Toshiba Satellite Pro Te2000 Manual

							Information to Wireless LAN User
Wireless Interoperability
The TOSHIBA Wireless LAN Mini PCI Card products are designed to be
interoperable with any Wireless LAN product that is based on Direct Sequence
Spread Spectrum (DSSS) radio technology, and is compliant to:
❑The IEEE 802.11 Standard on Wireless LANs (Revision B), as defined and
approved by the Institute of Electrical and Electronics Engineers.
❑The Wireless Fidelity (WiFi) certification as defined by the WECA Wireless
Ethernet Compatibility Alliance.
Wireless LAN and your Health
Wireless LAN products, like other radio devices, emit radio frequency electromag-
netic energy. The level of energy emitted by Wireless LAN devices however is far
much less than the electromagnetic energy emitted by wireless devices like for
example mobile phones.
Because Wireless LAN products operate within the guidelines found in radio
frequency safety standards and recommendations, TOSHIBA believes Wireless
LAN is safe for use by consumers. These standards and recommendations reflect
the consensus of the scientific community and result from deliberations of panels
and committees of scientists who continually review and interpret the extensive
research literature.
In some situations or environments, the use of Wireless LAN may be restricted by
the proprietor of the building or responsible representatives of the organization.
These situations may for example include:
❑Using the Wireless LAN equipment on board of airplanes, or
❑In any other environment where the risk of interference to other devices or
services is perceived or identified as harmful.
If you are uncertain of the policy that applies on the use of wireless devices in a
specific organization or environment (e.g. airports), you are encouraged to ask for
authorization to use the Wireless LAN device prior to turning on the equipment.
Regulatory Information
The TOSHIBA Wireless LAN Mini PCI Card must be installed and used in strict
accordance with the manufacturer’s instructions as described in the user documenta-
tion that comes with the product. This device complies with the following radio
frequency and safety standards. 
						

							Canada – Industry Canada (IC)
This device complies with RSS 210 of Industry Canada.
Operation is subject to the following two conditions: (1) this device may not cause
interference, and (2) this device must accept any interference, including interference
that may cause undesired operation of this device.”
L’utilisation de ce dispositif est autorisée seulement aux conditions suivantes : (1) il
ne doit pas produire de brouillage et (2) l’utilisateur du dispositif doit étre prét  à
accepter tout brouillage radioélectrique reçu, même si ce brouillage est susceptible
de compromettre le fonctionnement du dispositif.
Europe – EU Declaration of Conformity
This device complies with the essential requirements of the R&TTE Directive
1999/5/EC with essential test suites as per standards:
❑EN 60950 Safety of Information Technology equipment
❑ETS 300 328 Technical requirements for radio equipment
❑ETS 300 826 General EMC requirements for radio equipment.
België/ For outdoor usage only channel 10 (2457 MHz) and 11 (2462
Belgique: MHz) is allowed.
For private usage outside buildings across public grounds over
less than 300m no special registration with IBPT/BIPT is
required. Registration to IBPT/BIPT is required for private usage
outside buildings across public grounds over more than 300m.
An IBPT/BIPT license is required for public usage outside
building.
For registration and license please contact IBPT/BIPT.
Gebruik buiten gebouw alleen op kanalen 10 (2457 MHz) en 11
(2462 MHz). Voor privé-gebruik buiten gebouw over publieke
groud over afstand kleiner dan 300m geen registratie bij BIPT/
IBPT nodig; voor gebruik over afstand groter dan 300m is wel
registratie bij BIPT/IBPT nodig. Voor publiek gebruik buiten
gebouwen is licentie van BIPT/IBPT verplicht. Voor registratie of
licentie kunt u contact opnemen met BIPT. 
						

