Sharp Ux300 Plain Paper Fax Machine Operation Manual

The printing paper comes
out blank when you try to
receive a document.·
·· ·Make sure that the document is loaded properly
in the feeder of the transmitting machine. Make
a copy to confirm the printing ability of your
machine.
General print quality is poor.
·
·· ·It is important to select a paper that is
appropriate for the thermal transfer printer in
your fax. We recommend using laser quality
paper that has a very smooth finish. Copier
paper will work, but it sometimes tends to yield a
lighter print...

General problems
Problem Check and remedy
Information cannot be
programmed in the fax.
·
·· ·Make sure the fax is plugged in and the imaging
film and paper have been loaded. (Programming
is not possible if the imaging film and printing
paper have not been loaded.) See 
Loading the
Imaging Film
 and Loading Printing Paper in
Chapter 1.
Nothing appears in the
display.
·
·· ·Make sure the power cord is properly plugged
into a power outlet.
·
·· ·Connect another electrical appliance to the
outlet to see if...

UX178U-TSDMRT
Messages and Signals
Display messages
Note:If you have turned on the Caller ID function, see Caller ID in
Chapter 7 for display messages related to Caller ID.
CHECK PAPER SIZEThe paper size setting is incorrect. Change the paper
size setting as described in Loading the Paper in
Chapter 1.
COVER OPENThe print compartment cover (under the operation
panel) is open. Open the operation panel (grasp the
top and pull toward you), and then press down firmly
on both sides of the print compartment...

MEMORY IS FULLThe memory is full. This may occur during fax
reception if too much data is received before the
pages can be printed out. If faxes have been
received to memory because printing is not possible
(an additional message will indicate the problem),
resolve the problem so that printing can continue
(see 
Substitue Reception to Memory in Chapter 3). If
you are attempting to transmit from memory, see
Sending Documents from Memory in Chapter 7.
MEMORY PRINTINGThe fax is preparing to or printing out...

SEARCH DIALThe 
HOLD/SEARCH  key has been pressed. Press
# or * to search for an automatic dialing number, or
press 
STOP to return to the data and time display.
(See 
Using the 
HOLD/SEARCH  key in Sending a
Fax by Automatic Dialing
 in Chapter 2.)
TOTAL PAGE(S) 01 Number of pages transmitted, received, or copied.
Audible signals
Continuous tone 3 secondsIndicates the end of
transmission, reception, or
copying.
Intermittent tone
(3 beeps)5 seconds
(1 second on, 
1 second off)Indicates incomplete...

UX300U-TSCPRT
Clearing Paper Jams
Clearing a jammed document
If the original document doesn’t feed properly during transmission or
copying, or DOCUMENT JAMMED appears in the display, first try
pressing the START/MEMORY key. If the document doesn’t feed
out, open the operation panel and remove it.
Important:
Do not try to remove a document without opening the operation
panel. This may damage the feeder mechanism.
1Open the operation panel by grasping
the finger hold and pulling up.
2Remove the document....

Clearing jammed printing paper
1Pull the paper release plate forward
and remove the paper.
2Open the operation panel (grasp the
finger hold and pull up), and then pull
the release on the right side of the
machine forward to open the print
compartment cover.
3Gently pull the jammed paper out of
the machine, making sure no torn
pieces of paper remain in the print
compartment or rollers.
11.Trouble-
shooting
Clearing Paper Jams
115 

4Close the print compartment cover
(press down on both sides to make sure
it clicks into place), and then close the
operation panel.
5Reinsert the paper in the paper tray and
push the paper release plate back down.
Clearing Paper Jams
116 

UX300U-Parts
Ordering parts  
To order parts, contact the parts distribution center located nearest you. When
ordering a part, use the part order number shown below.  
Operation manual    TINSE3912XHZA 
Rapid Key labels    TLABH4751XHZZ 
Handset cord   QCNW-3976XHOW 
Telephone line cord    QCNW-3975XHGY 
Handset   DUNTK464BXHWH 
Paper tray extension  LPLTP3003XHSA 
Original document support  PHOP-2102XHZZ 
Imaging film cartridge  CPLTP3002XHB1 
Gears  NGERH2455XHZZ (large gear)
NGERH2456XHZZ 
Part...

UX178U-fcc
FCC Regulatory Information
This equipment complies with FCC rules, Part 68. On this equipment is a label that con-
tains, among other information, the FCC Registration Number and Ringer Equivalence
Number (REN) for this equipment. If requested, this information must be provided to
your telephone company.   
An FCC compliant telephone cord and modular plug is provided with this equipment.
This equipment is designed to be connected to the telephone network or premises wiring
using a compatible...