronic equipment
(Applicable throughout the European Union and other European countries with separate collection programs) This symbol found on your product or on its packaging, indicates that this product should not 
be treated as household waste when you wish to dispose of it. Instead, it should be handed 
over to an applicable collection point for the recycling of electrical and electronic equipment. By 
ensuring this product is disposed of correctly, you will help prevent potential negative conse-
quences to the environment and human health, which could otherwise be caused by inappro-
priate disposal of this product. The recycling of materials will help to conserve natural resources. 
This symbol is only valid in the European Union. If you wish to discard this product, please 
contact your local authorities or dealer and ask for the correct method of disposal.
  
Important Recycle Instructions:
Lamp(s) inside this product contain mercury. This product may contain other electronic waste 
that can be hazardous if not disposed of properly. Recycle or dispose in accordance with local, 
state, or federal Laws. For more information, contact the Electronic Industries Alliance at  WWW.
EIAE.ORG.  For lamp specific disposal information check  WWW.LAMPRECYCLE.ORG.   
						

							7
DLP Projector - User’s Manual
INTRODUCTION
About This Manual
This User’s Manual describes how to install, set up and operate the D8800/D8900/D8010W. Throughout this manual, 
the Projector is referred to as the “D8800/D8900/D8010W.”
Target Audience Vivitek has prepared this manual to help installers and end users get the most out of the D8800/
D8900/D8010W. Vivitek has made every effort to ensure that this manual is accurate as of the date it was printed. How -
ever, because of ongoing product improvements and customer feedback, it may require updating from time to time. You 
can always find the latest version of this and other Vivitek product manuals on-line, at www.vivitekcorp.com.
Description, Features and Benefits
The Vivitek D8800/D8900/D8010W provide state-of-the-art technology for full HD (1920 x 1200, WUXGA 16:10) native 
resolution for crystal clear, pristine images. The D8800/D8900/D8010W offer incredibly high definition images at to-
day’s highest avail-able resolutions. Equipped with precision optics, the D8800/D8900/D8010W include zoom, focus and 
lens shift controls for a throw range of 1.85:1 to 2.40:1. For a smaller throw distance (1.56:1 to 1.86:1), the D8800/D8900/
D8010W can be fitted with a varying optics package (optional) to meet different requirements. Exceptional scaling and 
film-to-video (3:2 pull-down) conversion is easily achieved. Combined with Vivitek’s sophisticated parameters for white 
balancing, the D8800/D8900/D8010W’s proprietary de-interlacing technology provides the highest level of develop-
ment for gray-scale and color balancing and artifact-free images. Completing this engineering marvel are discrete infra-
red (IR) and RS-232 control, power and source selection controls for seamless, flexible operation.
 
„ Key Features and Benefits
The D8800/D8900/D8010W offer these key features and benefits:
 
y Native Resolution: 1920 x 1080 (16:10 Native Aspect Ratio).
 
y DLP system using high-performance Digital Micromirror Device (DMD).
 
y HDMI 1.3 Input with High-bandwidth Digital Content Protection (HDCP).
 
y HDTV Compatible.
 
y Excellent Video Processing on progressive and interlaced video inputs.
 
„ Green Product with:
 
y Lead free solder used for soldering including circuit and component electronics.
 
y Lead free glasses and coatings.
 
y Recycled paper used in the user manuals and packing cartons.
 
y Energy Saving: High efficiency power switching and less than 0.5W power consumption in standby mode.   
						

							DLP Projector - User’s Manual
8
 
„ Additional Features of the D8800/D8900/D8010W 
 
y Horizontal and vertical lens shift.
 
y Keystone adjustment.
Parts List 
Your D8800/D8900/D8010W is shipped with the following items, if any items are missing or damaged, please contact 
your dealer or Vivitek Customer Service.
Accessory Box List D8800/D8900/D8010W
Item Manual Assy Q’tyEU/ASIA/US/TWN China
1 CD-ROM 1
● ●
2 WARRANTY CARD (US/EUR) 1
● -
3 WARRANTY CARD (CN) 1-
●
4 RoHS Card (CN) 1-
●
5 QC Pass Card (CN) 1-
●
6 Important Information (CN) 1
● ●
7 POWER CORD 125Vac USA 1
● -
8 POWER CORD 250Vac EUR 1
● -
9 POWER CORD 250Vac CHINA 1-
●
10 VGA Signal cable 1
● ●
11 SCREW M M4*0.7*70 PAN C SUS 1
● ●
12 BATTERY 2
● ●
13 R EMOTE 1
● ●
14 MODULE COLOR TYPE COLOR WHEEL 1
● ●   
						

							9
DLP Projector - User’s Manual
CONTROLS AND FUNCTIONS
D8800/D8900/D8010W at a Glance
Air outlet
Air outle t
Air outle
t Adjustable 
feet*4
Power inle
t
Rear Infre-red window
(remote control)
Power switchAir inlet
Air inlet
 
y Air outlet
Warm air exits the projector through this vent. Ensure 
that it is not blocked.
 
y Air inlet
Internal fans draw cool air into the projector through 
this vent.
 
y Adjustable feet
Use these when the projector is installed in a table-
top configuration to level the image and/or adjust the 
projection angle.
 
y Power Inlet
For input power from wall outlet to projector.
 
y Rear Infre-red window
For receive the remote controller’s message.   
						

							DLP Projector - User’s Manual
10
I/O Panel
INSDI OUT
LAN HDMI
DVI-D
RGB B/Pb
G/YR /Pr
VH WIRED REMOTE
TRIGGER
RS-232 S-VIEDOV
IEDO
 
y SDI
Connect a BNC cable from a serial digital interface (SDI) device.
 
y HDMI
Connect an HDMI source.
 
y DVI
Connect a DVI source.
 
y Component
Connect a Component (YUV HS/VS-CS) source.
 
y WIRED REMOTE
Wired input from a Niles- or Xantech-compatible, infrared (IR) repeater system.
 
y TRIGGER
(3.5-mm, mini phone jack) Offers 12 (+/- 1.5) V of output for 350mA monitor relay with short circuit protection.
 
y S-VIDEO
A standard S-Video input for connecting a DVD player, satellite receiver or Super VHS (S-VHS) VCR. 
 
y VIDEO
Standard composite video input for connecting a VCR, laser disc player or other composite video source. Also pro-
vides composite sync input for RGBS sources.
 
y LAN
Connect an RJ45 ethernet cable.
 
y RGB
Provides a standard, 15-pin VGA-style connection to either an RGB or component high-definition source, or to a 
personal computer.
The D8800/D8900/D8010W automatically detect the input signal resolution.
 
y RS-232
9-pin D-sub connector for interfacing with a PC or home theater automation/control system.