							L’utilisation en extérieur est autorisé sur le canal 10 (2457 MHz)
et 11 (2462 MHz).
Dans le cas d’une utilisation privée, à l’extérieur d’un bâtiment,
au-dessus d’un espace public, aucun enregistrement n’est
nécessaire pour une distance de moins de 300m. Pour une
distance supérieure à 300m un enregistrement auprès de I’IBPT
est requise. Pour une utilisation publique à I’extérieur de
bâtiments, une licence de I’IBPT est requise. Pour les
enregistrements et licences, veuillez contacter I’IBPT.
Deutschland: License required for outdoor installations. Check with reseller
for procedure to follow
Anmeldung im Outdoor-Bereich notwendig, aber nicht
genehmigungspflichtig. Bitte mit Händler die Vorgehensweise
abstimmen.
France: Restricted frequency band: only channels 10 and 11 (2457 MHz
and 2462 MHz respectively) may be used in France. License
required for every installation, indoor and outdoor installations.
Please contact ART for procedure to follow.
Bande de fréquence restreinte : seuls les canaux 10 à 11 (2457
et 2462 MHz respectivement) doivent être utilisés en France.
Toute utilisation, qu’elle soit intérieure ou extérieure, est
soumise à autorisation. Vous pouvez contacter I’Autorité de
Régulation des Télécommuniations (
http://www.art-telecom.fr)
pour la procédure à suivre.
Italia: License required for indoor use. Use with outdoor installations
not allowed
E’necessaria la concessione ministeriale anche per l’uso
interno.
Verificare con i rivenditori la procedura da seguire. L’uso per
installazione in esterni non e’ permessa.
Nederland License required for outdoor installations. Check with reseller
for procedure to follow
Licentie verplicht voor gebruik met buitenantennes. Neem
contact op met verkoper voor juiste procedure 
						

							USA-Federal Communications Commission(FCC)
This device complies with Part 15 of FCC Rules. Operation of the devices in a
Wireless LAN System is subject to the following two conditions:
❑ This device may not cause harmful interference.
❑ This device must accept any interference that may cause undesired operation.
Caution: Exposure to Radio Frequency Radiation.
The radiated output power of the TOSHIBA Wireless LAN Mini PCI Card is far
below the FCC radio frequency exposure limits. Nevertheless, the TOSHIBA
Wireless LAN Mini PCI Card shall be used in such a manner that the potential for
human contact during normal operation is minimized. When using this device in
combination with Wireless LAN Outdoor Antenna products, a certain separation
distance between antenna and nearby persons has to be kept to ensure RF exposure
compliance. The distance between the antennas and the user should not be less than
5.0cm.
Refer to the Regulatory Statements as identified in the documentation that comes
with those products for additional information.
The TOSHIBA Wireless LAN Mini PCI Card is far below the FCC radio frequency
exposure limits.
Nevertheless, it is advised to use the TOSHIBA Wireless LAN Mini PCI Card in
such a manner that human contact during normal operation is minimized.
Interference Statement
This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a residential
installation.
This equipment generates, uses, and can radiate radio frequency energy. If not
installed and used in accordance with the instructions, it may cause harmful
interference to radio communications. However, there is no guarantee that interfer-
ence will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and on, the user is encour-
aged to try and correct the interference by one or more of the following measures:
❑Reorient or relocate the receiving antenna.
❑Increase the distance between the equipment and the receiver. 
						

							❑ Connect the equipment to an outlet on a circuit different from that to which the
receiver is connected.
❑ Consult the dealer or an experienced radio/TV technician for help.
TOSHIBA is not responsible for any radio or television interference caused by
unauthorized modification of the devices included with this TOSHIBA Wireless
LAN Mini PCI Card, or the substitution or attachment of connecting cables and
equipment other than specified by TOSHIBA .
The correction of interference caused by such unauthorized modification, substitu-
tion or attachment will be the responsibility of the user.
Taiwan
Article 14Unless approved, for any model accredited low power radio
frequency electric machinery, any company, trader or user shall
not change the frequency, increase the power or change the
features and functions of the original design.
Article 17 Any use of low power radio frequency electric machinery shall
not affect the aviation safety and interfere with legal
communications. In event that any interference is found, the use
of such electric machinery shall be stopped immediately, and
reusing of such products can be resumed until no interference
occurs after improvement.
The legal communications mentioned in the above item refer to
radio communications operated in accordance with
telecommunication laws and regulations.
Low power radio frequency electric machinery shall resist
against interference from legal communications or from
industrial, scientific and medical radio emission electric
machinery.
Using this equipment in Japan
In Japan, the frequency bandwidth of 2,400~2,483.5MHz for second generation
low-power data communication systems such as this equipment overlaps that of
mobile object identification systems (premises radio station and specified low-
power radio station). 
						

