Sharp Mx2310u User Guide

4-77
FACSIMILE
Contents
4
Select the erase settings.
(1) Touch the desired erase mode.
Select one of the 4 erase modes.
Touch the [Side Erase] key to open the following screen.
Touch the checkbox of the edge that you wish to erase 
and make sure that a checkmark ( ) appears.
When performing two-sided scanning, set the erase edge 
on the reverse side.
 If you touch the [Same Side as Side 1] key, the edge in 
the same position as on the front side will be erased.
 If you touch the [Different Side from...

4-78
FACSIMILE
Contents
TRANSMITTING AN ORIGINAL AS TWO 
SEPARATE PAGES (Dual Page Scan)
The left and right sides of an original can be transmitted as two separate pages. This function is useful when you wish to 
fax the left and right pages of a book or other bound document as separate pages.
Example: Faxing the left and right pages of a book
Example:
Book or bound document
The left and right pages are sent as two pages.
Original scan sizeTransmitted image
A3 (11 x 17) x 1 pageA4 (8-1/2 x 11) x 2 pages...

4-79
FACSIMILE
Contents
3
Select Dual Page Scan.
(1) Touch the [Special Modes] key.
☞SPECIAL MODES (page 4-72)
(2) Touch the [Dual Page Scan] key so that it is 
highlighted.
(3) Touch the [OK] key.
4
Press the [BLACK & WHITE START] key.
Scanning begins.
When scanning finishes, place the next original and press the [BLACK & WHITE START] key. Repeat until all pages have 
been scanned and then touch the [Read-End] key.
A beep will sound to indicate that scanning is finished.
To cancel scanning...
Press the...

4-80
FACSIMILE
Contents
SENDING A FAX AT A SPECIFIED TIME 
(Timer)
When this function is used, transmission takes place automatically at a specified time.
The timer transmission function makes it easy to perform reserved transmissions, broadcast transmissions and other 
transmissions at night or other times when phone rates are low.
A timer setting can also be specified for polling reception to receive a fax when you are not present.
 When a timer transmission is set, keep the main power switch on....

4-81
FACSIMILE
Contents
4
Set the time with the   keys.
(1) Specify the day.
If you do not wish to specify a day, select [---]. In this 
case, transmission will begin when the time specified in 
(2) arrives.
(2) Specify the time (hour, minute)
Select the time in 24-hour format.
You can also directly touch a numeric display key to 
change the setting with the numeric keys.
(3) Touch the [OK] key.
When this screen is opened, the setting will show the current time. If the time is not correct, press the...

4-82
FACSIMILE
Contents
SENDING TWO PAGES AS A SINGLE PAGE 
(2in1)
Two original pages can be reduced and sent as a single page. This function is convenient when you have a large 
number of original pages and wish to reduce the number of pages sent.
1
Place the original.
When placing the originals, orient them as shown below.
2
Enter the destination fax number.
☞
ENTERING DESTINATIONS (page 4-17)
12
12
12
1
2
Portrait-oriented originals
Landscape-oriented originalsTransmission
Transmission
12
12
11
11...

4-83
FACSIMILE
Contents
3
Select 2in1.
(1) Touch the [Special Modes] key.
☞SPECIAL MODES (page 4-72)
(2) Touch the [2in1] key so that it is 
highlighted.
(3) Touch the [OK] key.
4
Touch the [Original] key.
5
Specify the orientation in which the 
original is placed.
(1) Touch the appropriate [Image Orientation] 
key.
If this setting is not correct, a suitable image may not be 
transmitted.
(2) Touch the [OK] key.
6
Press the [BLACK & WHITE START] key.
Scanning begins.
 If you inserted the original pages...

4-84
FACSIMILE
Contents
 Transmission is not possible at a size smaller than the original size.
 This function cannot be used in direct transmission mode or when the speaker is used to dial.
 The 2in1 function cannot be used when the original is other than A4, B5 or A5 (8-1/2 x 11 or 5-1/2 x 8-1/2) size.
 When the scan size of the original is specified by numerical values, this function cannot be used.
To cancel 2in1...
Touch the [2in1] key in the screen of step 3 so that it is not highlighted. 

4-85
FACSIMILE
Contents
SENDING BOTH SIDES OF A CARD AS A 
SINGLE PAGE (Card Shot)
This function lets you send the front and reverse sides of a card as a single page, without the need to send each side 
separately.
When using card shot, the original must be scanned on the document glass.
1
Place the original face down on the 
document glass.
2
Enter the destination fax number.
☞
ENTERING DESTINATIONS (page 4-17)
3
Select the special modes.
(1) Touch the [Special Modes] key.
(2) Touch the [Card Shot]...

4-86
FACSIMILE
Contents
4
Specify the original size.
(1) Enter the original size.
 Touch the X (width) numeric value display key and 
enter the width.
 Touch the Y (height) numeric value display key and 
enter the height.
(A) To return the original size to the default size, touch 
the [Size Reset] key.
(B) To automatically enlarge or reduce the image size to 
the send size, touch the [Fit to Send Size] key. Do not 
touch this key if you wish to scan the original at the 
original size that you entered....