Home > Toshiba > Communications System > Toshiba Perception Electronic Business Communications System Installation And Maintenance Manual

Toshiba Perception Electronic Business Communications System Installation And Maintenance Manual

Add to Favourites

Download as PDF

Here you can view all the pages of manual Toshiba Perception Electronic Business Communications System Installation And Maintenance Manual. The Toshiba manuals for Communications System are available online for free. You can easily download all the documents as PDF.

Overview View all the pages Comments

Page 181

$Page 181 member number will be selected first. Enter: Group and Member Number (GGMM) NOTE: 1. GMN cannot be altered by CHG pro- cedure. The GMN prompt will be fol- lowed by the existing GAIN. 2. To change the GMN, the Data Block must be deleted (OUT) and a new Data Block (NEW) entered. TDN (Trunk Directory Number)-For Private -- Lines Only (Trunk Group PVL); defines a phantom directory number that will be used to assign private lines to a station. Enter: 3-digit number [\IIT (Night Number)-Assigns...$

member number will be selected first. 
Enter: Group and Member Number 
(GGMM) 
NOTE: 
1. GMN cannot be altered by CHG pro- 
cedure. The GMN prompt will be fol- 
lowed by the existing GAIN. 
2. To change the GMN, the Data Block 
must be deleted (OUT) and a new 
Data Block (NEW) entered. 
TDN (Trunk Directory Number)-For Private 
-- 
Lines Only (Trunk Group PVL); defines a 
phantom directory number that will be used 
to assign private lines to a station. 
Enter: 3-digit number 
[\IIT (Night Number)-Assigns...

Page 182

cannot be used at the same time. One must be 
“open”. 
04.16 The pin assignments of the TTY and 
MODEM connectors are: 
TTY : 
Pin No. Designation 
2 RXD Received Data (from TTY) 
3 TXD Transmit Data ito TTY) ’ 
5 CTS Clear to Send* 
6 DSR Data Set Ready* 
7 SG Signal Ground 
8 CD Carrier Detect* 
20 
DTR Data Terminal Ready (from TTY) 
“Connect to f 12 VDC internally 
Pin No. 
2 
3 
4 
5 
6 
7 Designation 
TXD Transmit Data (to modem) 
RXD Receive Data (from modem) 
RTS Request to Send (to modem) 
CTS...

Page 183

then enter the mnemonic of the required Utility 
Program after the system responds with “OK”. 
.32 After the Utility Program name is entered, 
the program is loaded from the diskette. When the 
loading is complete, the system will prompt 
“R EQ”. 
.33 Inputting data via a Utility Program is 
a matter of responding to the prompts given by 
the system via the data terminal. The prompts 
and the required responses are mnemonics that 
are usually abbreviations of the actual English 
word required. 
If an...

Page 184