							1. Sticker
Please put the following sticker on devices incorporating this product.
In the frequency bandwidth of this equipment, industrial device,
scientific device, medical device like microwave oven, licensed
premises radio station and non-licensed specified low-power
radio station for mobile object identification system (RF-ID) that
is used in product line of factories, (Other Radio Stations)are
used.
1 Please make sure before using this equipment that no Other
Radio Stations are used in the neighborhood.
2 In case that RF interference occurs to Other Radio Stations
from this equipment, please change promptly the frequency for
use, place to use, or stop emitting Radio.
3 Please contact TOSHIBA Direct PC if you have a problem,
such as interference from this equipment to Other Radio
Stations.
2.  Indication
The indication shown below appears on this equipment.
     (1)     (2)     (3)
    2.4     DS      4
  
              (4)
(1) 2.4 : This equipment uses a frequency of 2.4GHz.
(2) DS : This equipment uses DS-SS modulation.
(3) 4 : The interference range of this equipment is less than 40m.
(4)  
  : This equipment uses a frequency bandwidth from 2,
400MHz to 2,483.5MHz.
It is possible to avoid the band of mobile object identifica-
tion systems. 
						

							3. TOSHIBA Direct PC
Monday — Friday :  10:00 — 17:00
Toll Free Tel  :  0120-13-1100
Direct Dial :  03-3457-5916
FAX :  03-5444-9450
Electronic communication device authorization
This device obtains the Technical Conditions Compliance Approval, and it belongs
to the device class of  radio equipment of low-power data communication system
radio station stipulated in the Telecommunications Business Law.
The following restrictions apply:
❑Do not disassemble or modify the device.
❑Do not remove the authorization label from the device.
Device Authorization
 This device obtains the Technical Regulation Conformity Certification, and it
belongs to the device class of radio equipment of low-power data communication
system radio station stipulated in the Radio Law of Japan.
The following restrictions apply:
❑Do not disassemble of modify the device.
❑Do not remove the authorization label from the device.
Regulatory statements
General
This product complies with any mandatory product specification in any country/
region where the product is sold. In addition, the product complies with the
following.
European Union (EU) and EFTA
This equipment complies with the R&TTE directive 1999/5/EC and has been
provided with the CE mark accordingly. 
						

							United States of America and Canada
Tested To Comply With FCC Standards FOR HOME OR OFFICE USE. See FCC
47CFR part 15.19(b)(2)
This device complies with part15 of the FCC rules and with RSS-210 / RSS-139 of
the Industry Canada. Operation is subject to the following two conditions: (1) This
device may not cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause undesired operation.
Note that any changes or modifications to this equipment not expressly approved by
the manufacturer may void the FCC authorization to operate this equipment.
Canada
IC Notice
To prevent radio interference to the licensed service, this device is intended to be
operated indoors and away from windows to provide maximum shielding. Equip-
ment that is installed outdoors is subject to licensing.
Pour empêcher un brouillage radioélectrique au service faisant l’objet d’une
licence, cet appareil doit être utilisé à l’interieur et loin des fenêtres afin de founir
un écran de blindage maximal. Au cas aù un installation en plain air, le materiel doit
faire l’objet d’une licence.
Caution
FCC Interference Statement
 Tested to comply with FCC Standards FOR HOME OR OFFICE USE. See FCC
47CFR part 15.19(b)(2). This device complies with part15 of the FCC rules and
with RSS-210 / RSS-139 of the Industry Canada. Operation is subject to the
following to conditions:
❑This device may not cause harmful interference, and
❑This device must accept any interference received, including interference that
may cause undesired operation.
This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a residential
installation. 
						

							This equipment generates, uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful interfer-
ence to radio communications. However, there is no guarantee that interference will
not occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and on, the user is encour-
aged to try and correct the interference by one or more of the following measures:
❑ Reorient or relocate the receiving antenna.
❑Increase the separation between the equipment and the receiver.
❑Connect the equipment into an outlet on a circuit different from that to which
the receiver is connected.
❑Consult the dealer or an experienced radio/TV technician for help.
Note that any changes or modifications to this equipment not expressly approved by
the manufacturer may void the authorization to operate this equipment. 
						

							TOSHIBA DVD-ROM drive SD-C2502**
safety instruction
** means any letters or numbers.
CAUTIONS:1. The DVD-ROM drive employs a laser system. To ensure
proper use of this product, please read this instruction
manual carefully and retain for future reference. Should
the unit ever require maintenance, contact an authorized
service location.
2. Use of controls, adjustments or the performance of
procedures other than those specified may result in
hazardous radiation exposure.
3. To prevent direct exposure to the laser beam, do not try
to open the enclosure.
    Location of the required label
PRODUCT IS CERTIFIED BY THE
MANUFACTURER TO COMPLY
WITH DHHS RULES 21 CFR
SUBCHAPTER  J APPLICABLE AT
THE DATE OF MANUFACTURE.
   MANUFACTURED:
TOSHIBA CORPORATION
1-1, SHIBAURA 1-CHOME
MINATO-KU, TOKYO 105-8001,
JAPAN