Siemens Saturn Iie Epabx Installation Test Procedures Manual

SATURN IIE EPABXA30808-X5130-B120-l-8928Installation Test ProceduresIssue 1, May 1986
5.01General. The SATURN IIE EPABX is a Stored-Program-Controlled (SPC) system. The system is shipped with two iden-
tical floppy disks that contain the basic operating and the
installation-dependent data. The operating program uses the
installation-dependent data, commonly referred to as the sys-
tem data base, to complete and process calls as required by
the customer. This information includes such items as the
number...

SATURN IIE EPABXA3080&X5130-B120-l-8928
Installation Test ProceduresIssue 1, May 1986WARNING
Hazardous voltages exist within the equipment cabinet. Be 
e&e&y careful when
performing testir;g/~roobleshooting procedur-LJ with the equ&ment panel(s) removed.
Table 5.00 Loading Procedures for Operaling Disk
;TEP
PROCEDUREVERIFICATION!F VERIFICATIONIS NOT OBTA!NED
1On the PSU, shown in Figure 5.01,place the FAtLURE TRANSFERswitch in the AUTO position,
2Insert a floppy disk into slot opening
of each FDD until...

SATURN IIE EPABXA30808-X5130-0120-1-8928Installation Test Procedureslssuc 1, May 1936
Table 5.00 Loading Procedures for Operating Disk 
(Continued)
STEPPROCEDUREVERlFlCATlONIF VERIFlCAT!ONIS NOT OBTAINED’
5If the operating disks that were load-
ed did not contain a Siemens-.
prepared data base, refer to SATURN
EPABX Data Base Preparation prac-
tice to define the particular system
data base, and the SATURN EPABX
Customer Memory Update Proce-
dures practice to input the 
installation-dependent data to the...

I’
A30808-X5130-(3120-l-8928Issue 1, May 1986
Table 5.02LED Display Values for Loading Errors
HEX
CCDEERRCR DETECTED
012
3
4
5
6
:DEF8
9
A
I3Start of self test not halted
Main processor error
EPROM checksum 
errorMEM slot 0 low 64k test error
8k by 8 static RAM test error
IRAM memory test errorORAM memory test error
SIB side error
Global memory 
errorWatchdog iimer error
SIB serial 
loopback test error
SIB counter timing test error
Start boot process (self test done)
Disk 
coniroller error
Drive not...

I--SATURN 
IIE EPABX
Installation Test ProceduresA30808-X5130-6120-1-8928Issue 1, May 1986
LATCHOPEN\
LATCH
CLoSED \
/
/
?
25
0WRITE
PROTECT
NOTCH
FLOPPY
/ DiSi’cFigure 5.02Floppy Dish Loading 
Proceduics 

I-SATURN 
IIE EPABX
Installation Test ProceduresA30800-X5130-6120-l-8928Issue 1, May 1986
LED
LED
(Red)
ST3
LED
ACTWrLED
Connector
ServiceTerminal
‘witch
Figure 5.03 CIOP Printed Circuit Coard5-6 (6 pages) 

SATURN IIE EPABXA30808-X5130-BlZO-l-8920Installation Test ProceduresIssue 1. May 1986
6.01General. After satisfactorily loading the cperating disk
and inputting CMU data to system memory via a service ter-
minal, the operational capability of the system must be veri-
fied after the necessary MDF cross-connections are
performed. The SATURN 
IIE System software contains a
group of system and apparatus (ancillary equipment) diag-
nostic test routines which are accessed via the maintenance
phone. Resulting...

I.-SATURN 
IIE EPABXA30808-X5130-B120-l-B928lnstallatlon Test ProceduresIssue 1, May 1986
,-SysleinMDF Cable J13
Cross-connect .to SLMA circuit designated
for the maintenance telephone.
1PXFER (No&h Ooen1J, I
PXFER (Normally Closed)Cross-connect to failure transfer
relay(s) subsystem (customer-provided).
\$$! > :tG TIP (Major-NC)
>RING (Major Common)014D > FUBL TIP (Major-NO)Dry contact closures
for remoie miner andmajor alarm indica-tions (customer-
provided).
Syslem Maiafcnancc Connecting BlsckFigure...

SATURN IIE EPABXA30808-X5130-B120-1-6928Installation Test ProceduresIssue 1, May 1986
II
SlNGLE LINE ’ HOUSE /TELEPHONE! CABLING IIEQUIPMENT ROOMI
Inlerfacing Connecting Block
System 
T&R Connecting Block
Sys:em MDF Cable J32, J34. J36. C38. JSO, J42or J44 from the EZISIC shelf or J26, J28, J30,
J32. J34. J36. J38, or J40 from tile LTU shelf----------
f-+(-Jo--- -________[
---III
INote: Dashed lilies represent installation-dependent cross-connections.
Figure 6.02
Sing!e Line Telephone Cross-Connections...

SATURN IIE EPABX
Installation Test ProceduresA30808-X5130-B120-l-8928Issue 1, May 1986
II
I
SIEMENS DIGITAL : HOUSE ’EQUlPMENT FiOOMTELEPHONEICABLING! .
I
II
II1Interfacing Connecting BlockI\ .
DYAD or Jr-DYADFigure 6.04Siemens Digital 
Te!cphone Cross-Connections Using SLMD PC9System T&R Connecting Block1
System MDF Cable J32, J34, J36. J38, J40. J42 :or J44 from the Basic shelf or J26, J28, J30, j
J32, J34, J36, J38, or J40 from the LTU shelf
Note: Dashed lines represent installation-dependent...