Trane Intellipak 2 Service Manual
Here you can view all the pages of manual Trane Intellipak 2 Service Manual. The Trane manuals for Air Conditioner are available online for free. You can easily download all the documents as PDF.
Page 1
SAFETY WARNING Only qualified personnel should install and service the equipment. The installation, starting up, and servicing of heating, ventilating, and air-conditioning equipment can be hazardous and requires specific knowledge and training. Improperly installed, adjusted or altered equipment by an unqualified person could result in death or serious injury. When working on the equipment, observe all precautions in the literature and on the tags, stickers, and labels that are attached to the...
Page 2
© 2014 Trane All rights reservedRT-SVX24K-EN Introduction Read this manual thoroughly before operating or servicing this unit. Warnings, Cautions, and Notices Safety advisories appear throughout this manual as required.Your personal safety and the proper operation of this machine depend upon the strict observance of these precautions. Important Environmental Concerns Scientific research has shown that certain man-made chemicals can affect the earth’s naturally occurring stratospheric ozone layer when...
Page 3
Introduction RT-SVX24K-EN3 Maintenance manual and the latest edition of the appropriate programming manual for Constant Volume (CV), Rapid Restart (RR), Variable Air Volume (VAV), or Single Zone Variable Air Volume (SZ VAV) applications before attempting to operate or service this equipment. Note:The procedures discussed in this manual should only be performed by qualified and experienced HVAC technicians. Overview of Manual This booklet describes proper installation, startup,operation, and maintenance...
Page 4
4RT-SVX24K-EN Table of Contents Introduction............................. 2 Warnings, Cautions, and Notices........ 2 Model Number Descriptions.............. 6 Unit Inspection.......................... 9 As soon as the unit arrives at the job site 9 Storage ............................ 9 Unit Clearances ..................... 9 Unit Dimensions and Weight Information 9 General Information.................... 10 Unit Nameplate...................... 10 Commonly Used Acronyms............ 10 Unit...
Page 5
Table of Contents RT-SVX24K-EN5 Unit Rigging and Placement (Two-Piece— addition to General Checklist)......... 95 Unit Rigging and Placement (Three-piece unit) (in addition to Two-piece unit rigging and placement) ..................... 95 Unit Startup............................ 98 Sequence of Operation................ 98 Cooling Sequence of Operation ....... 98 Compressor Sequence of Operation . . . 98 Units with Evaporative Condenser Sequence of Operation .............. 99 Modulating Dehumidification...
Page 6
6RT-SVX24K-EN DIGIT 1 — UNIT TYPE S Self-Contained (Packaged Rooftop) DIGIT 2 — UNIT FUNCTION E DX Cooling, Electric Heat F DX Cooling, Natural Gas Heat L DX Cooling, Hot Water Heat S DX Cooling, Steam Heat X DX Cooling, No Heat,Extended Casing DIGIT3—SYSTEM TYPE H Single Zone DIGIT 4 — DEVELOPMENT SEQUENCE J Ninth DIGIT 5, 6, 7 — NOMINAL CAPACITY 090 90 Ton Air-Cooled 105 105 Ton Air-Cooled 120 120 Ton Air-Cooled 130 130 Ton Air-Cooled 150 150 Ton Air-Cooled 100 100 Ton Evap Condenser 118 118 Ton Evap...
Page 7
RT-SVX24K-EN7 Model Number Descriptions DIGIT 18 — EXHAUST/RETURN FAN MOTOR SELECTION 0 None D 7.5 Hp E10Hp F15Hp G20Hp H25Hp J30Hp K40Hp L50Hp M60Hp DIGIT 19 — EXHAUST/RETURN RPM SELECTION 0 None 3300 4400 5500 6600 7700 8800 9900 A 1000 B1100 C 1200 D 1300 E 1400 DIGIT 20 — SYSTEM CONTROL SELECTION 1 Constant Volume (CV) (Zone Temperature Control) 2 CV w/ Discharge Temp Control 4 VAV w/ VFD Supply w/o Bypass (Discharge Temp Control) 5 VAV w/ VFD Supply w/ Bypass (Discharge Temp Control) 6 VAV – Single...
Page 8
8RT-SVX24K-EN Model Number Descriptions DIGIT 34 — MODULE OPTIONS 0 None A 0-5 volt Generic Building Automation System (GBAS) B 0-10 volt GBAS C 0-5 volt GBAS and 0-10 volt GBAS F LonTalk® Communication Interface (LCI) D Ventilation Override G 0-5 volt GBAS volt & Ventilation Override H 0-10 volt GBAS & Ventilation Override J 0-5 volt GBAS and 0-10 volt GBAS & Ventilation Override L LCI & Ventilation Override M BACnet Communication Interface (BCI) N BCI & Ventilation Override DIGIT 35 — ZONE SENSOR...
Page 9
RT-SVX24K-EN9 Unit Inspection As soon as the unit arrives at the job site [ ] Verify that the nameplate data matches the data on the sales order and bill of lading (including electrical data). [ ] Verify that the power supply complies with the unit nameplate specifications. [ ] Verify that the power supply complies with the electric heater specifications on the unit nameplate. [ ] Visually inspect the exterior of the unit, including the roof, for signs of shipping damage. [ ] Check for material...
Page 10
10RT-SVX24K-EN General Information Unit Nameplate One Mylar unit nameplate is located on the outside upper left corner of the control panel door. It includes the unit model number, serial number, electrical characteristics, weight, refrigerant charge, as well as other pertinent unit data. A small metal nameplate with the Model Number, Serial Number, and Unit Weight is located just above the Mylar nameplate, and a third nameplate is located on the inside of the control panel door. Compressor Nameplate The...